to send datagrams from an unconnected socket, we used to first block
input, then connect the socket to the sendmsg/sendto destination,
send the datagram, and finally disconnect the socket and unblock
input.
We now use in_pcbconnect_setup() to check if a connect() would have
succeeded, but we never record the connection in the PCB (local
anonymous port allocation is still recorded, though). The result
from in_pcbconnect_setup() authorises the sending of the datagram
and selects the local address and port to use, so we just construct
the header and call ip_output().
Discussed on: -net
Approved by: re
configuration stuff as well as conditional code in the IPv4 and IPv6
areas. Everything is conditional on FAST_IPSEC which is mutually
exclusive with IPSEC (KAME IPsec implmentation).
As noted previously, don't use FAST_IPSEC with INET6 at the moment.
Reviewed by: KAME, rwatson
Approved by: silence
Supported by: Vernier Networks
o instead of a list of mbufs use a list of m_tag structures a la openbsd
o for netgraph et. al. extend the stock openbsd m_tag to include a 32-bit
ABI/module number cookie
o for openbsd compatibility define a well-known cookie MTAG_ABI_COMPAT and
use this in defining openbsd-compatible m_tag_find and m_tag_get routines
o rewrite KAME use of aux mbufs in terms of packet tags
o eliminate the most heavily used aux mbufs by adding an additional struct
inpcb parameter to ip_output and ip6_output to allow the IPsec code to
locate the security policy to apply to outbound packets
o bump __FreeBSD_version so code can be conditionalized
o fixup ipfilter's call to ip_output based on __FreeBSD_version
Reviewed by: julian, luigi (silent), -arch, -net, darren
Approved by: julian, silence from everyone else
Obtained from: openbsd (mostly)
MFC after: 1 month
we can use the names _receive() and _send() for the receive() and send()
checks. Rename related constants, policy implementations, etc.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
kernel access control.
Add MAC support for the UDP protocol. Invoke appropriate MAC entry
points to label packets that are generated by local UDP sockets,
and to authorize delivery of mbufs to local sockets both in the
multicast/broadcast case and the unicast case.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
SYSCTL_OUT() from blocking while locks are held. This should
only be done when it would be inconvenient to make a temporary copy of
the data and defer calling SYSCTL_OUT() until after the locks are
released.
indication of whether this happenned so the calling function
knows whether or not to unlock the pcb.
Submitted by: Jennifer Yang (yangjihui@yahoo.com)
Bug reported by: Sid Carter (sidcarter@symonds.net)
o Add a mutex (sb_mtx) to struct sockbuf. This protects the data in a
socket buffer. The mutex in the receive buffer also protects the data
in struct socket.
o Determine the lock strategy for each members in struct socket.
o Lock down the following members:
- so_count
- so_options
- so_linger
- so_state
o Remove *_locked() socket APIs. Make the following socket APIs
touching the members above now require a locked socket:
- sodisconnect()
- soisconnected()
- soisconnecting()
- soisdisconnected()
- soisdisconnecting()
- sofree()
- soref()
- sorele()
- sorwakeup()
- sotryfree()
- sowakeup()
- sowwakeup()
Reviewed by: alfred
Requested by: bde
Since locking sigio_lock is usually followed by calling pgsigio(),
move the declaration of sigio_lock and the definitions of SIGIO_*() to
sys/signalvar.h.
While I am here, sort include files alphabetically, where possible.
general cleanup of the API. The entire API now consists of two functions
similar to the pre-KSE API. The suser() function takes a thread pointer
as its only argument. The td_ucred member of this thread must be valid
so the only valid thread pointers are curthread and a few kernel threads
such as thread0. The suser_cred() function takes a pointer to a struct
ucred as its first argument and an integer flag as its second argument.
The flag is currently only used for the PRISON_ROOT flag.
Discussed on: smp@
Move the network code from using cr_cansee() to check whether a
socket is visible to a requesting credential to using a new
function, cr_canseesocket(), which accepts a subject credential
and object socket. Implement cr_canseesocket() so that it does a
prison check, a uid check, and add a comment where shortly a MAC
hook will go. This will allow MAC policies to seperately
instrument the visibility of sockets from the visibility of
processes.
