- Make sure that when you kick the streams you add correctly
using a 16 bit unsigned.
- Make sure when sending out you allow FWD-TSN to skip over
and list the ACKED chunks in the stream/seq list (so the
rcv will kick the stream)
MFC after: 3 days
- Slide the map at the proper place.
- Mark the bits in the nr_array ONLY if there
is no marking.
- When generating a FWD-TSN we allow us to skip past
ACKED chunks too.
MFC after: 1 weeks
user sets up a socket to a server sends data and closes
the socket before the server has called accept(). It used
to NOT work at all. Now we add a flag to the assoc and
defer assoc cleanup so that the accept will suceed.
"Whitspace" churn after the VIMAGE/VNET whirls.
Remove the need for some "init" functions within the network
stack, like pim6_init(), icmp_init() or significantly shorten
others like ip6_init() and nd6_init(), using static initialization
again where possible and formerly missed.
Move (most) variables back to the place they used to be before the
container structs and VIMAGE_GLOABLS (before r185088) and try to
reduce the diff to stable/7 and earlier as good as possible,
to help out-of-tree consumers to update from 6.x or 7.x to 8 or 9.
This also removes some header file pollution for putatively
static global variables.
Revert VIMAGE specific changes in ipfilter::ip_auth.c, that are
no longer needed.
Reviewed by: jhb
Discussed with: rwatson
Sponsored by: The FreeBSD Foundation
Sponsored by: CK Software GmbH
MFC after: 6 days
that we allow all possible jail IPs as source address rather than
forcing the "primary". While IPv6 naturally has source address
selection, for legacy IP we do not go through the pain in case
IP_HDRINCL was not set. People should bind(2) for that.
This will, for example, allow ping(|6) -S to work correctly for
non-primary addresses.
Reported by: (ten 211.ru)
Tested by: (ten 211.ru)
MFC after: 4 days
by mrinfo and mtrace, was dropped by the IGMP TTL check. IGMP control
traffic must always have a TTL of 1.
Submitted by: Matthew Luckie
MFC after: 3 days
* Fix delaying of SACK by taking out old optimization code
which does not optimize anymore.
* Fix fast retransmission of chunks abandoned by the
"number of retransmissions" policy.
MFC after: 3 days.
prevented the link-layer entry from being freed.
In both in.c and in6.c (though that code path seems to be basically dead)
plug a reference leak in case of a pending callout being drained.
In if_ether.c consistently add a reference before resetting the callout
and in case we canceled a pending one remove the reference for that.
In the final case in arptimer, before freeing the expired entry, remove
the reference again and explicitly call callout_stop() to clear the active
flag.
In nd6.c:nd6_free() we are only ever called from the callout function and
thus need to remove the reference there as well before calling into
llentry_free().
In if_llatbl.c when freeing entire tables make sure that in case we cancel
a pending callout to remove the reference as well.
Reviewed by: qingli (earlier version)
MFC after: 10 days
Problem observed, patch tested by: simon on ipv6gw.f.o,
Christian Kratzer (ck cksoft.de),
Evgenii Davidov (dado korolev-net.ru)
PR: kern/144564
Configurations still affected: with options FLOWTABLE
This adds the explicit include (so far probably included through one of the
few "hidden" includes in other header files) for vnet.h and adds a cast
to unbreak LINT-VIMAGE.
IPv4 addresses can and do change during normal operation. Testing by
pfSense developers exposed an issue where OpenOSPFD was using the IPv4
address to leave the OSPF link-scope multicast groups on a dynamic
OpenVPN tun interface, rather than using RFC 3678 with the interface
index, which won't be raced when the interface's addresses change.
In inp_join_group():
If we are already a member of an ASM group, and IP_ADD_MEMBERSHIP or
MCAST_JOIN_GROUP ioctls are re-issued, return EADDRINUSE as per the
legacy 4.4BSD multicast API. This bends RFC 3678 slightly, but does
not violate POLA for apps using the old API.
It also stops us falling through to kicking IGMP state transactions
in what is otherwise a no-op case.
[This has already been dealt with in HEAD, but make it explicit before
we MFC the change to 8.]
In inp_leave_group():
Fix a bogus conditional.
Move the ifp null check to ioctls MCAST_LEAVE* in the switch..case
where it actually belongs.
If an interface was specified, by primary IPv4 address, for ioctl
IP_DROP_MEMBERSHIP or MCAST_LEAVE_GROUP (an ASM full leave operation),
then and only then should we look up the ifp from the IPv4 address in
mreqs.imr_interface.
If not, we fall through to imo_match_group() as before, but only in
the IP_DROP_MEMBERSHIP case.
With these changes, the legacy 4.4BSD multicast API idempotence should
be mostly preserved in the SSM enabled IPv4 stack.
