does not fit into registers, declare that we do not support this case
using CTASSERT(), and remove endianess-unsafe code to split return value
into td_retval.
While there, change the style of the sysctl debug.iosize_max_clamp
definition.
Requested by: bde
MFC after: 3 weeks
using the o32 ABI. This mostly follows nwhitehorn's lead in implementing
COMPAT_FREEBSD32 on powerpc64.
o) Add a new type to the freebsd32 compat layer, time32_t, which is time_t in the
32-bit ABI being used. Since the MIPS port is relatively-new, even the 32-bit
ABIs use a 64-bit time_t.
o) Because time{spec,val}32 has the same size and layout as time{spec,val} on MIPS
with 32-bit compatibility, then, disable some code which assumes otherwise
wrongly when built for MIPS. A more general macro to check in this case would
seem like a good idea eventually. If someone adds support for using n32
userland with n64 kernels on MIPS, then they will have to add a variety of
flags related to each piece of the ABI that can vary. That's probably the
right time to generalize further.
o) Add MIPS to the list of architectures which use PAD64_REQUIRED in the
freebsd32 compat code. Probably this should be generalized at some point.
Reviewed by: gonzo
significantly. Upon investigation this was caused by name cache
misses for lookups of "..". For name cache entries for non-".."
directories, the cache entry serves double duty. It maps both the
named directory plus ".." for the parent of the directory. As such,
two ctime values (one for each of the directory and its parent) need
to be saved in the name cache entry.
This patch adds an entry for ctime of the parent directory to the
name cache. It also adds an additional uma zone for large entries
with this time value, in order to minimize memory wastage.
As well, it fixes a couple of cases where the mtime of the parent
directory was being saved instead of ctime for positive name cache
entries. With this patch, Lookup RPC counts return to values similar
to pre-r230394 kernels.
Reported by: bde
Discussed with: kib
Reviewed by: jhb
MFC after: 2 weeks
long for specifying a boundary constraint.
- Change bus_dma tags to use bus_addr_t instead of bus_size_t for boundary
constraints.
These allow boundary constraints to be fully expressed for cases where
sizeof(bus_addr_t) != sizeof(bus_size_t). Specifically, it allows a
driver to properly specify a 4GB boundary in a PAE kernel.
Note that this cannot be safely MFC'd without a lot of compat shims due
to KBI changes, so I do not intend to merge it.
Reviewed by: scottl
snapshots on UFS filesystems running with journaled soft updates.
This is the first of several bugs that need to be fixed before
removing the restriction added in -r230250 to prevent the use
of snapshots on filesystems running with journaled soft updates.
The deadlock occurs when holding the snapshot lock (snaplk)
and then trying to flush an inode via ffs_update(). We become
blocked by another process trying to flush a different inode
contained in the same inode block that we need. It holds the
inode block for which we are waiting locked. When it tries to
write the inode block, it gets blocked waiting for the our
snaplk when it calls ffs_copyonwrite() to see if the inode
block needs to be copied in our snapshot.
The most obvious place that this deadlock arises is in the
ffs_copyonwrite() routine when it updates critical metadata
in a snapshot and tries to write it out before proceeding.
The fix here is to write the data and indirect block pointer
for the snapshot, but to skip the call to ffs_update() to
write the snapshot inode. To ensure that we will never have
to update a pointer in the inode itself, the ffs_snapshot()
routine that creates the snapshot has to ensure that all the
direct blocks are allocated as part of the creation of the
snapshot.
A less obvious place that this deadlock occurs is when we hold
the snaplk because we are deleting a snapshot. In the course of
doing the deletion, we need to allocate various soft update
dependency structures and allocate some journal space. If we
hit a resource limit while doing this we decrease the resources
in use by flushing out an existing dirty file to get it to give
up the soft dependency resources that it holds. The flush can
cause an ffs_update() to be done on the inode for the file that
we have selected to flush resulting in the same deadlock as
described above when the inode that we have chosen to flush
resides in the same inode block as the snapshot inode that we hold.
The fix is to defer cleaning up any time that the inode on which
we are operating is a snapshot.
Help and review by: Jeff Roberson
Tested by: Peter Holm
MFC (to 9 only) after: 2 weeks
operations for setting and accessing vnode's v_socket field.
The operations are necessary to implement proper unix socket handling
on layered file systems like nullfs(5).
This change fixes the long standing issue with nullfs(5) being in that
unix sockets did not work between lower and upper layers: if we bound
to a socket on the lower layer we could connect only to the lower
path; if we bound to the upper layer we could connect only to the
upper path. The new behavior is one can connect to both the lower and
the upper paths regardless what layer path one binds to.
PR: kern/51583, kern/159663
Suggested by: kib
Reviewed by: arch
MFC after: 2 weeks
following clang warning:
sys/kern/sys_pipe.c:1556:10: error: promoted type 'int' of K&R function parameter is not compatible with the parameter type 'mode_t'
(aka 'unsigned short') declared in a previous prototype [-Werror]
mode_t mode;
^
sys/kern/sys_pipe.c:155:19: note: previous declaration is here
static fo_chmod_t pipe_chmod;
^
not get syscall exit notification until the child performed exec of
exit. Swap the order of doing ptracestop() and waiting for P_PPWAIT
clearing, by postponing the wait into syscallret after ptracestop()
notification is done.
Reported, tested and reviewed by: Dmitry Mikulin <dmitrym juniper net>
MFC after: 2 weeks
Descriptions are specific to drivers and we don't change drivers on attached
devices. This fixes a few places where we were not clearing the description
when detaching a driver (e.g. with device_attach() failed). While here, fix
a few other nits:
- Remove spurious call to remove a device's driver from
devclass_driver_deleted(). device_detach() removes it already.
