This contains some new testcases in /usr/tests/...:
- .../lib/libc
- .../lib/libthr
- .../lib/msun
- .../sys/kern
Tested on: amd64, i386
MFC after: 1 month
drain timeout handling to historical freebsd behavior.
The primary reason for these changes is the need to have tty_drain() call
ttydevsw_busy() at some reasonable sub-second rate, to poll hardware that
doesn't signal an interrupt when the transmit shift register becomes empty
(which includes virtually all USB serial hardware). Such hardware hangs
in a ttyout wait, because it never gets an opportunity to trigger a wakeup
from the sleep in tty_drain() by calling ttydisc_getc() again, after
handing the last of the buffered data to the hardware.
While researching the history of changes to tty_drain() I stumbled across
some email describing the historical BSD behavior of tcdrain() and close()
on serial ports, and the ability of comcontrol(1) to control timeout
behavior. Using that and some advice from Bruce Evans as a guide, I've
put together these changes to implement the hardware polling and restore
the historical timeout behaviors...
- tty_drain() now calls ttydevsw_busy() in a loop at 10 Hz to accomodate
hardware that requires polling for busy state.
- The "new historical" behavior for draining during close(2) is retained:
the drain timeout is "1 second without making any progress". When the
1-second timeout expires, if the count of bytes remaining in the tty
layer buffer is smaller than last time, the timeout is extended for
another second. Unfortunately, the same logic cannot be extended all
the way down to the hardware, because the interface to that layer is a
simple busy/not-busy indication.
- Due to the previous point, an application that needs a guarantee that
all data has been transmitted must use TIOCDRAIN/tcdrain(3) before
calling close(2).
- The historical behavior of honoring the drainwait setting for TIOCDRAIN
(used by tcdrain(3)) is restored.
- The historical kern.drainwait sysctl to control the global default
drainwait time is restored, but is now named kern.tty_drainwait.
- The historical default drainwait timeout of 300 seconds is restored.
- Handling of TIOCGDRAINWAIT and TIOCSDRAINWAIT ioctls is restored
(this also makes the comcontrol(1) drainwait verb work again).
- Manpages are updated to document these behaviors.
Reviewed by: bde (prior version)
This makes the versions inheritance consistent for our versioned libraries.
Extracted from: ino64
Discussed with: kan
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Nowadays it's not necessary to compute network mask from the IP address and
compare to given by DHCP.
Submitted by: kczekirda
Reviewed by: glebius, bapt
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D8740
libstdc++ before gcc r244057 expected that libc provided
__cxa_thread_atexit_impl, and libstdc++ implemented
__cxa_thread_atexit, by forwarding the calls to _impl. Mentioned gcc
revision checks for __cxa_thread_atexit in libc and does not provide
the symbol from libstdc++ if found.
This change helps older gcc, in particular, all released versions
which implement thread_local, by consolidating the implementation into
libc. For that versions, if configured with the current libc, the
__cxa_thread_atexit is exported from libstdc++ as a trivial wrapper
around libc::__cxa_thread_atexit_impl.
The __cxa_thread_atexit implementation is put into separate source
file to allow for static linking with older libstdc++.a.
gcc bugzilla: https://gcc.gnu.org/bugzilla/show_bug.cgi?id=78968
Reported by: Hannes Hauswedell <h2+fbsdports@fsfe.org>
PR: 215709
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
This is preparation work for 11ac support. The regulatory database
needs to know about VHT channel flags and 80MHz (and later 160MHz)
available channel bands.
Whilst here, add the 2GHz VHT band (which is a terrible, terrible vendor
extension that almost all vendors do) just in preparation, even though
I don't (yet) plan on supporting it.
the mapping which might be accessed by other threads.
If a pointer to the /dev/hpet register page mapping was stored into
the hpet_dev_map, other threads might access the page at any time.
Never unmap it, instead, keep track of mappings for all hpet units in
smal array. Store pointer to the newly mapped registers page using
CAS, to detect parallel mappings.
It appeared relatively easy to demonstrate the problem by arranging
two threads which perform gettimeofday(2) concurently, first time in
the process address space, when HPET is used for timecounter.
PR: 215715
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
party software, this provides more standarized import workflow and
makes future upgrades easier.
The following files are new with this commit:
zconf.h.in
zlib.map
zlib.pc.in
They are not connected to build, but were kept in tree for reference
for future maintenance.