Obtained from: TrustedBSD Project
Sponsored by: DARPA, NAI Labs
spares (the size of the field was changed from u_short to u_int to
reflect what it really ends up being). Accordingly, change users of
xucred to set and check this field as appropriate. In the kernel,
this is being done inside the new cru2x() routine which takes a
`struct ucred' and fills out a `struct xucred' according to the
former. This also has the pleasant sideaffect of removing some
duplicate code.
Reviewed by: rwatson
sysctl_req', which describes in-progress sysctl requests. This permits
sysctl handlers to have access to the current thread, permitting work
on implementing td->td_ucred, migration of suser() to using struct
thread to derive the appropriate ucred, and allowing struct thread to be
passed down to other code, such as network code where td is not currently
available (and curproc is used).
o Note: netncp and netsmb are not updated to reflect this change, as they
are not currently KSE-adapted.
Reviewed by: julian
Obtained from: TrustedBSD Project
is calculated. this caused some trouble in the code which the ip header
is not modified. for example, inbound policy lookup failed.
Obtained from: KAME
MFC after: 1 week
a single kern.security.seeotheruids_permitted, describes as:
"Unprivileged processes may see subjects/objects with different real uid"
NOTE: kern.ps_showallprocs exists in -STABLE, and therefore there is
an API change. kern.ipc.showallsockets does not.
- Check kern.security.seeotheruids_permitted in cr_cansee().
- Replace visibility calls to socheckuid() with cr_cansee() (retain
the change to socheckuid() in ipfw, where it is used for rule-matching).
- Remove prison_unpcb() and make use of cr_cansee() against the UNIX
domain socket credential instead of comparing root vnodes for the
UDS and the process. This allows multiple jails to share the same
chroot() and not see each others UNIX domain sockets.
- Remove unused socheckproc().
Now that cr_cansee() is used universally for socket visibility, a variety
of policies are more consistently enforced, including uid-based
restrictions and jail-based restrictions. This also better-supports
the introduction of additional MAC models.
Reviewed by: ps, billf
Obtained from: TrustedBSD Project
kern.ipc.showallsockets is set to 0.
Submitted by: billf (with modifications by me)
Inspired by: Dave McKay (aka pm aka Packet Magnet)
Reviewed by: peter
MFC after: 2 weeks
Note ALL MODULES MUST BE RECOMPILED
make the kernel aware that there are smaller units of scheduling than the
process. (but only allow one thread per process at this time).
This is functionally equivalent to teh previousl -current except
that there is a thread associated with each process.
Sorry john! (your next MFC will be a doosie!)
Reviewed by: peter@freebsd.org, dillon@freebsd.org
X-MFC after: ha ha ha ha
making pcbs available to the outside world. otherwise, we will see
inpcb without ipsec security policy attached (-> panic() in ipsec.c).
Obtained from: KAME
MFC after: 3 days
only do getcred calls for sockets which were created in the same jail.
This should allow the ident to work in a reasonable way within jails.
PR: 28107
Approved by: des, rwatson
This work was based on kame-20010528-freebsd43-snap.tgz and some
critical problem after the snap was out were fixed.
There are many many changes since last KAME merge.
TODO:
- The definitions of SADB_* in sys/net/pfkeyv2.h are still different
from RFC2407/IANA assignment because of binary compatibility
issue. It should be fixed under 5-CURRENT.
- ip6po_m member of struct ip6_pktopts is no longer used. But, it
is still there because of binary compatibility issue. It should
be removed under 5-CURRENT.
Reviewed by: itojun
Obtained from: KAME
MFC after: 3 weeks
For TCP, verify that the sequence number in the ICMP packet falls within
the tcp receive window before performing any actions indicated by the
icmp packet.
Clean up some layering violations (access to tcp internals from in_pcb)
and 1.84 of src/sys/netinet/udp_usrreq.c
The changes broken down:
- remove 0 as a wildcard for addresses and port numbers in
src/sys/netinet/in_pcb.c:in_pcbnotify()
- add src/sys/netinet/in_pcb.c:in_pcbnotifyall() used to notify
all sessions with the specific remote address.
- change
- src/sys/netinet/udp_usrreq.c:udp_ctlinput()
- src/sys/netinet/tcp_subr.c:tcp_ctlinput()
to use in_pcbnotifyall() to notify multiple sessions, instead of
using in_pcbnotify() with 0 as src address and as port numbers.
