Firmware.
- Add a temporary disklabel header to boot off a NetBSD/sparc64
partition. This file can be deleted when we have got a FCode
bootblock.
The disklabel header was obtained from NetBSD.
- Use unsigned types for the (32-bit) Open Firmware device handles
to avoid sign extension on 64-bit architectures.
- Add a standard type definition for Open Firmware arguments.
What the heck, the OpenBSD version will benefit.
1. Add wx_txint_delay as a tunable (defaults to 5000 now, or ~5ms) and switch
to using delayed TXDW interrupts. Since the chip continues to reload the
TIDV with this value for each descriptor written back, this allows continued
deferral of the actual interrupt until the last packet completes (assuming
that 5ms between multiple packets transmitting is reasonable).
2. Add two other SYSCTL entities:
hw.wx.dump_stats
hw.wx.clear_stats
to be used, hackey hackey, to get the watchdog routine to dump/clear
the current softc statistics.
Usage would be:
sysctl -w hw.wx.dump_stats=UNIT
to cause the current stats to be dumped for UNIT.
3. Attempt to clean up wx_detach routine so we don't panic. Well, things
still panic, but given that the code is just like other NIC drivers,
I suspect it's actually something elsewhere, like e1000phy, that's actually
blowing up.
4. Skip the entire test for runt packets- after doing somet thinking
and experimenting, I believe that the chip only doesn't like it if
the whole frame to xmit is < 16 bytes- each TFD can be some fragment
of that. This should improve performance a chunk because of all of the
(14 byte ETHERHEADER + DATA) mbuf chains.
5. Keep track of total frame length. Try not to xmit an odd byte frame-
this is supposed to get around some dumb Cisco switch problems.
6. On the last packet, also set Interrupt Delay && Report Packet Sent
(see #1 above)
7. Attempt to do xmit garbage collection *first* in order to avoid setting
IFF_OACTIVE if at all possible.
MFC after: 1 week
to working but still needs some work to properly switch the full context
(such as saving the fpu registers, switch stacks, etc.). Also, remove some
dead code that was mixed in.
This significantly reduces the number of TLB shootdowns caused by
vmapbuf/vunmapbuf when performing many large reads from raw disk devices.
Reviewed by: dillon
- vm map entries are not valid after the map has been unlocked.
- An exclusive lock on the map is needed before calling
vm_map_simplify_entry().
Fix cleanup after page wiring failure to unwire all pages that had been
successfully wired before the failure was detected.
Reviewed by: dillon
these chips. There is a new hint, hint.pcm.N.hwvol_config, that can be set
to 1 or 0 to select which pins the buttons are connected to. I'm open to
suggestions on where to document this. Also bump the number of playback
channels up to 4.
MFC after: 3 days
number, portable OpenAFS applications don't have to attempt to determine
what system call number was dynamically allocated. No system call
prototype or implementation is defined.
Requested by: Tom Maher <tardis@watson.org>
- Count the number of this error.
- When the error is detected for the first time, the psm driver will
throw few data bytes (up to entire packet size) and see if it can
get back to sync.
- If the error still persists, the psm driver disable/enable the mouse
and see if it works.
- If the error still persists and the count goes up to 20,
the psm driver reset and reinitialize the mouse. The counter
is reset to zero.
- It also discards an incomplete data packet when the interval
between two consequtive bytes are longer than pre-defined timeout
(2 seconds). The last byte which arrived late will be regarded as
the first byte of a new packet. This is louie's idea.
You may see the following error logs during the above operations:
"psmintr: delay too long; resetting byte count"
"psmintr: out of sync (%04x != %04x)"
"psmintr: discard a byte (%d)"
"psmintr: re-enable the mouse"
"psmintr: reset the mouse"
MFC after: 1 month
kernel map and object in a manner that contigfree() is actually able to
free. Previously contigfree() freed up the KVA space but could not
unwire & free the underlying VM pages due to mismatched pageability between
the map entry and the VM pages.
Submitted by: Thomas Moestl <tmoestl@gmx.net>
Testing by: mark tinguely <tinguely@web.cs.ndsu.nodak.edu>
MFC after: 3 days
would sometimes prevent a dirty page from being cleaned, even when synced,
resulting in the dirty page being re-flushed to disk every 30-60 seconds or
so, forever. The problem is that when the filesystem flushes a page to
its backing file it typically does not clear dirty bits representing areas
of the page that are beyond the file EOF. If the file is also mmap()'d and
a fault is taken, vm_fault (properly, is required to) set the vm_page_t->dirty
bits to VM_PAGE_BITS_ALL. This combination could leave us with an uncleanable,
unfreeable page.
The solution is to have the vnode_pager detect the edge case and manually
clear the dirty bits representing areas beyond the file EOF. The filesystem
does the rest and the page comes up clean after the write completes.
MFC after: 3 days
instruction. Stefan Keller <dres@earth.serd.org> noticed that CPU
identification was broken when compiled with -O2, and tracked it
down to the asm statement, which was storing values into memory
without specifying that memory was modified. He submitted a patch
which added "memory" as a clobber, but I refined it further to
arrive at this version.
MFC after: 3 days
be set. We need to check isr.w before isr.r so that we can correctly
handle a cmpxchg to a copy-on-write page.
This fixes the hang-after-fork problem for dynamically linked programs.
This stops panics on unloading modules which define their own sysctl sets.
However, this also removes the protection against somebody actually
defining a static sysctl with an oid in the range of the dynamic ones,
which would break badly if there is already a dynamic sysctl with
the requested oid.
Apparently, the algorithm for removing sysctl sets needs a bit more work.
For the present, the panic I introduced only leads to Bad Things (tm).
Submitted by: many users of -current :(
Pointy hat to: roam (myself) for not testing rev. 1.112 enough.
