Driver support is only provided for ConnectX4/5.
System-time timestamp is calculated based on the free-running counter
timestamp provided by hardware. Driver periodically samples the
counter to calibrate it against the system clock and uses linear
interpolation to convert. Stability of the crystal which drives the
clock is +-50 ppm at the operational temperature, which makes the
algorithm good enough.
The calculation is somewhat delicate because all values are 64bit and
overflow the naive formula for linear interpolation. The calculation
drops the least significant bits in advance, see the PREC shift in
mlx5_mbuf_tstmp().
Hardware stamps can be turned off by 'ifconfig mceN -hwrxtsmp'. Buggy
firmware might result in small but visible errors in the reported
timestamps, detectable e.g. by nonsensical (negative) RTT values for
LAN pings.
Reviewed by: gallatin, hselasky
Sponsored by: Mellanox Technologies
Differential revision: https://reviews.freebsd.org/D12638
Very early BHND Wi-Fi devices (e.g. BCM4318) do not support any form of
dynamic clock control; on these devices, any PMU requests that cannot be
met by the device's fixed clock state will return an appropriate error
code.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Very early (PCI_V0) Broadcom PCI Wi-Fi chipsets have a few quirks when
compared to later PCI(e) core revisions:
- The standard static BAR0 mapping of the PCI core registers is discontiguous,
with siba's cfg0 register block mapped distinctly from the other core
registers.
- No dedicated ChipCommon register mapping is provided; instead, the
single configurable register window must be used to access both
ChipCommon and D11 core registers. The D11 core's operational semantics
guarantee the safety of -- after disabling interrupts -- borrowing
the single dynamic register window to perform the few ChipCommon
operations required by a driver.
To support these early PCI devices:
- Allow defining multiple discontiguous BHNDB_REGWIN_T_CORE register
windows that map a single port/region, and producing bridged resource
allocations backed by those discontiguous windows.
- Support stealing existing register window allocations to fulfill indirect
bhnd(4) bus I/O requests within address ranges tagged with
BHNDB_ALLOC_FULFILL_ON_OVERCOMMIT.
- Fix an inverted test of bhndb_is_pcie_attached() that disabled
PCI-only clock bring-up required by these devices.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
The SIBA_QUIRK_PCIE_D11_SB_TIMEOUT quirk should match on all BCM4312
revisions, and backplane service timeouts must also be disabled.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Add missing support for specifying I/O control flags during core reset,
and resolve a number of siba(4)-specific reset issues:
- Add missing check for target reject flags in siba_is_hw_suspended().
- Remove incorrect wait on SIBA_TMH_BUSY when modifying any target state
register; this should only be done when waiting for initiated
transactions to clear.
- Add missing wait on SIBA_IM_BY when asserting SIBA_IM_RJ.
- Overwrite any previously set SIBA_TML_REJ flag when bringing the core
out of reset. This fixes a lockup that occured when we brought up a core
(after reboot) that had previously been placed into RESET by siba_bwn(4).
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D13039
This includes a number of copyedits for the inline code documentation
comments, updates to the existing bhnd(4), bhndb(4), bcma(4), and siba(4)
man pages, and new man pages for bhnd_chipc(4), bhnd_pmu(4), bhndb_pci(4),
bhnd(9), and bhnd_erom(9).
Approved by: adrian (mentor)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D13021
Mainly focus on files that use BSD 2-Clause license, however the tool I
was using misidentified many licenses so this was mostly a manual - error
prone - task.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
This logic is still imperfect, since it allows at most 15 bidirectional
streams out of 30 allowed by specification, but at least now those should
work better. On the other side I don't remember I ever saw controller
supporting the bidirectional streams, so this is likely a nop change.
MFC after: 1 month
can be used prior to the ISCSIDHANDOFF IOCTL which set the negotiated values.
Else the login PDU will fail when passing the "-r" option to "iscsictl" which
means iSCSI over RDMA instead of TCP/IP.
Discussed with: np@ and trasz@
Sponsored by: Mellanox Technologies
MFC after: 1 week
The driver is functional on both BHND Wi-Fi adapters and MIPS SoCs, but
does not currently include support for features not required by bwn(4),
including GPIO interrupt handling.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12708
The bwn(4) driver requires a number of extensions to the bhnd(4) PMU
interface to support external configuration of PLLs, LDOs, and other
parameters that require chipset or PHY-specific workarounds.
These changes add support for:
- Writing raw voltage register values to PHY-specific LDO regulator
registers (required by LP-PHY).
- Enabling/disabling PHY-specific LDOs (required by LP-PHY)
- Writing to arbitrary PMU chipctrl registers (required for common PHY PLL
reset support).
- Requesting chipset/PLL-specific spurious signal avoidance modes.
- Querying clock frequency and latency.
Additionally, rather than updating legacy PWRCTL support to conform to the
new PMU interface:
- PWRCTL API is now provided by a bhnd_pwrctl_if.m interface.
- Since PWRCTL is only found in older SSB-based chipsets, translation from
bhnd(4) bus APIs to corresponding PWRCTL operations is now handled
entirely within the siba(4) driver.
- The PWRCTL-specific host bridge clock gating APIs in bhnd_bus_if.m have
been lifted out into a standalone bhnd_pwrctl_hostb_if.m interface.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12664
BHND Wi-Fi chipsets and SoCs share a common DMA engine, operating within
backplane address space. To support host DMA on Wi-Fi chipsets, the bridge
core maps host address space onto the backplane; any host addresses must
be translated to their corresponding backplane address.
