so should be copied to userspace with suword32() instead of suword().
This alleviates problems on 64-bit big-endian architectures, and is a
no-op on all 32-bit architectures.
Tested on: amd64, sparc64, powerpc64
AMD Family 10h Erratum 383, to i386.
Enable machine check exceptions by default, just like r204913 for amd64.
Enable superpage promotion only if the processor actually supports large
pages, i.e., PG_PS.
MFC after: 2 weeks
First, we compare mode table data against minimum value. If the mode table
does not make sense, we set the minimum in the mode info. When we actually
set the mode, we try VESA BIOS function and compare it against the previous
value. If it makes more sense, update the information.
cache, it did not free the request argument mbuf list, resulting in a leak.
This patch fixes that leak.
Tested by: danny AT cs.huji.ac.il
PR: kern/144330
Submitted by: to.my.trociny AT gmail.com (earlier version)
Reviewed by: dfr
MFC after: 2 weeks
has all 4 implemented, but across the processors we now support all the
combinations. For example, the MPC8533 doesn't have a PCI controller
at 0xA0000, but does at 0xB0000.
sure the caches remain coherent. For single-core configurations and
with busdma changes we could eventually switch to "nap" and force
a D-cache invalidation as part of the DMA completion. To this end,
clear PSL_WE until after we handled the decrementer or external
interrupt as it tells us whether we just woke up or not.
iv_recv_mgmt(). iv_recv_mgmt() will generate management frame responses
and pass them to bpf before the management frame that triggered the
response.
PR: 144323
Submitted by: Alexander Egorenkov <egorenar at gmail.com>
MFC after: 2 weeks
Sponsored by: iXsystems, inc.
in Open Firmware was Apple-specific, and we have complete coverage of Apple
system controllers, so move RTC responsibilities into the system controller
drivers. This avoids interesting problems from manipulating these devices
through Open Firmware behind the backs of their drivers.
Obtained from: NetBSD
MFC after: 2 weeks
mapping_array expansion would break. Basically
once we expanded the array we no longer had both
mapping arrays in sync which the sack processing code depends on.
This would mean we were randomly referring to memory that was probably
not there. This mostly just gave us bad sack results going back to the peer.
If INVARIENTS was on of course we would hit the panic routine in the sack_check
call.
We also add a print routine for the place where one would panic in
invarients so one can see what the main mapping array holds.
Reviewed by: tuexen@freebsd.org
MFC after: 2 weeks
- increase flow cleaning frequency and decrease flow caching time
when near the flow limit
- stop allocating new flows when within 3% of maxflows don't start
allocating again until below 12.5%
MFC after: 7 days
other than in a potentially dangerous KASSERT.
o Hand-inline pmap_remove_page() as it's only called from 1 place and
the abstraction that pmap_remove_page() provides is not enough to
warrant the obfuscation. Eliminate the dangerous KASSERT in the
process.
o In pmap_remove_pte(), remove the KASSERT for pmap being the current
one as it's not safe in the face of CPU migration.
than in a KASSERT. The KASSERT is broken in that it's done outside the
critical section and as such isn't protected against CPU migration.
Improve pmap_invalidate_page() as follows:
o calculate vhpt_ofs inside the critical region for exactly the same
reason.
o calculate the tag outside the FOREACH loop, as it's loop-invariant.
This is more efficient.
o Replace the test and set with an atomic cmpset operation because we
are changing other CPU's VHPT tables and this avoids invalidating
after the entry got modified. Not necessarily a problem, but better
safe than sorry.
before we grab the mutex. Don't assert that they must be disabled at
that point. We pretty much bypass all logic in that case anyway and
leave immediately, so there's no harm.
preemption doesn't happen until after all pending interrupt have
been services.
While here again, simplify the EOI handling by doing it after we
call the XIV-specific handlers, rather than in each of them. The
original thought was that we may want to do an EOI first and the
actual IPI handling next, but that's mostly a micro-optimization.
cycles. This serves 2 purposes:
1. It prevents preemption and CPU migration while running SAL code.
2. It reduces the chance of stack overflows: we're supposed to enter
SAL with at least 16KB of either memory- or register stack space,
which we can't do without switching to a different stack.
This is not for multiple inclusion purposes, because _regset.h already
handles this, but to enable inclusion of the MD header by cross-tools
on non-ia64 installations. The cross-tool can include _regset.h itself
before including MD headers that depend on it.
According to POSIX open() must return ENOTDIR when the path name does
not refer to a path name. Change vn_open() to respect this flag. This
also simplifies the Linuxolator a bit.
