It is better do not mix TxQ creation and receive event flags since only
checksum flags are applicable to TxQ.
Also it will allow to add a new TxQ creation specific flags.
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4389
When writing the MUM firmware the chunk size must be equal to the erase
size.
Submitted by: Laurence Evans <levans at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4388
Use flag on vadapter alloc when reported as a supported capability.
Use the slow device reset only when the capability is missing.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4387
The erase size is reported by the nvram info command.
Submitted by: Paul Fox <pfox at solarflare.com>
Reviewed by: gnn
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4386
Required to build with -Werror=unused-but-set-variable.
Keep it under #if 0 as a reminder for parse error processing.
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
The SFL9122 "Huntington" controller was never built.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
If, for example, a VF is configured to use a 1500 byte MTU, but the port
it is attached to is set to 9000 bytes, overlength frames can be received
by the VF. As Huntington scatters by default, these overlength packets
would be scattered across several descriptors, with all except the last
having the CONT bit set.
To avoid this, disable scatter when creating RXQs if the firmware
supports doing so, which all recent versions do. Then we only get
a single descriptor from an overlength frame. This will have the CONT
bit set to indicate it was truncated, so we can discard it.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4354
Submitted by: Paul Fox <pfox at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4353
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4331
After an MC reboot, a VF driver may reset before the PF driver has
finished bringing everything back up. This includes the VFs EVB port.
MC_CMD_VADAPTOR_ALLOC is the first MCDI call after an MC reboot to
require the EVB port, so if it fails with MC_CMD_ERR_NO_EVB_PORT,
retry the command a few times after waiting a while.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4333
Make link control privilege visible to OS driver to guard updates to
flow control and PHY advertised capabilities.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4330
It allows manftest to program them.
Submitted by: Paul Fox <pfox at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4329
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4328
Common code should infer other privileges from Admin privilege to
support firmware that pre-dates introduction of specific privilege
flags.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4327
Using a typedef for common code return types (rather than "int")
allows the Prefast static analyser to understand when a function
has been successful (and thus when its postconditions must hold).
This greatly reduces then number of false positives reported by
prefast for error paths in common code functions.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Dynamic config partitions on boards that support RFID are divided into
a number of segments, each formatted like a partition, with header,
trailer and end tags. The first segment is the current active
configuration.
The segments are initialised by manftest and each contain a different
configuration e.g. firmware variant. The firmware can be instructed
via RFID to copy a segment over the first segment, hence changing the
active configuration. This allows ops to change the configuration of
a board prior to shipment using RFID.
Changes to the dynamic config may need to be written to all segments (in
particular firmware versions written by manftest) or just the first
segment (changes to the active configuration). See SF-111324-SW.
If only the first segment is written the code still needs to be aware of
the possible presence of subsequent segments as writing to a segment may
cause its size to increase, which would overwrite the subsequent
segments and invalidate them.
Boards that do not support RFID will only have one segment in their
dynamic config partition.
Submitted by: Paul Fox <pfox at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4302
If the VPD is corrupt and contains an 'RV' keyword before the
END tag, then this function could return without setting the
return code to report the error.
Found by prefast.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Keep prefast happy by returning the initial queue index
from falconsiena_tx_qcreate(). No change in behaviour, as
etxo_qcreate already zeros *addedp before the call.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
PIO is not yet supported in the FreeBSD driver.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Adjust external port mapping table to distinguish Pavia from Monza.
Now the presence of any 40G mode implies at least 2 outputs per
external port. So Pavia 4x10G ports are now mapped to 1,2,3,4;
Monza 4x10G ports map to 1,1,2,2 as before.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
GCC 4.2.1 used on FreeBSD 8 and 9 branches does not like unnamed
union member in the structure. It is not strictly required in head,
but nice to have to minimize difference with out-of-tree driver.
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Driver must be able to start against older firmware that is missing
recently added MCDI calls, otherwise firmware upgrade will not be
possible.
Submitted by: Richard Houldsworth <rhouldsworth at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D3145
Support 7xxx adapters including firmware-assisted TSO and VLAN tagging:
- Solarflare Flareon Ultra 7000 series 10/40G adapters:
- Solarflare SFN7042Q QSFP+ Server Adapter
- Solarflare SFN7142Q QSFP+ Server Adapter
- Solarflare Flareon Ultra 7000 series 10G adapters:
- Solarflare SFN7022F SFP+ Server Adapter
- Solarflare SFN7122F SFP+ Server Adapter
- Solarflare SFN7322F Precision Time Synchronization Server Adapter
- Solarflare Flareon 7000 series 10G adapters:
- Solarflare SFN7002F SFP+ Server Adapter
Support utilities to configure adapters and update firmware.
The work is done by Solarflare developers
(Andy Moreton, Andrew Lee and many others),
Artem V. Andreev <Artem.Andreev at oktetlabs.ru> and me.
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 weeks
Causually read by: gnn
Differential Revision: https://reviews.freebsd.org/D2618
This is a temporary workaround until we determine a reliable sequence
of operations for detecting MC reboots.
Sponsored by: Solarflare Communications, Inc.
Differential Revision: https://reviews.freebsd.org/D2084
bus_space_*_8() are not always macros, so it is not correct to use
#ifndef.
Sponsored by: Solarflare Communications, Inc.
Differential Revision: https://reviews.freebsd.org/D2083
In theory the barriers are required to cope with write combining and
reordering. Two barriers are added (sometimes merged to one):
1. Before the first write to guarantee that previous writes to the region
have been done
2. Before the last write to guarantee that write to the last dword/qword is
done after previous writes
Barriers are inserted before in the assumption that it is better to
postpone barriers as much as it is possible (more chances that the
operation has already been already done and barrier does not stall CPU).
On x86 and amd64 bus space write barriers are just compiler memory barriers
which are definitely required.
Sponsored by: Solarflare Communications, Inc.
Differential Revision: https://reviews.freebsd.org/D2077
To delay packets from a particular TX queue by a particular time, write a value
into the TX Pace table s.t. pace time <= TX Pace Clock Period * (2 ^ pace value)
- the TX pace clock is 1/13 of the system clock, so its period should be 104 or
52 ns depending on whether turbo mode is active.
EFX_TX_PACE_CLOCK_BASE added by me.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
It solves locking problem when EFSYS_MEM_ALLOC is called in
the context holding a mutex (not allowed to sleep).
E.g. on interface bring up or multicast addresses addition.
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
Host-bus byte order translation is not requred.
Submitted by: Artem V. Andreev <Artem.Andreev at oktetlabs.ru>
Sponsored by: Solarflare Communications, Inc.
Approved by: gnn (mentor)
