This avoids back-to-back faults for all TLB misses. This can be
improved further in the future by also setting PTE_DIRTY for TLB
misses for write accesses.
MFC after: 1 week
ways:
(1) Cached pages are no longer kept in the object's resident page
splay tree and memq. Instead, they are kept in a separate per-object
splay tree of cached pages. However, access to this new per-object
splay tree is synchronized by the _free_ page queues lock, not to be
confused with the heavily contended page queues lock. Consequently, a
cached page can be reclaimed by vm_page_alloc(9) without acquiring the
object's lock or the page queues lock.
This solves a problem independently reported by tegge@ and Isilon.
Specifically, they observed the page daemon consuming a great deal of
CPU time because of pages bouncing back and forth between the cache
queue (PQ_CACHE) and the inactive queue (PQ_INACTIVE). The source of
this problem turned out to be a deadlock avoidance strategy employed
when selecting a cached page to reclaim in vm_page_select_cache().
However, the root cause was really that reclaiming a cached page
required the acquisition of an object lock while the page queues lock
was already held. Thus, this change addresses the problem at its
root, by eliminating the need to acquire the object's lock.
Moreover, keeping cached pages in the object's primary splay tree and
memq was, in effect, optimizing for the uncommon case. Cached pages
are reclaimed far, far more often than they are reactivated. Instead,
this change makes reclamation cheaper, especially in terms of
synchronization overhead, and reactivation more expensive, because
reactivated pages will have to be reentered into the object's primary
splay tree and memq.
(2) Cached pages are now stored alongside free pages in the physical
memory allocator's buddy queues, increasing the likelihood that large
allocations of contiguous physical memory (i.e., superpages) will
succeed.
Finally, as a result of this change long-standing restrictions on when
and where a cached page can be reclaimed and returned by
vm_page_alloc(9) are eliminated. Specifically, calls to
vm_page_alloc(9) specifying VM_ALLOC_INTERRUPT can now reclaim and
return a formerly cached page. Consequently, a call to malloc(9)
specifying M_NOWAIT is less likely to fail.
Discussed with: many over the course of the summer, including jeff@,
Justin Husted @ Isilon, peter@, tegge@
Tested by: an earlier version by kris@
Approved by: re (kensmith)
of pages don't sum to anywhere near the total number of pages on amd64.
This is for the most part because uma_small_alloc() pages have never been
counted as wired pages, like their kmem_malloc() brethren. They should
be. This changes fixes that.
It is no longer necessary for the page queues lock to be held to free
pages allocated by uma_small_alloc(). I removed the acquisition and
release of the page queues lock from uma_small_free() on amd64 and ia64
weeks ago. This patch updates the other architectures that have
uma_small_alloc() and uma_small_free().
Approved by: re (kensmith)
Recently the AP in my Merced box seems to have grown a habit
of getting unexpected interrupts, such as redundant wake-ups
and legacy interrupts that require an INTA cycle.
While here, replace DELAY(0) with cpu_spinwait() so that it's
clear what we're doing as well as enable the code to take
advantage of cpu_spinwait() when it gets implemented.
Approved by: re (blanket)
There's no advantage in allowing nested external interrupts.
In fact, it leads to a potential stack overrun.
While here, put the interrupt vector in the trapframe, so as
to compensate for the 36 cycle latency of reading cr.ivr.
Further simplify assembly code by dealing with ASTs from C.
Approved by: re (blanket)
us to do the data serializations once after writing multiple
region registers, as is done in pmap_switch(). All existing
calls to ia64_set_rr() are followed with calls to ia64_srlz_d().
Approved by: re (blanket)
ia64_cpu.h. This improves readability and consistency and aids in
auditing the code.
Add instruction-serialization after writing to cr.pta.
Delay enabling interrupts until after we setup the clocks and after
we program the task priority register.
Approved by: re (blanket)
ia64_cpu.h. This improves readability and consistency and aids in
auditing the code.
Add data-serialization after writing to the region registers and
add instruction-serialization after writing to cr.pta.
Approved by: re (blanket)
ia64_cpu.h. This improves readability and consistency and aids in
auditing the code.
Add data-serialization after writing to cr.tpr.
Approved by: re (blanket)
bucket pointer. The virtual mapping may not be present in the
translation cache. This will result in a nested TLB fault at
a place we don't handle (and don't want to handle).
o Make sure there's a stop after the rfi instruction, otherwise
its behaviour is undefined.
o Make sure we switch back to virtual addressing before doing
a rfi. Behaviour is undefined otherwise.
Approved by: re (blanket)
(INTR_FILTER). This includes:
o Save a pointer to the sapic structure and IRQ for every vector,
so that we can quickly EOI, mask and unmask the interrupt.
o Add locking to the sapic code now that we can reprogram a
sapic on multiple CPUs at the same time.
o Use u_int for the vector and IRQ. We only have 256 vectors, so
using a 64-bit type for it is rather excessive.
o Properly handle concurrent registration of a handler for the
same vector.
Since vectors have a corresponding priority, we should not map
IRQs to vectors in a linear fashion, but rather pick a vector
that has a priority in line with the interrupt type. This is left
for later. The vector/IRQ interchange has been untangled as much
as possible to make this easier.
Approved by: re (blacket)
merely lucky that the VHPT was mapped as a side-effect of
mapping the kernel, but when there's enough physical memory,
this may not at all be the case.
