Consistently use the LLE_ prefix for lla_lookup() and the ND6_ prefix
for nd6_lookup() even though both are defined the same. Use the right
flag variable when checking each.
No real functional change.
MFC after: 4 days
legacy and IPv6 route destination address.
Previously in case of IPv6, there was a memory overwrite due to not enough
space for the IPv6 address.
PR: kern/122565
MFC After: 2 weeks
un-expiring.
The previous version of code have no locking when testing rt_refcnt.
The result of the lack of locking may result in a condition where
a routing entry have a reference count but at the same time have
RTPRF_OURS bit set and an expiration timer. These would eventually
lead to a panic:
panic: rtqkill route really not free
When the system have ICMP redirects accepted from local gateway
in a moderate frequency, for instance.
Commit this workaround for now until we have some better solution.
PR: kern/149804
Reviewed by: bz
Tested by: Zhao Xin, Pete French
MFC after: 2 weeks
In protosw we define pr_protocol as short, while on the wire
it is an uint8_t. That way we can have "internal" protocols
like DIVERT, SEND or gaps for modules (PROTO_SPACER).
Switch ipproto_{un,}register to accept a short protocol number(*)
and do an upfront check for valid boundries. With this we
also consistently report EPROTONOSUPPORT for out of bounds
protocols, as we did for proto == 0. This allows a caller
to not error for this case, which is especially important
if we want to automatically call these from domain handling.
(*) the functions have been without any in-tree consumer
since the initial introducation, so this is considered save.
Implement ip6proto_{un,}register() similarly to their legacy IP
counter parts to allow modules to hook up dynamically.
Reviewed by: philip, will
MFC after: 1 week
Fix the switching on/off of PF and NR-SACKs using sysctl.
Add minor improvement in handling malloc failures.
Improve the address checks when sending.
MFC after: 4 weeks
Add kernel side support for Secure Neighbor Discovery (SeND), RFC 3971.
The implementation consists of a kernel module that gets packets from
the nd6 code, sends them to user space on a dedicated socket and reinjects
them back for further processing.
Hooks are used from nd6 code paths to divert relevant packets to the
send implementation for processing in user space. The hooks are only
triggered if the send module is loaded. In case no user space
application is connected to the send socket, processing continues
normaly as if the module would not be loaded. Unloading the module
is not possible at this time due to missing nd6 locking.
The native SeND socket is similar to a raw IPv6 socket but with its own,
internal pseudo-protocol.
Approved by: bz (mentor)
and go to the next iteration early if multicast filtering would decide that
this socket shall not receive the data.
Unlock the pcb in that case or we leak the read lock and next time trying
to get a write lock, would hang forever.
PR: kern/149608
Submitted by: Chris Luke (chrisy flirble.org)
MFC after: 3 days
bridge(4), lagg(4) etc. and make use of function pointers and
pf_proto_register() to hook carp into the network stack.
Currently, because of the uncertainty about whether the unload path is free
of race condition panics, unloads are disallowed by default. Compiling with
CARPMOD_CAN_UNLOAD in CFLAGS removes this anti foot shooting measure.
This commit requires IP6PROTOSPACER, introduced in r211115.
Reviewed by: bz, simon
Approved by: ken (mentor)
MFC after: 2 weeks
Add proto spacers to inet6sw like we have for legacy IP. This allows us
to dynamically pf_proto_register() for INET6 from modules, needed by
upcoming CARP changes and SeND.
MC and SCTP could make use of it as well in theory in the future after
upcoming VIMAGE vnet teardown work.
Discussed with: will, anchie
MFC after: 10 days
nd6_llinfo_timer() functions with a KASSERT().
Note: there is no need to return after panic.
In the legacy IP case, only assign the arg after the check,
in the IPv6 case, remove the extra checks for the table and
interface as they have to be there unless we freed and forgot
to cancel the timer. It doesn't matter anyway as we would
panic on the NULL pointer deref immediately and the bug is
elsewhere.
This unifies the code of both address families to some extend.
Reviewed by: rwatson
MFC after: 6 days
working anymore. In addition more checks and operations were missing.
In case lla_lookup results in a match, get the ifaddr to update the
statistics counters, and check that the address is neither tentative,
duplicate or otherwise invalid before accepting the packet. If ok,
record the address information in the mbuf. [ as is done in case
lla_lookup does not return a result and we go through the FIB ].
Reported by: remko
Tested by: remko
MFC after: 2 weeks
We do not respect rules 3 and 4 in the required list:
1. omit leading zeros
2. "::" used to their maximum extent whenever possible
3. "::" used where shortens address the most
4. "::" used in the former part in case of a tie breaker
5. do not shorten one 16 bit 0 field
6. use lower case
http://tools.ietf.org/html/draft-ietf-6man-text-addr-representation-04.html
Submitted by: Kalluru Abhiram @ Juniper Networks
Obtained from: Juniper Networks
Reviewed by: hrs, dougb
"Whitspace" churn after the VIMAGE/VNET whirls.
Remove the need for some "init" functions within the network
stack, like pim6_init(), icmp_init() or significantly shorten
others like ip6_init() and nd6_init(), using static initialization
again where possible and formerly missed.
Move (most) variables back to the place they used to be before the
container structs and VIMAGE_GLOABLS (before r185088) and try to
reduce the diff to stable/7 and earlier as good as possible,
to help out-of-tree consumers to update from 6.x or 7.x to 8 or 9.
