"...If "keyboard" is the selected input-device and "screen" the
output-device (both via /options) but the keyboard is unplugged,
OF automatically switches to ttya for the console, it even prints
a line telling so on "screen". Solaris respects this behaviour and
uses ttya as the console in this case and people probably expect
FreeBSD to do the same (it's also very handy to temporarily switch
consoles)..."
"...I changed the comparison of the console device with "ttya" ||
"ttyb" to "tty" because on AXe boards all 4 onboard UARTs end in
SUB-D connectors (ttya and ttyb being 16550 and ttyc and ttyd a
SAB82532) and there's no Sun keyboard connector (but PS/2). If one
plugs a serial card in a box there also can be more than just ttya
and ttyb available for a console..."
Submitted by: Marius Strobl <marius@alchemy.franken.de>
Has no doubt that the change is correct: marcel
- Factor out common settings and put them in an upper level Makefile.inc.
- Properly use PROG for real programs, not their products.
- Further reduce diffs to i386 versions.
Tested on: sparc64 (panther)
This ensures that uart gets a higher console priority than syscons when
a serial console is being used. Testing against the "console" environment
variable doesn't make sense since we only have one loader console driver.
path, instead of an internal i386 specific one. Don't try to interpret
a disklabel in ofw_disk.c, open the partition's device node directly and
let the firmware do it. This fixes booting from a partition other than 'a'
on sparc64, which is needed to support more installation methods.
No objection: ppc
This is required by recent changes to <sys/pcpu.h>, which uses
the #error preprocessor directive to keep non-kernel
applications from using it.
_KERNEL is defined below the #include <stand.h>, because <stand.h>
removes the definition of _KERNEL.
- Move the inclusion of <sys/queue.h> above the inclusion of
<sys/linker.h> to avoid syntax errors.
special-case make rule
2.) Cleanups, remove superfluous expicit rules, add -nostdlib to LDFLAGS,
remove -X and -g, remove -g from CFLAGS
3.) Add BINDIR
4.) Build install the loader help file, add an empty help.sparc64
5.) Change the default configuration to only support booting from disk
6.) Get libofw.a from a path relative ${.OBJDIR}, not ${.CURDIR}
Submitted by: jake (1 - 5), obrien (6)
watchpoint support for debugging (under LOADER_DEBUG). Claim the
physical and virtual addresses used to map the kernel from the prom;
we map it ourselves behind the scenes though. Add a reboot command.
Submitted by: tmm
Remove asm functions to call the openfirmware and kernel entry points;
we can just call them directly.
Don't use the stack pointer for an intermediate result in setx.
Put the stack in the bss.