Approved by: re (blanket)
print a one line error message. Add some comments on not being able to
trust the day of week field (I'll act on these comments in a follow up
commit).
Approved by: re
MFC after: 3 weeks
The SDM states that writing to ar.bspstore invalidates the ar.rnat
register as a side-effect. This was interpreted as "bits in the
ar.rnat register that correspond to registers whose value is on
the stack are undefined'. Since we keep the kernel stack NaT-
aligned with the user stack (i.e. the lower 9 bits of the backing
store pointer remain unchanged when we switch to the kernel stack)
bits that need preserving would be preserved.
That interpretation is questionable. So, now, the interpretation
is more absolute: ar.rnat is undefined after writing to ar.bspstore.
As such, we write the saved value of ar.rnat back to ar.rnat after
writing to ar.bspstore.
Discussed with: christian.kandeler@hob.de
Approved by: re (kensmith)
more exposure. The current state of SCTP implementation is
considered to be ready for 32-bit platforms, but still need some
work/testing on 64-bit platforms.
Approved by: re (kensmith)
Discussed with: rrs
is really a memory mapped I/O address. The bug is in the GAS that
describes the address and in particular the SpaceId field. The field
should not say the address is an I/O port when it clearly is not.
With an additional check for the IA64_BUS_SPACE_IO case in the bus
access functions, and the fact that I/O ports pretty much not used
in general on ia64, make the calculation of the I/O port address a
function. This avoids inlining the work-around into every driver,
and also helps reduce overall code bloat.
caches with data caches after writing to memory. This typically
is required to make breakpoints work on ia64 and powerpc. For
those architectures the function is implemented.
grab sched_lock. This would serialize calls to pmap_switch from
cpu_switch(). With the introduction of thread_lock, this is not
possible anymore, because thread_lock is not a single lock. It
varies. Secondly and most importantly, it's not needed at all. The
only requirement for pmap_switch() is that it's not preempted
while in the middle of updating the CPU and PCPU. In other words,
it's a critical region. No locking required.
- Use thread_lock() rather than sched_lock for per-thread scheduling
sychronization.
- Use the per-process spinlock rather than the sched_lock for per-process
scheduling synchronization.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Add a new parameter to cpu_switch() that is used to release the lock on
the outgoing thread and properly acquire the lock on the incoming
thread. This parameter is not required for schedulers that don't do
per-cpu locking and architectures which do not support it may continue
to use the 4BSD scheduler. This feature is presently not supported
on ia64
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Use sched_throw() rather than replicating the same cpu_throw() code for
each architecture. This also allows the scheduler to use any locking it
may want to.
- Use the thread_lock() rather than sched_lock when preempting.
- The scheduler lock is not required to synchronize release_aps.
Tested by: kris, current@
Tested on: i386, amd64, ULE, 4BSD, libthr, libkse, PREEMPTION, etc.
Discussed with: kris, attilio, kmacy, jhb, julian, bde (small parts each)
- Rename PCPU_LAZY_INC into PCPU_INC
- Add the PCPU_ADD interface which just does an add on the pcpu member
given a specific value.
Note that for most architectures PCPU_INC and PCPU_ADD are not safe.
This is a point that needs some discussions/work in the next days.
Reviewed by: alc, bde
Approved by: jeff (mentor)
Probabilly, a general approach is not the better solution here, so we should
solve the sched_lock protection problems separately.
Requested by: alc
Approved by: jeff (mentor)
handler is wrapped in a couple of functions - a filter wrapper and an
ithread wrapper. In this case (and just in this case), the filter
wrapper could ask the system to schedule the ithread and mask the
interrupt source if the wrapped handler is composed of just an ithread
handler: modify the "old" interrupt code to make it support
this situation, while the "new" interrupt code is already ok.
Discussed with: jhb
used to return PAGE_SIZE without respect to restrictions of a DMA tag.
This affected all of the busdma load functions that use
_bus_dmamap_loader_buffer() as their back-end.
Reviewed by: scottl
speculative loads. This at least makes control speculative loads
work. In the future we should analyze which faults/exceptions
we want to handle rather than defer to avoid having to call the
recovery code when it's not strictly necessary.
same way it was enabled for Linux binares in linuxulator.
This allows binaries built with -pie. Many ports auto-detect -fPIE support
in GCC 4.2 and build binaries FreeBSD was unable to run.
processor is to jump to recovery code. This branching behaviour
may not be implemented by the processor and a Speculative Operation
fault is raised. The OS is responsible to emulate the branch.
Implement this, because GCC 4.2 uses advanced loads regularly.
scheme allowed for 1024 PTE pages, each containing 256 PTEs.
This yielded 2GB of KVA. This is not enough to boot a kernel
on a 16GB box and in general too low for a 64-bit machine.
By adding a level of indirection we now have 1024 2nd-level
directory pages, each capable of supporting 2GB of KVA. This
brings the grand total to 2TB of KVA.
Fix the flags argument: M_WAITOK is not a valid flag. Its presence
leaves the indication that contigmalloc(9) will not return a NULL
pointer.
The use of contigmalloc(9) in this place is probably not a good idea
given the constraints. It's probably better to lift the constraints
and instead add a permanent mapping to the ITR. It's possible that
the first 256MB of memory is exhausted when we get here.
This fixes a kernel panic on a 16GB rx3600.