Found by: ermal (with pfSense)
MFC after: 3 days
compiled with "options VIMAGE".
As it is now, there is still a single instance of the pipes,
and it is only usable from vnet0 (the main instance).
Trying to use a pipe from a different vimage does not crash
the system as it did before, but the traffic coming out from
the pipe goes to the wrong place, and i still need to
figure out where.
Support for per-vimage pipes is almost there (just a matter of
uncommenting the VNET_* definitions for dn_cfg, plus putting into
the structure the remaining static variables), however i need
first to figure out how init/uninit work, and also to understand
where packets are ending up on exit from a pipe.
In summary: vimage support for dummynet is not complete yet,
but we are getting there.
* Fix handling of mapping arrays when draining mbufs or processing
FORWARD-TSN chunks.
* Cleanup code (no duplicate code anymore for SACKs and NR-SACKs).
Part of this code was developed together with rrs.
MFC after: 2 weeks.
This patch has two fixes for potential kernel panics (one wrong
index, one access to the wrong lock) and two fixes to wrong logic
in a conditional. The potential panics are also on stable/8,
so I am going to MFC the fix quickly.
enabled. Basically most of the operations were incorrect causing
bad sacks when you enabled nr-sack. The fixes range across
4 files and unifiy most of the processing so that we only test
nr_sack flags to decide which type of sack to generate.
Optimization left for this is to combine the sack generation
code and make it capable of generating either sack thus shrinking
out a routine.
Reviewed by: tuexen@freebsd.org
mapping_array expansion would break. Basically
once we expanded the array we no longer had both
mapping arrays in sync which the sack processing code depends on.
This would mean we were randomly referring to memory that was probably
not there. This mostly just gave us bad sack results going back to the peer.
If INVARIENTS was on of course we would hit the panic routine in the sack_check
call.
We also add a print routine for the place where one would panic in
invarients so one can see what the main mapping array holds.
Reviewed by: tuexen@freebsd.org
MFC after: 2 weeks
- increase flow cleaning frequency and decrease flow caching time
when near the flow limit
- stop allocating new flows when within 3% of maxflows don't start
allocating again until below 12.5%
MFC after: 7 days
dscp as a search key in table lookups;
+ (re)implement a sysctl variable to control the expire frequency of
pipes and queues when they become empty;
+ add 'queue number' as optional part of the flow_id. This can be
enabled with the command
queue X config mask queue ...
and makes it possible to support priority-based schedulers, where
packets should be grouped according to the priority and not some
fields in the 5-tuple.
This is implemented as follows:
- redefine a field in the ipfw_flow_id (in sys/netinet/ip_fw.h) but
without changing the size or shape of the structure, so there are
no ABI changes. On passing, also document how other fields are
used, and remove some useless assignments in ip_fw2.c
- implement small changes in the userland code to set/read the field;
- revise the functions in ip_dummynet.c to manipulate masks so they
also handle the additional field;
There are no ABI changes in this commit.
their calling contexts in {IP divert, raw IP sockets, TCP, UDP} and
create new helper functions: in_pcbinfo_init() and in_pcbinfo_destroy()
to do this work in a central spot. As inpcbinfo becomes more complex
due to ongoing work to add connection groups, this will reduce code
duplication.
MFC after: 1 month
Reviewed by: bz
Sponsored by: Juniper Networks
have the delayed function take an argument as to the offset
to the SCTP header. This allows it to work for V4 and V6.
This of course means changing all callers of the function
to either pass the header len, if they have it, or create
it (ip_hl << 2 or sizeof(ip6_hdr)).
PR: 144529
MFC after: 2 weeks
- add a name argument to flowtable_alloc for printing with ddb commands
- extend ddb commands to print destination address or 4-tuples
- don't parse ports in ulp header if FL_HASH_ALL is not passed
- add kern_flowtable_insert to enable more generic use of flowtable
(e.g. system calls for adding entries)
- don't hash loopback addresses
- cleanup whitespace
- keep statistics per-cpu for per-cpu flowtables to avoid cache line contention
- add sysctls to accumulate stats and report aggregate
MFC after: 7 days
allow for connection load balancing across interfaces. Currently
the address alias handling method is colliding with the ECMP code.
For example, when two interfaces are configured on the same prefix,
only one prefix route is installed. So connection load balancing
among the available interfaces is not possible.
The other advantage of ECMP is for failover. The issue with the
current code, is that the interface link-state is not reflected
in the route entry. For example, if there are two interfaces on
the same prefix, the cable on one interface is unplugged, new and
existing connections should switch over to the other interface.
This is not done today and packets go into a black hole.
Also, there is a small bug in the kernel where deleting ECMP routes
in the userland will always return an error even though the command
is successfully executed.
MFC after: 5 days
