- Remove unused kse fields from struct proc.
- Group remaining fields and #ifdef KSE them.
- Move some kern_kse.c only prototypes out of proc and into kern_kse.
Discussed with: Julian
- Add a count of exiting threads, p_exitthreads, to struct proc.
- Increment p_exithreads when we set the deadthread in thread_exit().
- When we thread_stash() a deadthread use an atomic to drop the count.
- Spin until the p_exithreads count reaches 0 in thread_wait().
- Lock the last exiting thread momentarily to be certain that it has
exited cpu_throw().
- Restructure thread_wait(). It does not need a loop as there will only
ever be one thread.
Tested by: moose@opera.com
Reported by: kris, moose@opera.com
some cases, move to priv_check() if it was an operation on a thread and
no other flags were present.
Eliminate caller-side jail exception checking (also now-unused); jail
privilege exception code now goes solely in kern_jail.c.
We can't yet eliminate suser() due to some cases in the KAME code where
a privilege check is performed and then used in many different deferred
paths. Do, however, move those prototypes to priv.h.
Reviewed by: csjp
Obtained from: TrustedBSD Project
o major overhaul of the way channels are handled: channels are now
fully enumerated and uniquely identify the operating characteristics;
these changes are visible to user applications which require changes
o make scanning support independent of the state machine to enable
background scanning and roaming
o move scanning support into loadable modules based on the operating
mode to enable different policies and reduce the memory footprint
on systems w/ constrained resources
o add background scanning in station mode (no support for adhoc/ibss
mode yet)
o significantly speedup sta mode scanning with a variety of techniques
o add roaming support when background scanning is supported; for now
we use a simple algorithm to trigger a roam: we threshold the rssi
and tx rate, if either drops too low we try to roam to a new ap
o add tx fragmentation support
o add first cut at 802.11n support: this code works with forthcoming
drivers but is incomplete; it's included now to establish a baseline
for other drivers to be developed and for user applications
o adjust max_linkhdr et. al. to reflect 802.11 requirements; this eliminates
prepending mbufs for traffic generated locally
o add support for Atheros protocol extensions; mainly the fast frames
encapsulation (note this can be used with any card that can tx+rx
large frames correctly)
o add sta support for ap's that beacon both WPA1+2 support
o change all data types from bsd-style to posix-style
o propagate noise floor data from drivers to net80211 and on to user apps
o correct various issues in the sta mode state machine related to handling
authentication and association failures
o enable the addition of sta mode power save support for drivers that need
net80211 support (not in this commit)
o remove old WI compatibility ioctls (wicontrol is officially dead)
o change the data structures returned for get sta info and get scan
results so future additions will not break user apps
o fixed tx rate is now maintained internally as an ieee rate and not an
index into the rate set; this needs to be extended to deal with
multi-mode operation
o add extended channel specifications to radiotap to enable 11n sniffing
Drivers:
o ath: add support for bg scanning, tx fragmentation, fast frames,
dynamic turbo (lightly tested), 11n (sniffing only and needs
new hal)
o awi: compile tested only
o ndis: lightly tested
o ipw: lightly tested
o iwi: add support for bg scanning (well tested but may have some
rough edges)
o ral, ural, rum: add suppoort for bg scanning, calibrate rssi data
o wi: lightly tested
This work is based on contributions by Atheros, kmacy, sephe, thompsa,
mlaier, kevlo, and others. Much of the scanning work was supported by
Atheros. The 11n work was supported by Marvell.
In particular:
- Add an explicative table for locking of struct vmmeter members
- Apply new rules for some of those members
- Remove some unuseful comments
Heavily reviewed by: alc, bde, jeff
Approved by: jeff (mentor)
This patch fixes places where they should be called atomically changing
their locking requirements (both assume per-proc spinlock held) and
introducing rufetchcalc which wrappers both calls to be performed in
atomic way.
Reviewed by: jeff
Approved by: jeff (mentor)
- Unsafeness on ruadd() in thread_exit()
- Unatomicity of thread_exiit() in the exit1() operations
This patch addresses these problems allocating p_fd as part of the
process and modifying the way it is accessed.
A small chunk of this patch, resolves a race about p_state in kern_wait(),
since we have to be sure about the zombif-ing process.
Submitted by: jeff
Approved by: jeff (mentor)
embedded storage in struct ucred. This allows audit state to be cached
with the thread, avoiding locking operations with each system call, and
makes it available in asynchronous execution contexts, such as deep in
the network stack or VFS.
Reviewed by: csjp
Approved by: re (kensmith)
Obtained from: TrustedBSD Project
- Use thread_lock() rather than sched_lock for per-thread scheduling
sychronization.
- Use the per-process spinlock rather than the sched_lock for per-process
scheduling synchronization.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Add new spinlocks to support thread_lock() and adjust ordering.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Attempt to return the ttyinfo() selection algorithm to something sane
as it has been broken and disabled for some time. Adapt this algorithm
in such a way that it does not conflict with per-cpu scheduler locking.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Use a global umtx spinlock to protect the sleep queues now that there
is no global scheduler lock.
- Use thread_lock() to protect thread state.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Use thread_lock() rather than sched_lock for per-thread scheduling
sychronization.
