OTP registers (because the user is in control of the fdt data). Remove the
early returns from the code that tries to find a good mac address, so that
the execution always flows through the routine to get an address from FDT
data last, when on FDT-enabled systems.
the device instance, and to get the MAC address for the device instance.
The ad-hoc code this replaces could find the wrong instance if multiple
devices were present.
Also use LED mode settings from the FDT to set the PHY.
From v3 of the patch submitted in the PR.
I moved the sc_led_modes and sc_led_modes_mask default setting outside
of the #ifdef FDT case.
PR: 237325
Submitted by: Ralf <iz-rpi03@hs-karlsruhe.de>
Reviewed by: ian
MFC after: 2 weeks
MFC with: r348001
Event: Waterloo Hackathon 2019
Differential Revision: https://reviews.freebsd.org/D20325
Also apply some style(9) and remove the message about EEPROM configuration
(if there's an EEPROM the hardware handles LED configuration itself).
PR: 237325
Reviewed by: ian
MFC after: 2 weeks
Submitted by: Ralf <iz-rpi03@hs-karlsruhe.de>
The existing SPI support only worked for directly attached flash chips.
it didn't implement clock programming or chipselect. It also supports
transfers with unbalanced tx/rx command sizes.
Submitted by: <yamori813@yahoo.co.jp>
Differential Revision: https://reviews.freebsd.org/D20101
Summary:
PowerPC kernels are fully position independent, just like kernel modules.
The same fixups that are done for modules therefore need to be done to the
kernel, else symbol resolution in, e.g., DTrace, cannot resolve the kernel
symbols, so only addresses in the kernel are printed, while kernel module
symbols are printed.
Test Plan:
Run lockstat on powerpc64. Note symbols are resolved for kernel and
modules.
Reviewed By: markj
Differential Revision: https://reviews.freebsd.org/D20316
This allows replacing "sys/eventfilter.h" includes with "sys/_eventfilter.h"
in other header files (e.g., sys/{bus,conf,cpu}.h) and reduces header
pollution substantially.
EVENTHANDLER_DECLARE and EVENTHANDLER_LIST_DECLAREs were moved out of .c
files into appropriate headers (e.g., sys/proc.h, powernv/opal.h).
As a side effect of reduced header pollution, many .c files and headers no
longer contain needed definitions. The remainder of the patch addresses
adding appropriate includes to fix those files.
LOCK_DEBUG and LOCK_FILE_LINE_ARG are moved to sys/_lock.h, as required by
sys/mutex.h since r326106 (but silently protected by header pollution prior
to this change).
No functional change (intended). Of course, any out of tree modules that
relied on header pollution for sys/eventhandler.h, sys/lock.h, or
sys/mutex.h inclusion need to be fixed. __FreeBSD_version has been bumped.
Currently such routes are added with a link-level IFA, which is
plain wrong. Only after the insertion they get fixed by the special
link_rtrequest() ifa handler. This behaviour complicates routing code
and makes ifa selection more complex.
Streamline this process by explicitly moving link_rtrequest() logic
to the pre-insertion rt_getifa_fib() ifa selector. Avoid calling all
this logic in the loopback route case by explicitly specifying
proper rt_ifa inside the ifa_maintain_loopback_route().§
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D20076
FDT data is sometimes used to configure usb devices which are hardwired into
an embedded system. Because the devices are instantiated by the usb
enumeration process rather than by ofwbus iterating through the fdt data, it
is somewhat difficult for a usb driver to locate fdt data that belongs to
it. In the past, various ad-hoc methods have been used, which can lead to
errors such applying configuration that should apply only to a hardwired
device onto a similar device attached by the user at runtime. For example,
if the user adds an ethernet device that uses the same driver as the builtin
ethernet, both devices might end up with the same MAC address.
These changes add a new usb_fdt_get_node() helper function that a driver can
use to locate FDT data that belongs to a single unique instance of the
device. This function locates the proper FDT data using the mechanism
detailed in the standard "usb-device.txt" binding document [1].
There is also a new usb_fdt_get_mac_addr() function, used to retrieve the
mac address for a given device instance from the fdt data. It uses
usb_fdt_get_node() to locate the right node in the FDT data, and attempts to
obtain the mac-address or local-mac-address property (in that order, the
same as linux does it).
The existing if_smsc driver is modified to use the new functions, both as an
example and for testing the new functions. Rpi and rpi2 boards use this
driver and provide the mac address via the fdt data.
[1] https://github.com/torvalds/linux/blob/master/Documentation/devicetree/bindings/usb/usb-device.txt
Differential Revision: https://reviews.freebsd.org/D20262
The source file was moved to base earlier and also improved upon,
but never compiled in. This patch will:
- Make a module in sys/modules
- Make lindebugfs depend on linuxkpi (for seq_file)
- Check if read/write functions are set before calling, DRM drivers
don't always set both of them.
Reviewed by: hps
Approved by: imp (mentor), hps
MFC after: 1 week
socket is non-blocking and connect() is not finished yet.
Initial patch developed by Steven Hartland in 2008 and adopted by me.
PR: 129169
Reported by: smh@
MFC after: 2 weeks
Submitted by: Patrick Mooney <pmooney@pfmooney.com>
Reviewed by: kib
Tested by: Patrick on SmartOS with Linux and Windows guests
Obtained from: Joyent
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D20296
Apparently, there is more code trying to call pmap_remove() early,
mostly to free preloaded memory. Instead of moving all deallocations
to the point where a scheduler is initialized, add missed setup of
thread0 di init at hammer_time().
