* WPA-None requires ap_scan=2:
The major difference between ap_scan=1 (default) and 2 is, that no
IEEE80211_IOC_SCAN* ioctls/functions are called, though, there is a
dependency on those. For example the call to wpa_driver_bsd_scan()
sets the interface UP, this never happens, therefore the interface
must be marked up in wpa_driver_bsd_associate(). IEEE80211_IOC_SSID
also is not called, which means that the SSID has not been set prior
to the IEEE80211_MLME_ASSOC call.
* WPA-None has no support for sequence number updates, it doesn't make
sense to check for replay violations..
* I had some crashes right after the switch to RUN state, issue is
that sc->sc_lastrs was not yet defined.
Approved by: rpaulo (mentor)
MFC after: 3 weeks
This framework allows drivers to abstract the rate control algorithm and
just feed the framework with the usable parameters. The rate control
framework will now deal with passing the parameters to the selected
algorithm. Right now we have AMRR (the default) and RSSADAPT but there's
no way to select one with ifconfig, yet.
The objective is to have more rate control algorithms in the net80211
stack so all drivers[0] can use it. Ideally, we'll have the well-known
sample rate control algorithm in the net80211 at some point so all
drivers can use it (not just ath).
[0] all drivers that do rate control in software, that is.
Reviewed by: bschmidt, thompsa, weyongo
MFC after: 1 months
iv_recv_mgmt(). iv_recv_mgmt() will generate management frame responses
and pass them to bpf before the management frame that triggered the
response.
PR: 144323
Submitted by: Alexander Egorenkov <egorenar at gmail.com>
MFC after: 2 weeks
Sponsored by: iXsystems, inc.
o Process the BAR frame on the adhoc, mesh and sta modes
o Fix the format of the ADDBA reply frame
o Fix references to the spec section numbers
Also, print the all the MCS rates in bootverbose.
Sponsored by: iXsystems, Inc.
Obtained from: //depot/user/rpaulo/80211n/...
ifmultiaddr structures' reference to the parent interface, unless the parent
interface is really detaching. While here, program only link layer multicast
filters to a wlan's hardware parent interface.
PR: kern/142391, kern/142392
Reviewed by: sam, rpaolo, bms
MFC after: 1 week
the parent wirless interface. If the user passed in a mac address or it was
autogenerated then flag this to avoid trashing it on update.
This will fix wlan+lagg in a post vap world.
This makes ifconfig list scan display the correct beacon interval
(previously it would int overflow). As a side effect, this makes the
ieee80211req_scan_result word aligned.
Submitted by: Paul B Mahol <onemda at gmail.com>
* fix the processing of RANN frames
* the originator and target addresses were swapped and while it worked
fine, it was not spec compliant.
MFC after: 3 days
band-aid for the general problem that if_link_state_change can be
called between if_detach and if_free leaving a task queued that has
been free'd.
Spotted by: thompsa
Reviewed by: rwatson
Approved by: re (rwatson)
vnet.h, we now use jails (rather than vimages) as the abstraction
for virtualization management, and what remained was specific to
virtual network stacks. Minor cleanups are done in the process,
and comments updated to reflect these changes.
Reviewed by: bz
Approved by: re (vimage blanket)