All our local trivial changes were applied to contrib/zlib, and the
contrib/zlib vendor source code is intended to 100% match lib/libz
before this commit.
MFC after: 2 weeks
As a followup to r310638, update libsysdecode (and kdump) to decode the
'mode' argument to getfsstat(). sysdecode_getfsstat_flags() has been
renamed to sysdecode_getfsstat_mode() and now treats the argument as an
enumerated value rather than a mask of flags.
Change ksw_used and ksw_total to unsigned, which increases the maximum
total swap that can be displayed properly from ~8TB to ~16TB.
Obtained from: DragonflyBSD (ecc2e461)
MFC after: 2 weeks
Apple had them at the start but moving them to the end is better for
faster reading and fits better what is done in other FreeBSD headers.
MFC after: 5 days
Sync libarchive with vendor.
Vendor changes (relevant to FreeBSD):
PR #771: Add NFSv4 ACL support to pax and restricted pax
NFSv4 ACL information may now be stored to and restored from tar archives.
ACL must be non-trivial and supported by the underlying filesystem, e.g.
natively by ZFS or by UFS with the NFSv4 ACL enable flag set.
MFC after: 2 weeks
Relnotes: yes
The strategy argument cleanup in r310850 did miss another call to strategy(),
and left it with extra argument.
Reviewed by: allanjude
Approved by: allanjude (mentor)
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D9003
Apparently the libstand dosfs optimization is a bit too optimistic
and did introduce possible memory corruption.
This patch is backing out the bad part and since this results in
dosfs reading full blocks now, we can also remove extra offset argument
from dv_strategy callback.
The analysis of the issue and the backout patch is provided by Mikhail Kupchik.
PR: 214423
Submitted by: Mikhail Kupchik
Reported by: Mikhail Kupchik
Reviewed by: bapt, allanjude
Approved by: allanjude (mentor)
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D8644
Move llvm-objdump from CLANG_EXTRAS to installed by default
We currently install three tools from binutils 2.17.50: as, ld, and
objdump. Work is underway to migrate to a permissively-licensed
tool-chain, with one goal being the retirement of binutils 2.17.50.
LLVM's llvm-objdump is intended to be compatible with GNU objdump
although it is currently missing some options and may have formatting
differences. Enable it by default for testing and further investigation.
It may later be changed to install as /usr/bin/objdump, it becomes a
fully viable replacement.
Reviewed by: emaste
Differential Revision: https://reviews.freebsd.org/D8879
We currently install three tools from binutils 2.17.50: as, ld, and
objdump. Work is underway to migrate to a permissively-licensed
tool-chain, with one goal being the retirement of binutils 2.17.50.
LLVM's llvm-objdump is intended to be compatible with GNU objdump
although it is currently missing some options and may have formatting
differences. Enable it by default for testing and further investigation.
It may later be changed to install as /usr/bin/objdump, it becomes a
fully viable replacement.
Reviewed by: emaste
Differential Revision: https://reviews.freebsd.org/D8879
This argument is not a bitmask of flags, but only accepts a single value.
Fail with EINVAL if an invalid value is passed to 'flag'. Rename the
'flags' argument to getmntinfo(3) to 'mode' as well to match.
This is a followup to r308088.
Reviewed by: kib
MFC after: 1 month
This change consists of two parts:
- allow libkvm to recognize /dev/vmm/* character devices as devices that
provide access to the physical memory of a system (similarly to /dev/fwmem*)
- allow libkvm to recognize that /dev/vmm/* and /dev/fwmem* devices provide
access to the physical memory of live remote systems and, thus, the memory
is writable
As a result, it should be possible to run commands like
$ kgdb -w /path/to/kernel /dev/fwmem0.0
$ kgdb /path/to/kernel /dev/vmm/guest
Reviewed by: kib, jhb
MFC after: 2 weeks
Relnotes: yes
Sponsored by: Panzura
Differential Revision: https://reviews.freebsd.org/D8679
Sync libarchive with vendor.
Vendor bugfixes (relevant to FreeBSD):
PR 846: Spelling fixes
PR 850: Fix issues with reading certain jar files
OSS-Fuzz 286: Bugfix in archive_strncat_l()
Adding %b support to vfprintf for parity with kernel space requires
more discussion/review.
In particular, many parties were concerned over introducing a
non-standard format qualifier to *printf(3) which didn't already
exist in other OSes, e.g. Linux, thus making code which used %b
harder to port to other operating systems.
Requested by: many
