self-decompressing ram disk that I'm fiddling with..
(Note, this depends on the various syscalls having correctly set uio_segflag
before calling physio - I've checked and they look correct.)
What was happening, was that the main mfs loop was sleeping, and when it was
being awoken by a wakeup when it was supposed to process some IO requests.
The problem was that if it was being woken out of the tsleep() by a signal
at shutdown, it was going straight into dounmount() without servicing any
pending IO requests, causing dounmount() to fail because there were busy
buffers (and they could not be "processed" because the processing loop was
trying to unmount rather than dispatching into mfs_doio()).
This (dare I say it :-) appears to be a layering problem....
to get the prototypes.
Changed some `int's to `boolean_t's. boolean_t's are ints so they are
hard to distinguish from ints.
Converted function headers to old-style. ddb is written in K&R1 C
except where we broke it.
- don't #include other headers just to get struct names.
- don't use __BEGIN_DECLS/__END_DECLS for system prototypes. It is for
user prototypes.
- don't use extern.
- don't use lines longer than 80 columns.
- use alphabetical order.
- use tabs.
Uniformized idempotency ifdefs.
it `const' to inhibit compiler warnings.
Added #include of <pccard/driver.h> to get prototypes. <pccard/slot.h>
is still necessary for its side effect of exporting non-slot things.
HD64570 chip. Both the 2 and 4 port cards is supported and auto detected.
Line speeds of up to 2Mbps is possible. At this speed about 85% of the
bandwidth is usable with 486DX processors.
The standard FreeBSD sppp code is used for the link level layer. The
default protocol used is PPP. The Cisco HDLC protocol can be used by
adding "link2" to the ifconfig line in /etc/sysconfig or where ever
ifconfig is run.
At the moment only the V.35 and X.21 interfaces is supported. The others
may need tweaks to the clock selection code.
Submitted by: John Hay <jhay@mikom.csir.co.za>
is acknowledged, it should go to the lcp ack sent state.
Don't reply on lcp echo requests when not in the lcp opened state.
If the interface is set to CISCO mode, it should still be marked
running when ifconfiged.
Fixed a few indentations that had gone wrong somewhere.
Submitted-by: John.Hay@csir.co.za
bit set. I broke stat_imask in Dec 1994 and update_intr_masks() has
copied the breakage to intr_mask[8] since Mar 1995. This can cause
the RTC to stop interrupting in rare cases (under loads heavy enough
for a new RTC interrupt to occur at a critical time just before Xintr8
finishes handling the previous one) and may have caused worse problems.
Convert the remaining sysctl stuff to the new way of doing things.
the devconf stuff is the reason for the large number of files.
Cleaned up some compiler warnings while I were there.