- Fix a typo.
- In sched_pickcpu() be more careful taking previous CPU on SMT systems.
Do it only if all other logical CPUs of that physical one are idle to avoid
extra resource sharing.
- In sched_pickcpu() change general logic of CPU selection. First
look for idle CPU, sharing last level cache with previously used one,
skipping SMT CPU groups. If none found, search all CPUs for the least loaded
one, where the thread with its priority can run now. If none found, search
just for the least loaded CPU.
- Make cpu_search() compare lowest/highest CPU load when comparing CPU
groups with equal load. That allows to differentiate 1+1 and 2+0 loads.
- Make cpu_search() to prefer specified (previous) CPU or group if load
is equal. This improves cache affinity for more complicated topologies.
- Randomize CPU selection if above factors are equal. Previous code tend
to prefer CPUs with lower IDs, causing unneeded collisions.
- Rework periodic balancer in sched_balance_group(). With cpu_search()
more intelligent now, make balansing process flat, removing recursion
over the topology tree. That fixes double swap problem and makes load
distribution more even and predictable.
All together this gives 10-15% performance improvement in many tests on
CPUs with SMT, such as Core i7, for number of threads is less then number
of logical CPUs. In some tests it also gives positive effect to systems
without SMT.
Reviewed by: jeff
Tested by: flo, hackers@
MFC after: 1 month
Sponsored by: iXsystems, Inc.
Uftdi(4) examines (c_iflag & (IXON|IXOFF)) to control hw XON-XOFF support.
This is obviously no good, if changes to those bits are not communicated
down the stack.
allow.mount.zfs:
allow mounting the zfs filesystem inside a jail
This way the permssions for mounting all current VFCF_JAIL filesystems
inside a jail are controlled wia allow.mount.* jail parameters.
Update sysctl descriptions.
Update jail(8) and zfs(8) manpages.
TODO: document the connection of allow.mount.* and VFCF_JAIL for kernel
developers
MFC after: 10 days
socket protocol number. This is useful since the socket type can
be implemented by different protocols in the same protocol family,
e.g. SOCK_STREAM may be provided by both TCP and SCTP.
Submitted by: Jukka A. Ukkonen <jau iki fi>
PR: kern/162352
Discussed with: bz
Reviewed by: glebius
MFC after: 2 weeks
unp->unp_vnode pointer to detect if there is a vnode associated with
(binded to) this socket and does necessary cleanup if there is.
The issue is that after forced unmount this check may be too late as
the unp_vnode is reclaimed and the reference is stale.
To fix this provide a helper function that is called on a socket vnode
reclamation to do necessary cleanup.
Pointed by: kib
Reviewed by: kib
MFC after: 2 weeks
according to POSIX document, the clock ID may be dynamically allocated,
it unlikely will be in 64K forever. To make it future compatible, we
pack all timeout information into a new structure called _umtx_time, and
use fourth argument as a size indication, a zero means it is old code
using timespec as timeout value, but the new structure also includes flags
and a clock ID, so the size argument is different than before, and it is
non-zero. With this change, it is possible that a thread can sleep
on any supported clock, though current kernel code does not have such a
POSIX clock driver system.
a new jail parameter node with the following parameters:
allow.mount.devfs:
allow mounting the devfs filesystem inside a jail
allow.mount.nullfs:
allow mounting the nullfs filesystem inside a jail
Both parameters are disabled by default (equals the behavior before
devfs and nullfs in jails). Administrators have to explicitly allow
mounting devfs and nullfs for each jail. The value "-1" of the
devfs_ruleset parameter is removed in favor of the new allow setting.
Reviewed by: jamie
Suggested by: pjd
MFC after: 2 weeks
to the debugger. When reparenting for debugging, keep the child in
the new orphan list of old parent. When looping over the children in
kern_wait(), iterate over both children list and orphan list to search
for the process by pid.
Submitted by: Dmitry Mikulin <dmitrym juniper.net>
MFC after: 2 weeks
UMTX_OP_WAIT. Upper 16bits is enough to hold a clock id, and lower
16bits is used to pass flags. The change saves a clock_gettime() syscall
from libthr.
Add the sysctl debug.iosize_max_clamp, enabled by default. Setting the
sysctl to zero allows to perform the SSIZE_MAX-sized i/o requests from
the usermode.
Discussed with: bde, das (previous versions)
MFC after: 1 month
Vnode-backed mappings cannot be put into the kernel map, since it is a
system map.
Use exec_map for transient mappings, and remove the mappings with
kmem_free_wakeup() to notify the waiters on available map space.
Do not map the whole executable into KVA at all to copy it out into
usermode. Directly use vn_rdwr() for the case of not page aligned
binary.
There is one place left where the potentially unbounded amount of data
is mapped into exec_map, namely, in the COFF image activator
enumeration of the needed shared libraries.
Reviewed by: alc
MFC after: 2 weeks
messages were printed.
This can be enabled with the kern.msgbuf_show_timestamp sysctl
PR: kern/161553
Reviewed by: avg
Submitted by: Arnaud Lacombe <lacombar@gmail.com>
Approved by: cperciva
MFC after: 1 month
A new jail(8) option "devfs_ruleset" defines the ruleset enforcement for
mounting devfs inside jails. A value of -1 disables mounting devfs in
jails, a value of zero means no restrictions. Nested jails can only
have mounting devfs disabled or inherit parent's enforcement as jails are
not allowed to view or manipulate devfs(8) rules.
Utilizes new functions introduced in r231265.
Reviewed by: jamie
MFC after: 1 month
