* Implement a SoC probe function, from Linux, which determines the
SoC family, type and revision. This only probes the AR71xx series
SoC and (currently) panics on others.
* Migrate some of the AR71XX specific hardware init (USB device, determining
system frequencies) into using the cpuops introduced in an earlier commit.
Other SoC specific hardware stuff (per-device flush/WB, GPIO pin wiring,
Ethernet PLL setup, other things I've likely missed) will be introduced in
subsequent commits.
Reviewed by: imp@
Obtained from: (partially) Linux
it must reset its congestion window back to the initial window.
RFC3390 has increased the initial window from 1 segment to up to
4 segments.
The initial window increase of RFC3390 wasn't reflected into the
restart window which remained at its original defaults of 4 segments
for local and 1 segment for all other connections. Both values are
controllable through sysctl net.inet.tcp.local_slowstart_flightsize
and net.inet.tcp.slowstart_flightsize.
The increase helps TCP's slow start algorithm to open up the congestion
window much faster.
Reviewed by: lstewart
MFC after: 1 week
sysctl's and remove any side effects.
Both sysctl's share the same backend infrastructure and due to the
way it was implemented enabling net.inet.tcp.log_in_vain would also
cause log_debug output to be generated. This was surprising and
eventually annoying to the user.
The log output backend is kept the same but a little shim is inserted
to properly separate log_in_vain and log_debug and to remove any side
effects.
PR: kern/137317
MFC after: 1 week
1. On n64, use XKPHYS to map page table pages instead of KSEG0. Maintain
just one freepages list on n64.
The changes are mainly to introduce MIPS_PHYS_TO_DIRECT(pa),
MIPS_DIRECT_TO_PHYS(), which will use KSEG0 in 32 bit compilation
and XKPHYS in 64 bit compilation.
2. Change macro based PMAP_LMEM_MAP1(), PMAP_LMEM_MAP2(), PMAP_LMEM_UNMAP()
to inline functions.
3. Introduce MIPS_DIRECT_MAPPABLE(pa), which will further reduce the cases
in which we will need to have a special case for 64 bit compilation.
4. Update CP0 hazard definitions for CPU_RMI - the cpu does not need any
nops
Reviewed by: neel
number of syncache entries into account for the surplus we add to account
for a possible increase of records in the re-entry window.
Discussed with: jhb, silby
MFC after: 1 week
Each of these SoCs have different devices, different hardware initialisation
methods and, quite likely, different quirks. These functions will abstract
out the SoC differences and keep these differences out of the drivers (eg
USB init, if_arge, etc.)
Makefiles or *.mk files, use ${CC:T:Mfoo} instead, so only the basename
of the compiler command (excluding any arguments) is considered.
This allows you to use, for example, CC="/nondefault/path/clang -xxx",
and still have the various tests in bsd.*.mk identify your compiler as
clang correctly.
ICC if cases were also changed.
Submitted by: Dimitry Andric <dimitry at andric.com>
memory size estimate to userland for pcb list sysctls. The previous
behavior of a "slop" of n/8 does not work well for small values of n
(e.g. no slop at all if you have less than 8 open UDP connections).
Reviewed by: bz
MFC after: 1 week
method is used by the PCI bus driver to query the power management system
to determine the proper device state to be used for a device during suspend
and resume. For the ACPI PCI bridge drivers this calls
acpi_device_pwr_for_sleep(). This removes ACPI-specific knowledge from
the PCI and PCI-PCI bridge drivers.
Reviewed by: jkim
In particular, provide pagesize and pagesizes array, the canary value
for SSP use, number of host CPUs and osreldate.
Tested by: marius (sparc64)
MFC after: 1 month
to uma_zone_set_max().
The UMA zone limit is not exactly set to the value supplied but
rounded up to completely fill the backing store increment (a page
normally). This can lead to surprising situations where the number
of elements allocated from UMA is higher than the supplied limit
value. The new get function reads back the effective value so that
the supplied limit value can be adjusted to the real limit.
Reviewed by: jeffr
MFC after: 1 week
path MTU discovery and the tcp_minmss limiter for very small MTU's.
When the MTU suggested by the gateway via ICMP, or if there isn't
any the next smaller step from ip_next_mtu(), is lower than the
floor enforced by net.inet.tcp.minmss (default 216) the value is
ignored and the default MSS (512) is used instead. However the
DF flag in the IP header is still set in tcp_output() preventing
fragmentation by the gateway.
Fix this by using tcp_minmss as the MSS and clear the DF flag if
the suggested MTU is too low. This turns off path MTU dissovery
for the remainder of the session and allows fragmentation to be
done by the gateway.
Only MTU's smaller than 256 are affected. The smallest official
MTU specified is for AX.25 packet radio at 256 octets.
PR: kern/146628
Tested by: Matthew Luckie <mjl-at-luckie org nz>
MFC after: 1 week
report when a new socket couldn't be created because one of
in_pcbinshash(), in6_pcbconnect() or in_pcbconnect() failed.
Logging is conditional on net.inet.tcp.log_debug being enabled.
MFC after: 1 week
and we loop back to 'again'. If the remainder is less or equal
to one full segment, the TSO flag was not cleared even though
it isn't necessary anymore. Enabling the TSO flag on a segment
that doesn't require any offloaded segmentation by the NIC may
cause confusion in the driver or hardware.
Reset the internal tso flag in tcp_output() on every iteration
of sendalot.
PR: kern/132832
Submitted by: Renaud Lienhart <renaud-at-vmware com>
MFC after: 1 week
a kernel printf to a log output with the priority of LOG_NOTICE.
This way the messages still show up in /var/log/messages but no
longer spam the console every other second on busy servers that
are port scanned:
"Limiting open port RST response from 114 to 100 packets/sec"
PR: kern/147352
Submitted by: Eugene Grosbein <eugen-at-eg sd rdtc ru>
MFC after: 1 week
It was experimental and interferes with the normal congestion control
algorithms by instating a separate, possibly lower, ceiling for the
amount of data that is in flight to the remote host. With high speed
internet connections the inflight limit frequently has been estimated
too low due to the noisy nature of the RTT measurements.
This code gives way for the upcoming pluggable congestion control
framework. It is the task of the congestion control algorithm to
set the congestion window and amount of inflight data without external
interference.
Reviewed by: lstewart
MFC after: 1 week
Removal after: 1 month
and go to the next iteration early if multicast filtering would decide that
this socket shall not receive the data.
Unlock the pcb in that case or we leak the read lock and next time trying
to get a write lock, would hang forever.
PR: kern/149608
Submitted by: Chris Luke (chrisy flirble.org)
MFC after: 3 days