- Defines a new bhnd_get_dma_translation(9) API to support querying DMA
address translation parameters from the bhnd(4) bus.
- Extends bhndb(4) to provide DMA translation descriptors from a DMA
address translation table defined in the host bridge-specific
bhndb_hwcfg.
- Defines bhndb(4) DMA address translation tables for all supported host
bridge cores.
- Extends mips/broadcom's bhnd_nexus driver to return an identity (no-op)
DMA translation descriptor; no translation is required when addressing
the SoC backplane.
Approved by: adrian (mentor)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12582
On BHND MIPS SoCs, this replaces the use of hard-coded MIPS IRQ#s in the
common bhnd(4) core drivers; we now register an INTRNG child PIC that
handles routing of backplane interrupt vectors via the MIPS core.
On BHND PCI devices, backplane interrupt vectors are now routed to the
PCI/PCIe host bridge core when bus_setup_intr() is called, where they are
dispatched by the PCI core via a host interrupt (e.g. INTx/MSI).
The bhndb(4) bridge driver tracks registered interrupt handlers for the
bridged bhnd(4) devices and manages backplane interrupt routing, while
delegating actual bus interrupt setup/teardown to the parent bus on behalf
of the bridged cores.
Approved by: adrian (mentor, implicit)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D12518
the system time.
As we seem to only read this time on boot, and this is the only source of
time on many arm64 machines we need to enable this by default there. As
this is not always the case with U-Boot firmware, or when we have been
booted from a non-UEFI environment we only enable the device driver when
the Runtime Services are present and reading the time doesn't result in an
error.
PR: 212185
Reviewed by: imp, kib
Tested by: emaste
Relnotes: yes
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D12650
Mainly focus on files that use BSD 3-Clause license.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
Special thanks to Wind River for providing access to "The Duke of
Highlander" tool: an older (2014) run over FreeBSD tree was useful as a
starting point.
XX_VirtToPhys(), by way of pmap_kextract(), is an expensive operation.
Profiling via dtrace during a series of iperf tests I found 16111 / 30432
stack frames were located in mmu_booke_kextract(), so eliminating this
expensive call should improve performance slightly. XX_PhysToVirt() is not
as expensive, but redundant calls in this context is wasteful.
The Software Package Data Exchange (SPDX) group provides a specification
to make it easier for automated tools to detect and summarize well known
opensource licenses. We are gradually adopting the specification, noting
that the tags are considered only advisory and do not, in any way,
superceed or replace the license texts.
Special thanks to Wind River for providing access to "The Duke of
Highlander" tool: an older (2014) run over FreeBSD tree was useful as a
starting point.
Initially, only tag files that use BSD 4-Clause "Original" license.
RelNotes: yes
Differential Revision: https://reviews.freebsd.org/D13133
tunables. Add num_vis to the intrs_and_queues structure as it affects
the number of interrupts requested and queues created. In future
cfg_itype_and_nqueues might lower it incrementally instead of going
straight to 1 when enough interrupts aren't available.
Sponsored by: Chelsio Communications
Background:
The coming ibcore update forces an update of mlx4ib(4) which in turn requires
an updated mlx4 core module. This also affects the mlx4en(4) module because
commonly used APIs are updated. This commit is a middle step updating the
mlx4 modules towards the new ibcore.
This change contains no major new features.
Changes in mlx4:
a) Improved error handling when mlx4 PCI devices are
detached inside VMs.
b) Major update of codebase towards Linux 4.9.
Changes in mlx4ib(4):
a) Minimal changes needed in order to compile using the
updated mlx4 core APIs.
Changes in mlx4en(4):
a) Update flow steering code in mlx4en to use new APIs for
registering MAC addresses and IP addresses.
b) Update all statistics counters to be 64-bit.
c) Minimal changes needed in order to compile using the
updated mlx4 core APIs.
Sponsored by: Mellanox Technologies
MFC after: 1 week
The setbit/clearbit pair casts the bitfield pointer
to uint8_t* which effectively treats its contents as
little-endian variable. The ffs() function accepts int as
the parameter, which is big-endian. Use uint8_t here to
avoid mismatch, as we have only 4 doorbells.
Submitted by: Wojciech Macek <wma@freebsd.org>
Reviewed by: np
Obtained from: Semihalf
Sponsored by: QCM Technologies
Differential revision: https://reviews.freebsd.org/D13084
No longer return ENXIO when trying to send an IPv6 packet in
nicvf_sq_add_hdr_subdesc().
Restructure the code so that the upper layer protocol parts are
agnostic of the L3 protocol (and no longer specific to IPv4).
With this basic IPv6 packets go through. We are still seeing
weird behaviour which needs further diagnosis.
PR: 223669
In collaboration with: emaste
MFC after: 3 days
The driver is currently hardcoded to force promiscuous mode, so all of
the MAC filtering code is presently unused and multicast should "just
work." Report to the higher layers that multicast is supported.
PR: 223573
Reported by: bz
Sponsored by: The FreeBSD Foundation, Packet.net (hardware)
Different compilers may optimise the enum type in different ways. This ensures
coherency when range checking the value of enums in ibcore.
Sponsored by: Mellanox Technologies
MFC after: 1 week
information for that and XPT_PATH_INQ. Provide macros to encode/decode
major/minor versions. Read the link speed and lane count to compute
the base_transfer_speed for XPT_PATH_INQ.
Sponsored by: Netflix
