_PDC was deprecated in favor of _OSC long time ago, but it
seems that they still peacefully coexist and in some case
only _PDC is present.
Still _OSC provides a reacher interface and is capable to
report back its status.
If the status is non-zero, then report it, we may find
it useful to understand what firmware expects from OS.
Also clean up some comments that became less useful over time.
Reviewed by: njl, jhb, rpaulo
MFC after: 3 weeks
disabling interrupts.
Simplify register usage - we can directly load 'curpcb' into 'k1' after
interrupts are disabled. There is no need to do so indirectly through 'a1'.
The only reason we need to have the sb_load64() and sb_store64()
functions in assembly is to cheat the compiler and generate the
'ld' and 'sd' instructions which it otherwise will not do when
compiling for a 32-bit architecture. There are some 64-bit
registers in the SCD unit that must be accessed using 64-bit
load and store instructions.
providers for writing provokes huge traffic related to taste events send
by GEOM on close. This can lead to various problems with opening GEOM
providers that are created on top of other GEOM providers.
Reorted by: Kurt Touet <ktouet@gmail.com>, mr
Tested by: mr, Baginski Darren <kickbsd@ya.ru>
MFC after: 2 weeks
out each such call graph only once, along with a stack backtrace. This
should make kernels built with VNET_DEBUG reasonably usable again in
busy / production environments.
Introduce a new DDB command "show vnetrcrs" which dumps the whole log
of distinctive curvnet recursion events. This might be useful when
recursion reports get burried / lost too deep in the message buffer.
In the later case stack backtraces are not available.
Reviewed by: bz
MFC after: 3 days
numbers and handle types in rational way. This will better protect from
(unwittingly) dealing with stale handles/commands.
Fix the watchdog timeout code to better protect itself from mistakes.
If we run an abort on a putatively timed out command, the command
may in fact get completed, so check to make sure the command we're
timing it out is still around. If the abort succeeds, btw, the command
should get returned via a different path.
Add Power Up In Stand-by feature support. Device with PUIS enabled
require explicit command to do initial spin-up. Mark that command
with CAM_HIGH_POWER flag, to allow CAM manage staggered spin-up.
Make CAM to stop all attached devices on system shutdown.
It allows devices to park heads, reducing stress on power loss.
Add `kern.cam.power_down` tunable and sysctl to controll it.
successfully. Continue to do this before the empty path check so that the
ENOENT returned in that case gets an empty string token in the BSM record.
MFC after: 3 days
the IP addresses of the tunnel end points to the same value. In
these cases the loopback route is not installed for the local
end.
Verified by: avg
MFC after: 5 days
