lualoader in itself only uses another ~200K, but there seems to be no reason
not to bump it a little higher to give us some more wiggle room.
With this, I can boot using a menu-enabled lualoader, no problem and
reasonably fast. Some heap usage datapoints from the review:
forthloader, no menus, kernel loaded:
heap base at 0x1203d5b0, top at 0x1208e000, used 330320
lualoader, no menus, kernel loaded:
heap base at 0x42050028, top at 0x420ab000, used 372696
lualoader, menus, kernel loaded:
heap base at 0x42050028, top at 0x420d5000, used 544728
Since then, the no menu case for lualoader should have decreased slightly as
I've made some changes to make sure that it no longer loads any of th emenu
bits with beastie disabled.
While here, split heap size out into a HEAP_SIZE macro.
Reviewed by: ian, imp
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D14471
A foolish consistency is the hobgoblin of little minds, adored by
little statesmen and philosophers and divines. With consistency a
great soul has simply nothing to do. -- Ralph Waldo Emerson
The current system is fragile and requires very careful layout of all
*_devdesc structures. It also makes it hard to change the base
devdesc. Take a page from CAM and put the 'header' in all the derived
classes and adjust the code to match.
For OFW, move the iHandle h_handle out of a slot conflicting with
d_opendata. Due to quirks in the alignment rules, this worked.
However changing the code to use d_opendata storage now that it's a
pointer is hard, so just have a separate field for it.
All other cleanups were to make the *_devdesc structures match where
they'd taken some liberties that were none-the-less compatible enough
to work.
Make sure { on the same line as struct for all struct *devdesc. Move
some type definitions to next to the dv_type define, since that's what
sets the d_type.
One does not simply convert to SUBDIR.yes in stand without making everything
else in the affected files SUBDIR.yes -- there are better ways to do this.
Use SUBDIR.${MK_*} where appropriate. r330248 eliminated most of the
offenders, sweep the rest under the rug.
Differential Revision: https://reviews.freebsd.org/D14545
OK. We don't really need a bsd.stand.mk, and it was causing a -fPIC
for the toolchain to be added (bogusly) when building on amd64. Pull
all relevant defs back into defs.mk and delete bsd.stand.mk.
This saves about 15-20k on i386 loader and zfsloader which when
combined with Lua give us a lot more stack space in those constrained
environments.
Summary:
All metadata.c files are very similar, with only trivial changes. Unify them
into a single common file, with minor special-casing where needed.
Reviewed By: imp
Differential Revision: https://reviews.freebsd.org/D13978
MK_CTF, MK_SSP, MK_PROFILE, NO_PIC, and INTERNALLIB are always the
same, so set them in defs.mk. MAN= is common, so set it here too.
This removes a lot of boring repetition from the Makefiles that added
almost no value.
This should have been done as part of r327350, but due to lack of foresight
it came later. In the different places we apply overlays, we duplicate the
bits that check for fdt_overlays in the environment and supplement that with
any other places we need to check for overlays to load. These "other places"
will be loader specific and are not candidates for consolidation.
Provide an fdt_load_dtb_overlays to capture the common logic, allow passing
in an additional list of overlays to be loaded. This additional list of
overlays is used in practice for ubldr to pull in any fdt_overlays passed to
it from U-Boot environment, but it can be used for any other source of
overlays.
These additional overlays supplement loader.conf(5) fdt_overlays, rather
than replace, so that we're not restricted to specifying overlays in only
one place. This is a change from previous behavior where loader.conf(5)
supplied fdt_overlays would cause us to ignore U-Boot environment, and this
seems nonsensical- user should have sufficient control over both of these
aspects, or lack of control for good reasons.
A knob could be considered in the future to ignore U-Boot supplied overlays,
but the supplemental treatment seems like a good start.
Reviewed by: imp (earlier version), gonzo (earlier version)
Differential Revision: https://reviews.freebsd.org/D13993
Overlays were previously not applied when U-Boot provides FDT or EFI
provides FDT, only when we load FDT from /boot/dtb given name from U-Boot.
Make all three paths lead to loading fdt_overlays and applying them, so that
fdt_overlays can be expected to Just Work.
Reviewed by: gonzo, imp, manu
Differential Revision: https://reviews.freebsd.org/D13664
removing this argument, and expanding when rc is NULL. This
effectively completes the back out of custom scripts for tftp booted
loaders from r269153 that was started in r292344 with the new path
tricks that obsoleted it.
Submitted by: Netflix
simd / no float stuff is centeralized here. Also centralise
-ffreestanding since it is specified everywhere.
This, along with a change to share/mk/bsd.cpu.mk to include -mno-avx2
in CFLAGS_NO_SIMD should fix building for newer machines (eg with
CPUTYPE=haswell) where clang was generating avx2 instructions.
Sponsored by: Netflix
