It only supports sa1110 (on simics) right now, but xscale support should come
soon.
Some of the initial work has been provided by :
Stephane Potvin <sepotvin at videotron.ca>
Most of this comes from NetBSD.
Wind River. In the IPv4 output path, one of the tests in ip_output()
checks how many slots are actually available in the interface output
queue before attempting to send a packet. If, for example, we need
to transmit a packet of 32K bytes over an interface with an MTU of
1500, we know it's going to take about 21 fragments to do it. If
there's less than 21 slots left in the output queue, there's no point
in transmitting anything at all: IP does not do retransmission, so
sending only some of the fragments would just be a waste of bandwidth.
(In an extreme case, if you're sending a heavy stream of fragmented
packets, you might find yourself sending nothing by the first fragment
of all your packets.) So if ip_output() notices there's not enough
room in the output queue to send the frame, it just dumps the packet
and returns ENOBUFS to the app.
It turns out ip6_output() lacks this code. Consequently, this caused
the netperf UDPIPV6_STREAM test to produce very poor results with large
write sizes. This commit adds code to check the remaining space in the
output queue and junk fragmented packets if they're too big to be
sent, just like with IPv4. (I can't imagine anyone's running an NFS
server using UDP over IPv6, but if they are, this will likely make them
a lot happier. :)
fills its field (6 characters). In that case the OEMID is not
null-terminated, and the sprintf that was used would copy up to the
next null byte, which could be pretty far away.
o Remove setting the description of the device (that is more properly done in
probe).
o Remove setting the driver, as it is unnecessary
o Add pseudo code to ensure that the device isn't added to the tree already.
o remove some now unreferenced routines
registers, so add a register offset array to the softc. We key off the
device ID to determine which set of register offsets. Currently the 8385
host bridge used on amd64 is the only bridge to use the AGP3_VIA_*
register offsets and all other bridges use the AGP_VIA_* offsets. It is
currently unclear if the AGP3_VIA_* offsets are for VIA bridges that
implement AGP 3.0 bridges or just for amd64 bridges.
Submitted by: Kenneth Culver culverk at sweetdreamsracing dot biz
removes a specific thread from a sleep queue. sleepq_resume_thread()
resumes scheduling of a thread that has been previously removed from a
sleep queue.
- sleepq_catch_signals() just removes a thread from the queue it was just
added to when a pending signal is found.
- sleepq_signal() and sleepq_broadcast() remove threads from a queue,
drop the queue lock, and then resume all the previously removed threads.
This doesn't completely fix the sched_lock <-> sleepq chain LOR, but it
makes it a little better as we no longer call setrunnble() with a sleep
queue lock held meaning if setrunnable() tries to wakeup the swapper we
don't try to lock two sleep queue chains at the same time.
proper locking to be checked at runtime.
Remove sb_lock() and sb_unlock() calls from sb_reset_dsp() because the
latter is called from sb_setup() with the lock already held. Add a
call to sb_lockassert().
Surround the call to sb_reset_dsp() in sb16_attach() with sb_lock()
and sb_unlock() calls.
Tested by: Bartek Marcinkiewicz <junior AT p233.if.pwr.wroc.pl>