The code in pmap_delayed_invl_start_u() is modified to not ever take
the thread lock if the thread priority is less or equal to PVM. Since
thread0 starts at priority 0, and then is reset to PVM at
proc0_init(), this eliminates taking the thread lock during early
boot.
While there, fix off by one in comparision of the base priority.
Reported and tested by: bcran (previous version)
Reviewed by: markj
Sponsored by: The FreeBSD Foundation
MFC after: 29 days
It was found during building llvm that the page pv lock pool was seeing very
high contention. Since the pmap is already NUMA aware, it was surmised that
the domains were referencing similar pages in the different domains. This
reduces contention to the point of noise in a lockstat(8) run (~51% down to
under 5%), reducing build times by up to 20%.
This doesn't do a perfect domain alignment, just a best-guess based on
hardware available, that the domain is roughly specified in the upper bits
of the PA. Trying to be more clever would more than likely result in
reduced performance just on the work needed.
MFC after: 2 weeks
memguard(9) wants to avoid reuse of freed addresses for as long as
possible. Previously it maintained a racily updated cursor which was
passed to vmem_xalloc(9) as the minimum address. However, vmem will
not in general return the lowest free address in the arena, so this
trick only really works until the cursor has wrapped around the first
time.
Reported by: alc
Reviewed by: alc
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D17227
This is described in the vmem paper: "directs vmem to use the next free
segment after the one previously allocated." The implementation adds a
new boundary tag type, M_CURSOR, which is linked into the segment list
and precedes the segment following the previous M_NEXTFIT allocation.
The cursor is used to locate the next free segment satisfying the
allocation constraints.
This implementation isn't O(1) since busy tags aren't coalesced, and we
may potentially scan the entire segment list during an M_NEXTFIT
allocation.
Reviewed by: alc
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D17226
This change doesn't make any attempt to add support for these slices to the
relevent GEOM classes. Just register the number in fdisk and the canonical
list of kernel macros (diskmbr.h).
Obtained from: DragonFlyBSD (794d80aa519b394b3174f20776a) (small subset of)
Fix stack unwinding such that requesting N stack frames in lockstat will
actually give you N frames, not anywhere from 0-3 as had been before.
lockstat prints the mutex function instead of the caller as the reported
locker, but the stack frame is detailed enough to find the real caller.
MFC after: 2 weeks
We need to make the find_veriexec_file() function available publicly, so
rename it to mac_veriexec_metadata_find_file_info() and make it non-static.
Bump the version of the veriexec device interface so user space will know
the labelized version of fingerprint loading is available.
Approved by: sjg
Obtained from: Juniper Networks, Inc.
Differential Revision: https://reviews.freebsd.org/D20295
MAC_VERIEXEC_CHECK_PATH_SYSCALL per-MAC policy system call.
When we are checking the status of the fingerprint on a vnode using the
per-MAC-policy syscall, we do not need an exclusive lock on the vnode.
Even if there is more than one thread requesting the status at the same time,
the worst we can end up doing is processing the file more than once.
This can potentially be improved in the future with offloading the fingerprint
evaluation to a separate thread and blocking until the update completes. But
for now the race is acceptable.
Obtained from: Juniper Networks, Inc.
MFC after: 1 week
be restricted when veriexec is enforced.
Add mpo_system_check_sysctl method to mac_veriexec which does this.
Obtained from: Juniper Networks, Inc.
MFC after: 1 week
are different types across architectures by using %ju and typecasting to
uintmax_t, where appropriate.
Obtained from: Juniper Networks, Inc.
MFC after: 1 week
priv. This allows for MAC/veriexec to prevent apps that are not "trusted"
from using these commands.
Obtained from: Juniper Networks, Inc.
MFC after: 1 week
mac_veriexec_get_executable_flags(). Only try locking/unlocking if the caller
has not already acquired the process lock.
Obtained from: Juniper Networks, Inc.
MFC after: 1 week
type, use a table to make it easier to add more in the future, if needed.
Add VirtualBox detection to the table ("VBoxVBoxVBox" is the hypervisor
vendor string to look for.) Also add VM_GUEST_VBOX to the VM_GUEST
enumeration to indicate VirtualBox.
Save the CPUID base for the hypervisor entry that we detected. Driver code
may need to know about it in order to obtain additional CPUID features.
Approved by: bryanv, jhb
Differential Revision: https://reviews.freebsd.org/D16305
With lockless DI, pmap_remove() requires operational thread lock,
which is initialized at SI_SUB_RUN_QUEUE for thread0. Move it even
later where APs are started, the moment after which other boot memory
like trampoline stacks is already being freed.
Reported by: gtetlow
Sponsored by: The FreeBSD Foundation
MFC after: 30 days
When activating a resource do not compare the resource id to the adress.
Treat IO region as MEMORY region too.
Submitted by: Tuan Phan <tphan@amperecomputing.com> (Original Version)
Sponsored by: Ampere Computing, LLC
Differential Revision: https://reviews.freebsd.org/D20214
We cannot know the bus end number before parsing the MCFG table
so don't set the bus_end before that. If the MCFG table doesn't
exist we will set the configuration base address based on the _CBA
value and set the bus_end to the maximal number allowed by PCI.
Sponsored by: Ampere Computing, LLC
Differential Revision: https://reviews.freebsd.org/D20213
cpufunc, in terms of __builtin_ffs and the like, for arm64
architectures, and use those, rather than the simple libkern
implementations, in building arm64 kernels.
Tested by: greg_unrelenting.technology (earlier version)
Reviewed by: alc
Approved by: kib (mentor)
Differential Revision: https://reviews.freebsd.org/D20250
