Don't count busy buffers before the initial call to sync() and
don't skip the initial sync() if no busy buffers were called.
Always call sync() at least once if syncing is requested. This
defers the "Syncing disks, buffers remaining..." message until
after the initial sync() call and the first count of busy
buffers. This backs out changes in kern_shutdown 1.162.
Print a different message when there are no busy buffers after the
initial sync(), which is now the expected situation.
Print an additional message when syncing has completed successfully
in the unusual situation where the work of syncing was done by
boot().
Uppercase one message to make it consistent with all of the other
kernel shutdown messages.
Discussed with: bde (in a much earlier form, prior to 1.162)
Reviewed by: njl (in an earlier form)
to specify an alternative padding character when using a conversion
mode, or when using noerror with sync and an input error occurs. This
facilities reading old and error-prone media by allowing the user to
more effectively mark error blocks in the output stream.
- Remove reference to the NOTES section in the entry for Sun DMFE,
since ot doesn't work well with the auto generated Hardware Notes. [1]
OK'ed by: marius [1]
logical CPUs on a system to be used as a dedicated watchdog to cause a
drop to the debugger and/or generate an NMI to the boot processor if
the kernel ceases to respond. A sysctl enables the watchdog running
out of the processor's idle thread; a callout is launched to reset a
timer in the watchdog. If the callout fails to reset the timer for ten
seconds, the watchdog will fire. The sysctl allows you to select which
CPU will run the watchdog.
A sample "debug.leak_schedlock" is included, which causes a sysctl to
spin holding sched_lock in order to trigger the watchdog. On my Xeons,
the watchdog is able to detect this failure mode and break into the
debugger, which cannot otherwise be done without an NMI button.
This option does not currently work with sched_ule due to ule's push
notion of scheduling, similar to machdep.hlt_logical_cpus failing to
work with that scheduler.
On face value, this might seem somewhat inefficient, but there are a
lot of dual-processor Xeons with HTT around, so using one as a watchdog
for testing is not as inefficient as one might fear.
of PS_STRINGS. This is a no-op at present, but it will be needed when
running 32-bit Linux binaries on amd64 to ensure PS_STRINGS is in
addressable memory.
Without this, the device cannot detect the end of ethernet packets
whose size is a multiple of the USB packat size.
PR: kern/70474
Submitted by: Andrew Thompson <andy@fud.org.nz>
MFC after: 1 week
a more complete subsystem, and removes the knowlege of how things are
implemented from the drivers. Include locking around filter ops, so a
module like aio will know when not to be unloaded if there are outstanding
knotes using it's filter ops.
Currently, it uses the MTX_DUPOK even though it is not always safe to
aquire duplicate locks. Witness currently doesn't support the ability
to discover if a dup lock is ok (in some cases).
Reviewed by: green, rwatson (both earlier versions)
with the currently running kernel image. Otherwise, one of -c, -n or
-r is expected for working on a particular core file (-c), working
on a saved dump (-n) or working remotely (-r). When working on a
saved dump, a kernel may be omitted.
For a remote debugging session (-r), kgdb(1) will use the specified
device.
attempt to IPI other cpus when entering the debugger in order to stop
them while in the debugger. The default remains to issue the stop;
however, that can result in a hang if another cpu has interrupts disabled
and is spinning, since the IPI won't be received and the KDB will wait
indefinitely. We probably need to add a timeout, but this is a useful
stopgap in the mean time.
Reviewed by: marcel
and that can be used as an identify function for all kinds of busses on a
certain platform. Expect for sparc64 these are only stubs right now. [1]
- For sparc64, add code to its uart_cpu_identify() for registering the on-
board ISA UARTs and their resources based on information obtained from
Open Firmware.
It would be better if this would be done in the OFW ISA code. However, due
to the common FreeBSD ISA code and PNP-IDs not always being present in the
properties of the ISA nodes there seems to be no good way to implement that.
Therefore special casing UARTs as the sole really relevant ISA devices on
sparc64 seemed reasonable. [2]
Approved by: marcel
Discussed with: marcel [1], tmm [2]
Tested by: make universe
without Open Firmware directly instead of using OF_getetheraddr(). This is
a bit painful though, as the MAC address is contained in the NA field of
the VPD of the EBus bridge, which is is another function of the same chip.
To make it worse, the VPD of the EBus bridge can't be accessed via the PCI
capability pointer but has to be digged out from the Boot PROM and has a
non-standard format.
The PCI VPD struct and macros used here should be part of the FreeBSD PCI
code nevertheless.
Approved by: tmm
Based on: NetBSD
Tested with: Sun X1032A (hme(4)-isp(4)-combo card) on alpha and i386
o reprobe children when a new driver is added to uhub
o fix the usbd_probe_and_attach to set the ivars to a malloc'd area, as well
as freeing the ivars on child destruction.
o Don't delete children that don't attach. Evidentally, the need to do this
is a common misconception.
o minor formatting foo that may violate style(9) at the moment, but keeps the
diffs against my p4 tree smaller.
This does not solve the ugen gobbling things up problem, but the fixes
I have for that expose bugs in other parts of the tree...
- Add a NOTES section with information regarding the "local-mac-address?"
system configuration variable on sparc64 and add a reference to eeprom(8)
for using it. Dump document date for this.
- In dc.4, add the on-board DM9102A on Sun Netra X1 and Sun Fire V100 to
the list of known working devices.
variable. If set to "true" OF_getetheraddr() will now return the unique
MAC address stored in the "local-mac-address" property of the device's
OFW node if present and the host address/system default MAC address if
the node doesn't doesn't have such a property. If set to "false" the
host address will be returned for all devices like before this change.
This brings the behaviour of device drivers for NICs with OFW support/
FCode, i.e. dc(4) for on-board DM9102A on Sun machines, gem(4) and hme(4),
regarding "local-mac-address?" in line with NetBSD and Solaris.
The man pages of the respective drivers will be updated separately to
reflect this change.
- Remove OF_getetheraddr2() which was used as a stopgap in dc(4). Its
functionality is now part of OF_getetheraddr().
threads consuming the result of pfind() will not need to check for a NULL
credential pointer or other signs of an incompletely created process.
However, this also means that pfind() cannot be used to test for the
existence or find such a process. Annotate pfind() to indicate that this
is the case. A review of curent consumers seems to indicate that this is
not a problem for any of them. This closes a number of race conditions
that could result in NULL pointer dereferences and related failure modes.
Other related races continue to exist, especially during iteration of the
allproc list without due caution.
Discussed with: tjr, green
have already done this, so I have styled the patch on their work:
1) introduce a ip_newid() static inline function that checks
the sysctl and then decides if it should return a sequential
or random IP ID.
2) named the sysctl net.inet.ip.random_id
3) IPv6 flow IDs and fragment IDs are now always random.
Flow IDs and frag IDs are significantly less common in the
IPv6 world (ie. rarely generated per-packet), so there should
be smaller performance concerns.
The sysctl defaults to 0 (sequential IP IDs).
Reviewed by: andre, silby, mlaier, ume
Based on: NetBSD
MFC after: 2 months
Only the actual loopback address should be declared passive, other
addresses are very likely to be desirable to announce.
Check for IFF_LOOPBACK instead of IFF_PASSIVE to determine if we have
an unknown interface type.