This also removes some header file pollution for putatively
static global variables.
Revert VIMAGE specific changes in ipfilter::ip_auth.c, that are
no longer needed.
Reviewed by: jhb
Discussed with: rwatson
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 6 days
that we allow all possible jail IPs as source address rather than
forcing the "primary". While IPv6 naturally has source address
selection, for legacy IP we do not go through the pain in case
IP_HDRINCL was not set. People should bind(2) for that.
This will, for example, allow ping(|6) -S to work correctly for
non-primary addresses.
Reported by: (ten 211.ru)
Tested by: (ten 211.ru)
MFC after: 4 days
addresses while walking the IPv6 address list if in the jail case
something is connecting to ::1.
Reported by: Pieter de Boer (pieter thedarkside.nl)
Tested by: Pieter de Boer (pieter thedarkside.nl)
MFC after: 4 days
prevented the link-layer entry from being freed.
In both in.c and in6.c (though that code path seems to be basically dead)
plug a reference leak in case of a pending callout being drained.
In if_ether.c consistently add a reference before resetting the callout
and in case we canceled a pending one remove the reference for that.
In the final case in arptimer, before freeing the expired entry, remove
the reference again and explicitly call callout_stop() to clear the active
flag.
In nd6.c:nd6_free() we are only ever called from the callout function and
thus need to remove the reference there as well before calling into
llentry_free().
In if_llatbl.c when freeing entire tables make sure that in case we cancel
a pending callout to remove the reference as well.
Reviewed by: qingli (earlier version)
MFC after: 10 days
Problem observed, patch tested by: simon on ipv6gw.f.o,
Christian Kratzer (ck cksoft.de),
Evgenii Davidov (dado korolev-net.ru)
PR: kern/144564
Configurations still affected: with options FLOWTABLE
being embedded is in fact link-local, before attempting to embed it.
Note that this operation is a side-effect of trying to avoid recursion on
the IN6 scope lock.
PR: 144560
Submitted by: Petr Lampa
MFC after: 3 days
* Fix handling of mapping arrays when draining mbufs or processing
FORWARD-TSN chunks.
* Cleanup code (no duplicate code anymore for SACKs and NR-SACKs).
Part of this code was developed together with rrs.
MFC after: 2 weeks.
have the delayed function take an argument as to the offset
to the SCTP header. This allows it to work for V4 and V6.
This of course means changing all callers of the function
to either pass the header len, if they have it, or create
it (ip_hl << 2 or sizeof(ip6_hdr)).
PR: 144529
MFC after: 2 weeks
no delayed checksum was added to the ip6 output code. This
causes cards that do not support SCTP checksum offload to
have SCTP packets that are IPv6 NOT have the sctp checksum
performed. Thus you could not communicate with a peer. This
adds the missing bits to make the checksum happen for these cards.
PR: 144529
MFC after: 2 weeks
whether to use source address selection (default) or the primary
jail address for unbound outgoing connections.
This is intended to be used by people upgrading from single-IP
jails to multi-IP jails but not having to change firewall rules,
application ACLs, ... but to force their connections (unless
otherwise changed) to the primry jail IP they had been used for
years, as well as for people prefering to implement similar policies.
Note that for IPv6, if configured incorrectly, this might lead to
scope violations, which single-IPv6 jails could as well, as by the
design of jails. [1]
Reviewed by: jamie, hrs (ipv6 part)
Pointed out by: hrs [1]
MFC After: 2 weeks
Asked for by: Jase Thew (bazerka beardz.net)
for the interface address. This marker is necessary to properly support
PPP types of links where multiple links can have the same local end
IP address. The IFA_RTSELF flag bit maps to the RTF_HOST value, which
was combined into the route flag bits during prefix installation in
IPv6. This inclusion causing the prefix route to be unusable. This
patch fixes this bug by excluding the IFA_RTSELF flag during route
installation.
MFC after: 5 days
same interface. The first address will install the prefix route into
the kernel routing table and that prefix will be marked as on-link.
Without RADIX_MPATH enabled, the other address aliases of the same
prefix will update the prefix reference count but no other routes
will be installed. Consequently the prefixes associated with these
addresses would not be marked as on-link. As such, incoming packets
destined to these address aliases will fail the ND6 on-link check
on input. This patch fixes the above problem by searching the kernel
routing table and try to find an on-link prefix on the given interface.
MFC after: 5 days
IFF_POINTOPOINT link types. The reason was due to the routing
entry returned from the kernel covering the remote end is of an
interface type that does not support ARP. This patch fixes this
problem by providing a hint to the kernel routing code, which
indicates the prefix route instead of the PPP host route should
be returned to the caller. Since a host route to the local end
point is also added into the routing table, and there could be
multiple such instantiations due to multiple PPP links can be
created with the same local end IP address, this patch also fixes
the loopback route installation failure problem observed prior to
this patch. The reference count of loopback route to local end would
be either incremented or decremented. The first instantiation would
create the entry and the last removal would delete the route entry.
MFC after: 5 days
with SSM MLDv2 by default.
This is current practice and complies with RFC 4604, as well as being
required by production IPv6 networks in Japan.
The behaviour may be disabled by setting the net.inet6.mld.use_allow
sysctl/tunable to 0.
Requested by: Hideki Yamamoto
MFC after: 1 week
