directly to a merged model where only one callout, the next to fire,
is registered.
Instead of callout_reset(9) and callout_stop(9) the new function
tcp_timer_activate() is used which then internally manages the callout.
The single new callout is a mutex callout on inpcb simplifying the
locking a bit.
tcp_timer() is the called function which handles all race conditions
in one place and then dispatches the individual timer functions.
Reviewed by: rwatson (earlier version)
Yukon II generated corrupted TCP checksum for short TCP packets
that's less than 60 bytes in size(e.g. window probe packet, pure ACK
packet etc). Padding the frame with zeros to make the frame minimum
ethernet frame size didn't work at all. Instead of dropping Tx
checksum offload support we calculate TCP checksum with S/W method
when we encounter short TCP frames.
Fortunately it seems that short UDP datagrams appear to be handled
correctly by Yukon II.
While I'm here simplify ethernet/VLAN header size calculation logic.
PR: 111384
software-generated UUID. Store the result in /etc/hostid and use it in
the future. Perform simple UUID format check, as there is a lot of
hardware with broken UUIDs. The check should be improved to also eliminate
fake UUIDs like 00000000-0000-0000-0000-000000000000.
Requested by: many
popular names. Hence:
- comment current index() and rindex() functions, as these serve the same
functionality as, respectively, strchr() and strrchr() from userland;
- add inlined version of strchr() and strrchr(), as we tend to use them more
often;
- remove str[r]chr() definitions from ZFS code;
Reviewed by: pjd
Approved by: cognet (mentor)
front-end if the dpt(4) module is built along with a kernel that
includes eisa(4) or when compiling it stand-alone (logic based on
the corresponding ISA logic in sys/modules/sound/sound/Makefile).
As as side-effect this fixes the stand-alone build of the dpt(4)
module after dpt.h 1.17, dpt_eisa.c 1.22 and dpt_scsi.c 1.55.
Breakage reported by: n_hibma
which can be used to turn off multicast pfsync support, and enable
the transmission of directed PFSYNC (IP protocol: 240) packets to
a specific "sync peer" host.
PR: conf/111225
Submitted by: Bas van Beek <bas@tobin.nl>
Approved by: mtm, mlaier
MFC after: 2 weeks
does not prevent handle_workitem_remove() from recursing into a blocking
version. Add the dirrem to worklist instead of processing it now if this
is the case.
Reported and tested by: kris
Submitted by: tegge
MFC after: 2 weeks
- Allow to shrink ARC down to 16MB (instead of 64MB).
- Set arc_max to 1/2 of kmem_map by default.
- Start freeing things earlier when low memory situation is detected.
- Serialize execution of arc_lowmem().
I decided to setup minimum ZFS memory requirements to 512MB of RAM and 256MB of
kmem_map size. If there is less RAM or kmem_map, a warning will be printed.
World is cruel, be no better. In other words: modern file system requires
modern hardware:)
From ZFS administration guide:
"Currently the minimum amount of memory recommended to install a Solaris
system is 512 Mbytes. However, for good ZFS performance, at least one
Gbyte or more of memory is recommended."
tolerance. This driver allows aggregation of multiple network interfaces as
one virtual interface using a number of different protocols/algorithms.
failover - Sends traffic through the secondary port if the master becomes
inactive.
fec - Supports Cisco Fast EtherChannel.
lacp - Supports the IEEE 802.3ad Link Aggregation Control Protocol
(LACP) and the Marker Protocol.
loadbalance - Static loadbalancing using an outgoing hash.
roundrobin - Distributes outgoing traffic using a round-robin scheduler
through all active ports.
This code was obtained from OpenBSD and this also includes 802.3ad LACP support
from agr(4) in NetBSD.
* Build with or without INET, INET6, or KVM features.
* When built without KVM, the sysctl-based getifmaddrs() function
is used as the back-end for the utility.
* Reflect the fact that FreeBSD now uses the in_multi refcount as
a true refcount.
* Style.
The utility may now be run without super-user privilege, albeit with
a less detailed display, equivalent to that of the soon-to-be-retired
netstat -g host-mode output.
MFC after: 3 weeks
the args for hash32_stre and hash32_strne but there are no consumers in the
base system and openbgpd does not use it which the initial import was for.
Silence on: hackers