- Use the per-process spinlock rather than the sched_lock for per-process
scheduling synchronization.
- Use a global kse spinlock to protect upcall and thread assignment. The
per-process spinlock can not be used because this lock must be acquired
via mi_switch() where we already hold a thread lock. The kse spinlock
is a leaf lock ordered after the process and thread spinlocks.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Use thread_lock() rather than sched_lock for per-thread scheduling
sychronization.
- Use the per-process spinlock rather than the sched_lock for per-process
scheduling synchronization.
- Replace the tail-end of fork_exit() with a scheduler specific routine
which can do the appropriate lock manipulations.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Protect the cp_time tick counts with atomics instead of a global lock.
There will only be one atomic per tick and this allows all processors
to execute softclock concurrently.
- In softclock, protect access to rusage and td_*tick data with the
thread_lock(), expanding the scope of the thread lock over the whole
function.
- Do some creative re-arranging in hardclock() to avoid excess locking.
- Protect the p_timer fields with the per-process spinlock.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Use thread_lock() rather than sched_lock for per-thread scheduling
sychronization.
- Use the per-process spinlock rather than the sched_lock for per-process
scheduling synchronization.
- Move some common code into thread_suspend_switch() to handle the
mechanics of suspending a thread. The locking here is incredibly
convoluted and should be simplified.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Add a per-turnstile spinlock to solve potential priority propagation
deadlocks that are possible with thread_lock().
- The turnstile lock order is defined as the exact opposite of the
lock order used with the sleep locks they represent. This allows us
to walk in reverse order in priority_propagate and this is the only
place we wish to multiply acquire turnstile locks.
- Use the turnstile_chain lock to protect assigning mutexes to turnstiles.
- Change the turnstile interface to pass back turnstile pointers to the
consumers. This allows us to reduce some locking and makes it easier
to cancel turnstile assignment while the turnstile chain lock is held.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Adapt sleepqueues to the new thread_lock() mechanism.
- Delay assigning the sleep queue spinlock as the thread lock until after
we've checked for signals. It is illegal for a thread to return in
mi_switch() with any lock assigned to td_lock other than the scheduler
locks.
- Change sleepq_catch_signals() to do the switch if necessary to simplify
the callers.
- Simplify timeout handling now that locking a sleeping thread has the
side-effect of locking the sleepqueue. Some previous races are no
longer possible.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Move all scheduler locking into the schedulers utilizing a technique
similar to solaris's container locking.
- A per-process spinlock is now used to protect the queue of threads,
thread count, suspension count, p_sflags, and other process
related scheduling fields.
- The new thread lock is actually a pointer to a spinlock for the
container that the thread is currently owned by. The container may
be a turnstile, sleepqueue, or run queue.
- thread_lock() is now used to protect access to thread related scheduling
fields. thread_unlock() unlocks the lock and thread_set_lock()
implements the transition from one lock to another.
- A new "blocked_lock" is used in cases where it is not safe to hold the
actual thread's lock yet we must prevent access to the thread.
- sched_throw() and sched_fork_exit() are introduced to allow the
schedulers to fix-up locking at these points.
- Add some minor infrastructure for optionally exporting scheduler
statistics that were invaluable in solving performance problems with
this patch. Generally these statistics allow you to differentiate
between different causes of context switches.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
Now, we assume no more sched_lock protection for some of them and use the
distribuited loads method for vmmeter (distribuited through CPUs).
Reviewed by: alc, bde
Approved by: jeff (mentor)
- Rename PCPU_LAZY_INC into PCPU_INC
- Add the PCPU_ADD interface which just does an add on the pcpu member
given a specific value.
Note that for most architectures PCPU_INC and PCPU_ADD are not safe.
This is a point that needs some discussions/work in the next days.
Reviewed by: alc, bde
Approved by: jeff (mentor)
sysctl_handle_int is not sizeof the int type you want to export.
The type must always be an int or an unsigned int.
Remove the instances where a sizeof(variable) is passed to stop
people accidently cut and pasting these examples.
In a few places this was sysctl_handle_int was being used on 64 bit
types, which would truncate the value to be exported. In these
cases use sysctl_handle_quad to export them and change the format
to Q so that sysctl(1) can still print them.
argument from being file descriptor index into the pointer to struct file:
part 2. Convert calls missed in the first big commit.
Noted by: rwatson
Pointy hat to: kib
td_ru. This removes the requirement for per-process synchronization in
statclock() and mi_switch(). This was previously supported by
sched_lock which is going away. All modifications to rusage are now
done in the context of the owning thread. reads proceed without locks.
- Aggregate exiting threads rusage in thread_exit() such that the exiting
thread's rusage is not lost.
- Provide a new routine, rufetch() to fetch an aggregate of all rusage
structures from all threads in a process. This routine must be used
in any place requiring a rusage from a process prior to it's exit. The
exited process's rusage is still available via p_ru.
- Aggregate tick statistics only on demand via rufetch() or when a thread
exits. Tick statistics are kept in the thread and protected by sched_lock
until it exits.
Initial patch by: attilio
Reviewed by: attilio, bde (some objections), arch (mostly silent)
Probabilly, a general approach is not the better solution here, so we should
solve the sched_lock protection problems separately.
Requested by: alc
Approved by: jeff (mentor)
