Use bd_getdev() to work out a dev_t for the root device.
Allow $rootdev to override $currdev as the root device.
biosdisk.c
Save the slice table and disklabel when opening a disk.
Add bd_getdev(), which attempts to return a dev_t corresponding
to a given device. Cases which it still doesn't get right:
- The inevitable da-when-wd-also-exists
- Disks with no slice table (the slice number is not set correctly)
The first is difficult to get right, the second will be
fixed in an upcoming commit.
comconsole.c
vidconsole.c
getchar() should return an 8-bit value; some BIOSsen pack extra
information in %eax.
libi386.h
Remove some stale prototypes, add new ones.
Increase the robustness of the "is it time to boot yet" test;
if the time skipped the "when" time, we would miss it.
Don't spin in an endless loop if we don't find the first possible
kernel suggested. When we run out, don't try to load an empty
kernel name.
load_aout.c
printf format warnings
of the ..umm.. "wierd" way binutils lays out the file. The section
headers are nearly at the end of the file and this is a problem when
loading from a .gz file which can't seek backwards (or has a limited
reverse seek, ~2K from memory).
This is intended to be compatable with the ddb/db_elf.c code and the
alpha/libalpha/elf_freebsd.c layout. I've studied these (which are NetBSD
derived) but did it a bit differently. Naturally the process is similar
since it's supposed to end up with the same result.
block descriptors enabled on mode sense commands.
Basically, we try sending a mode sense with block descriptors disabled (the
previous default), and if it fails, we try sending the mode sense with
block descriptors enabled. If that works, we note that in a runtime quirk
entry, so we don't bother disabling block descriptors again for the device.
This problem was first reported by Chris Jones <cjones@honors.montana.edu>
on one of the NetBSD lists, but I'd imagine that some FreeBSD users would
have run into it eventually as well, since our changer driver is derived
form the NetBSD changer driver.
Also, change some of the probe logic so that we do the right thing in the
case of a failure to attach.
Fix a memory leak in chgetparams().
Add a couple of inline helper functions to scsi_all.h to correctly return
the start of a mode page.
NetBSD PR: kern/6214
Reviewed by: gibbs
timeouts in the SA driver (timeouts for space, rewind and erase). Folks
can lengthen the timeouts if their hardware is especially slow, or shorten
them if they want to be notified of errors a little sooner.
Also, get rid of two OD driver options. The od driver has been made
obsolete by the da driver.
Reviewed by: ken, gibbs
Submitted by: Dag-Erling Coidan Smørgrav <des@FreeBSD.ORG>
expected. This bug caused builds of Modula-3 to fail in mysterious
ways on SMP kernels. More precisely, such builds failed on systems
with kern.fast_vfork equal to 0, the default and only supported
value for SMP kernels.
PR: kern/7468
Submitted by: tegge (Tor Egge)
- Express various sizes in bytes, rather than Kbytes, in the video
mode and adapter information structures.
- Fill 0 in the linear buffer size field if the linear frame buffer
is not available.
- Remove SW_VESA_USER ioctl. It is still experimetal and was not meant
to be released.
- Fix missing cast operator.
- Correctly handle pointers returned by the VESA BIOS. The pointers
may point to the area either in the BIOS ROM or in the buffer supplied
by the caller.
- Set the destructive cursor at the right moment.
o Use the board id command to find out what kind of board
we're talking to. If we're talking to a board that is has
an ID that is shared between boards supported by the aha
driver and the bt driver, then use the bt's geometry
register to weed out the bt cards. Otherwise assume that we
support this card.
o Remove bt esetup command sending to the card. It seems to
wedge too many cards.
o Revert to doing a soft reset after an invalid command. This
change didn't fix anything, so I'm backing it out. The
whole issue of card resetting needs to be revisisted at some
point so that we can do it properly on all hardware.
o GC unused stuff in some places.
bootblocks, the kernel shows up as the primary module:
[3:24am]~-100# kldstat
Id Refs Address Size Name
1 1 0xf0100000 ff00000 /kernel
^^^^ oops.. :-)
Based heavily on aout_freebsd.c. Hmm.. There's so much in common that
these could probably be combined and just check the metadata to see which
format it is.
so far, and should probably be able to be made to work for the alpha
without too much trouble once it's connected up and my assumptions tested.
I think (but have not tested) it will also load "old" ELF kernels that
were not linked with DYNAMIC headers.
The module glue is yet to come. (oh fun.. :-)
It does not explicitly load symbols [yet]. The _DYNAMIC data contains a
runtime symbol set that ddb can use via ddb/db_kld.c. It'll be missing
some detail that stabs normally provides (eg: number of args to a function,
line numbers, etc). On the other hand, those minimal symbols will always
be available even on a stripped kernel.
This is mostly stolen from load_aout.c with some ideas from
alpha/libalpha/elf_freebsd.c.
the in-kernel linker to access the _DYNAMIC data for doing loadable elf
modules. The alpha kernel is already done this way, I've borrowed some of
the hacks from there.
This is primarily aimed at the 3-stage boot process which is intended to
be able to do pre-loading of kernel modules.
Note that the entry point isn't 0xf0100000 any more, it'll be a little
further on - but this value is stored in the headers. I don't think this
will be a problem, but I'm sure somebody will tell me if it is. :-)
I'm not sure if btxboot is going to like this, it doesn't do proper ELF
header checking and assumes that there are exactly two program header
entries and that they are both PT_LOAD entries - a bad assumption.
happen when an NFS exported filesystem tries to remove a locally
mounted on directory.
PR: kern/7272
Submitted by: Andre Albsmeier <andre.albsmeier@mchp.siemens.de>
for some of the fsinfo RPC fields. It is strictly speaking not
wrong to do this, as the spec says that "it is expected that a
server will make a best effort at supporting all the attributes",
but pretty unusual. You guessed it, it's NT servers that do it.'
Obtained from: Frank van der Linden <frank@wins.uva.nl>
is being deleted due to an forcible unmount. The problem is
that vgone calls vclean() which then calls calls nfs_inactive()
with VXLOCK set on the vnode. Nfs_inactive() was calling vget()
to get a reference on the vnode, which in turn hung on VXLOCK.
Nfs_inactive() now checks v_usecount to make sure that the vnode
is not coming from vclean() before it does a vget().
is less than NFS_MINPACKET or greater than NFS_MAXPACKET in size, it
barfs and, I think, drops the connection.
However, there's no guarantee that in a multi-fragment RPC, all the
fragments will be at least as large as NFS_MINPACKET.
In fact, with the version of "tclnfs" we have here, which supports NFS
over TCP, at least when built under SunOS 4.1.3 (i.e., with 4.1.3's
user-mode ONC RPC library), I can *repeatably* cause "tclnfs" to send a
request with more than one fragment, one of which is only 8 bytes long.
I just do a 3877-byte write to a file, at an offset of 0.
The check that "slp->ns_reclen" is greater than or equal to
NFS_MINPACKET serves no useful purpose - if the NFS server code can't
handle packets < NFS_MINPACKET bytes, it can't handle them over *any*
protocol, so the check has to be done above the RPC-over-TCP layer - and
should be removed.
Obtained from: Fix from Guy Harris, forwarded by Rick Macklem.
