IPI to a specific CPU by its cpuid. Replace calls to ipi_selected() that
constructed a mask for a single CPU with calls to ipi_cpu() instead. This
will matter more in the future when we transition from cpumask_t to
cpuset_t for CPU masks in which case building a CPU mask is more expensive.
Submitted by: peter, sbruno
Reviewed by: rookie
Obtained from: Yahoo! (x86)
MFC after: 1 month
interfaces to be a vlan (IFT_L2VLAN) rather than an Ethernet interface
(IFT_ETHER). The code already fixed if_type in the ifnet causing some
places to report the interface as a vlan (e.g. arp -a output) and other
places to report the interface as Ethernet (getifaddrs(3)). Now they
should all report IFT_L2VLAN.
Reviewed by: brooks
MFC after: 1 month
the virtualization detection successfully disabling the clflush instruction.
This fixes insta-panics for XEN hvm users when the hw.clflush_disable
tunable is -1 or 0 (-1 by default).
Discussed with: jhb
cdev will never be destroyed. Propagate the flag to devfs vnodes as
VV_ETERNVALDEV. Use the flags to avoid acquiring devmtx and taking a
thread reference on such nodes.
In collaboration with: pho
MFC after: 1 month
MIPS doesn't really need to use atomic_cmpset_int() in situations like
this because the software dirty bit emulation in trap.c acquires
the pmap lock. Atomics like this appear to be a carryover from i386
where the hardware-managed TLB might concurrently set the modified bit.
Reviewed by: alc
pmap_page_wired_mappings() counts the number of pv entries for the
specified page that have the pv entry wired flag set to TRUE.
pmap_enter() correctly initializes this flag. However,
pmap_change_wiring() doesn't update the corresponding pv entry flag,
only the PTE. So, the count returned by pmap_page_wired_mappings()
will sometimes be wrong.
In the short term, the best fix would be to eliminate the pv entry
flag and use only the PTE. That flag is wasting non-trivial memory.
Remove pv_wired flag, and use PTE flag to count the wired mappings.
Reviewed by: alc
value resulted in poor performance for UDP packets. With this
change, UDP bulk transfer performance is more than 940Mbps.
While I'm here fix a wrong register definition.
VM86 calls instead of the real mode emulator as a backend. VM86 has been
proven reliable for very long time and it is actually few times faster than
emulation. Increase maximum number of page table entries per VM86 context
from 3 to 8 pages. It was (ridiculously) low and insufficient for new VM86
backend, which shares one context globally. Slighly rearrange and clean up
the emulator backend to accommodate new code. The only visible change here
is stack size, which is decreased from 64K to 4K bytes to sync. with VM86.
Actually, it seems there is no need for big stack in real mode.
MFC after: 1 month
As des noted, the section on SCTP would benefit from
a rewrite by a native speaker (which I am not).
Any volunteers?
Approved by: des (mentor)
MFC after: 1 week
bus_generic_resume() since the pci_link(4) driver was added.
- Change the ACPI PCI-PCI bridge driver to inherit most of its methods
from the generic PCI-PCI bridge driver. In particular, this will now
restore PCI config registers for ACPI PCI-PCI bridges.
Tested by: Oleg Sharoyko osharoiko of gmail
'counter_upper' and 'counter_lower_last'. The race exists because
interrupts are enabled even though tick_ticker() executes in a
critical section.
Fix a bug in clock_intr() in how it updates the cached values of
'counter_upper' and 'counter_lower_last'. They are updated only
when the COUNT register rolls over. More interestingly it will *never*
update the cached values if 'counter_lower_last' happens to be zero.
Get rid of superfluous critical section in clock_intr(). There is no
reason to do this because clock_intr() executes in hard interrupt
context.
Switch back to using 'tick_ticker()' as the cpu ticker for Sibyte.
Reviewed by: jmallett, mav
- 32 bit compilation will still use old 2 level page tables
- re-arrange pmap code so that adding another level is easier
- pmap code for 3 level page tables for n64
- update TLB handler to traverse 3 levels in n64
Reviewed by: jmallett
infrastructure, not us. This appears to be a leftover from an older
version of the driver.
Submitted by: avg
Tested by: Anton Shterenlikht <mexas bristol.ac.uk>
MFC after: 1 week
X-MFC-Note: To stable/8 and stable/7 only
This way we would have an opportunity to hide the
Tj(target) value doesn't seem right stuff if we know
it's not working there.
Add temperature value for Core2 Duo Extreme Mobile that
I have access to.
which I mistakenly thought was correct w.r.t. style(9), back
to int and add the checks for != 0. This is just a stylistic
modification.
MFC after: 1 week
the calculation that is based on the kernel's heap size more conservative.
Hopefully, this will eliminate the need for MAXVNODES_MAX, but for the
time being set MAXVNODES_MAX to a large value.
Reviewed by: jhb@
MFC after: 6 weeks
