After this change, when component is disconnected because of an I/O error,
it will not be connected and synchronized automatically, it will be logged
as broken and skipped. Autosynchronization can occur, when component is
disconnected (on orphan event) and connected again - there were no I/O
error, so there is no need to not connected the component, but when there were
writes while it wasn't connected, it will be synchronized.
This fix cases, when component is disconnected because of I/O error and can be
connected again and again.
- Bump version number.
- Implement backward compatibility mechanism. After this change when metadata in
old version is detected, it is automatically upgraded to the new (current)
version.
because we know it then and we need it when inserting a component which
wasn't destroyed while device was running.
Reported by: Michael Handler <handler@grendel.net>
MFC after: 1 week
that the events queue is empty. In other case we're able to hit the race
where for example da0s1 is tasted by some other class, which means that
da0 is open with exclusive bit set, which means that we can't open da0
for writing if it is our component.
Reported by: Attila Nagy <bra@fsn.hu> (and somebody else sometime ago,
but I cannot find who it was)
but it is possible:
1. Read data from good component for synchronization.
2. Write data to the same area.
3. Write synchronization data, which are now stale.
Found by: tegge (for gmirror)
Actually, it can even cause some problems, because GEOM requires sectorsize
to be more than 0 on first access, not on provider creation, so we can skip
valid providers by doing this check here.
Reported by: Divacky Roman <xdivac02@stud.fit.vutbr.cz>
Sven Willenberger <sven@dmv.com>
verification of regular data when device is in complete state.
On verification error, EIO error is returned for the bio and sysctl
kern.geom.raid3.stat.parity_mismatch is increased.
Suggested by: phk
as well, even if device is in complete state.
I observe 40% of speed-up with this option for random read operations,
but slowdown for sequential reads.
Basically, without this option reading from a RAID3 device built from 5
components (c0-c4) looks like this:
Request no. Used components
1 c0+c1+c2+c3
2 c0+c1+c2+c3
3 c0+c1+c2+c3
With the new feature:
Request no. Used components
1 c0+c1+c2+c3
2 (c1^c2^c3^c4)+c1+c2+c3
3 c0+(c0^c2^c3^c4)+c2+c3
4 c0+c1+(c0^c1^c3^c4)+c3
5 c0+c1+c2+(c0^c1^c2^c4)
6 c0+c1+c2+c3
[...]