- remove check for src port == 0 in
- src/sys/netinet/tcp_subr.c:tcp_ctlinput()
- src/sys/netinet/udp_usrreq.c:udp_ctlinput()
as they are no longer needed.
- move handling of redirects and host dead from in_pcbnotify() to
udp_ctlinput() and tcp_ctlinput(), so they will call
in_pcbnotifyall() to notify all sessions with the specific
remote address.
Approved by: jlemon
Inspired by: NetBSD
credential structure, ucred (cr->cr_prison).
o Allow jail inheritence to be a function of credential inheritence.
o Abstract prison structure reference counting behind pr_hold() and
pr_free(), invoked by the similarly named credential reference
management functions, removing this code from per-ABI fork/exit code.
o Modify various jail() functions to use struct ucred arguments instead
of struct proc arguments.
o Introduce jailed() function to determine if a credential is jailed,
rather than directly checking pointers all over the place.
o Convert PRISON_CHECK() macro to prison_check() function.
o Move jail() function prototypes to jail.h.
o Emulate the P_JAILED flag in fill_kinfo_proc() and no longer set the
flag in the process flags field itself.
o Eliminate that "const" qualifier from suser/p_can/etc to reflect
mutex use.
Notes:
o Some further cleanup of the linux/jail code is still required.
o It's now possible to consider resolving some of the process vs
credential based permission checking confusion in the socket code.
o Mutex protection of struct prison is still not present, and is
required to protect the reference count plus some fields in the
structure.
Reviewed by: freebsd-arch
Obtained from: TrustedBSD Project
treat 0 as a wildcard in src/sys/in_pbc.c:in_pcbnotify()
It's sufficient to check for src|local port, as we'll have no
sessions with src|local port == 0
Without this a attacker sending ICMP messages, where the attached
IP header (+ 8 bytes) has the address and port numbers == 0, would
have the ICMP message applied to all sessions.
PR: kern/25195
Submitted by: originally by jesper, reimplimented by jlemon's advice
Reviewed by: jlemon
Approved by: jlemon
actually in the kernel. This structure is a different size than
what is currently in -CURRENT, but should hopefully be the last time
any application breakage is caused there. As soon as any major
inconveniences are removed, the definition of the in-kernel struct
ucred should be conditionalized upon defined(_KERNEL).
This also changes struct export_args to remove dependency on the
constantly-changing struct ucred, as well as limiting the bounds
of the size fields to the correct size. This means: a) mountd and
friends won't break all the time, b) mountd and friends won't crash
the kernel all the time if they don't know what they're doing wrt
actual struct export_args layout.
Reviewed by: bde
were performed to determine if the received packet should be reset. This
created erroneous ratelimiting and false alarms in some cases. The code
has now been reorganized so that the checks for validity come before
the call to badport_bandlim. Additionally, a few changes in the symbolic
names of the bandlim types have been made, as well as a clarification of
exactly which type each RST case falls under.
Submitted by: Mike Silbersack <silby@silby.com>
1. ICMP ECHO and TSTAMP replies are now rate limited.
2. RSTs generated due to packets sent to open and unopen ports
are now limited by seperate counters.
3. Each rate limiting queue now has its own description, as
follows:
Limiting icmp unreach response from 439 to 200 packets per second
Limiting closed port RST response from 283 to 200 packets per second
Limiting open port RST response from 18724 to 200 packets per second
Limiting icmp ping response from 211 to 200 packets per second
Limiting icmp tstamp response from 394 to 200 packets per second
Submitted by: Mike Silbersack <silby@silby.com>
because it only takes a struct tag which makes it impossible to
use unions, typedefs etc.
Define __offsetof() in <machine/ansi.h>
Define offsetof() in terms of __offsetof() in <stddef.h> and <sys/types.h>
Remove myriad of local offsetof() definitions.
Remove includes of <stddef.h> in kernel code.
NB: Kernelcode should *never* include from /usr/include !
Make <sys/queue.h> include <machine/ansi.h> to avoid polluting the API.
Deprecate <struct.h> with a warning. The warning turns into an error on
01-12-2000 and the file gets removed entirely on 01-01-2001.
Paritials reviews by: various.
Significant brucifications by: bde
