completely full, we'd not complete any of the mbufs due to the fence
post error (this creates a large leak). When this is fixed, we still
leak, but at a much smaller rate due to a race between ateintr and
atestart_locked as well as an asymmetry where atestart_locked is
called from elsewhere. Ensure that we free in-flight packets that
have completed there as well. Also remove needless check for NULL on
mb, checked earlier in the loop and simplify a redundant if.
MFC after: 3 days
this change we may end up with a panic (Fatal kernel mode data abort:
'External Non-Linefetch Abort (S)') as described in
http://e2e.ti.com/support/arm/sitara_arm/f/791/t/276862.aspx.
It is now possible to bring up I2C1 and I2C2 on BBB.
Approved by: adrian (mentor)
vm_max_virtual_address to be KERNVIRTADDR + 256MB. This allows some
future shock protection since the KVA requirements have gone up since
the unmapped changes have gone in, as well as preventing us from
overlapping with the hardware devices, which we map at 0xd0000000,
which we'd hit with anything more than 85MB...
MFC after: 3 days
always returning '0' for all the reads, even for the outputs. It is now
known to work with gpioiic(4) and gpioled(4).
Approved by: adrian (mentor)
Tested on: BBB
shifts into the sign bit. Instead use (1U << 31) which gets the
expected result.
This fix is not ideal as it assumes a 32 bit int, but does fix the issue
for most cases.
A similar change was made in OpenBSD.
Discussed with: -arch, rdivacky
Reviewed by: cperciva
enables data cache and other chip-specific features. It was previously
done via an early SYSINIT, but it was being done after pmap and vm setup,
and those setups need to use mutexes. On some modern ARM platforms,
the ldrex/strex instructions that implement mutexes require the data cache
to be enabled.
A nice side effect of enabling caching earlier is that it eliminates the
multi-second pause that used to happen early in boot while physical memory
and pmap and vm were being set up. On boards with 1 GB or more of ram
this pause was very noticible, sometimes 5-6 seconds.
PR: arm/183740
When entering a mapping via pmap_enter() unmanaged pages ought to be
naturally excluded from the "modified" and "referenced" emulation.
RW permission should be granted implicitly when requested,
otherwise unmanaged page will not recover from the permission fault
since there will be no PV entry to indicate that the page can be written.
In addition, only managed pages that participate in "modified"
emulation need to be marked as "dirty" and "writeable" when entered
with RW permissions. Likewise with "referenced" flag for managed pages.
Unmanaged ones however should not be marked as such.
Reviewed by: cognet, gber
When emulating modified bit the executable attribute was cleared by
mistake when calling pmap_set_prot(). This was not a problem before
changes to ref/mod emulation since all the pages were created RW basing
on the "prot" argument in pmap_enter(). Now however not all pages are RW
and the RW permission can be cleared in the process.
Added proper KTRs accordingly.
Spotted by: cognet
Reviewed by: gber
host.host_ocr, examine the correct field when setting up the hardware. Also,
the offset for the capabilties register should be 0x140, not 0x240.
Submitted by: Ilya Bakulin <ilya@bakulin.de>
Pointy hat to: me
rely only on checking the device unit to indentify the BSC unit we are
attaching to. Make use of the device base address to identify our BSC unit.
Approved by: adrian (mentor)
words, every architecture is now auto-sizing the kmem arena. This revision
changes kmeminit() so that the definition of VM_KMEM_SIZE_SCALE becomes
mandatory and the definition of VM_KMEM_SIZE becomes optional.
Replace or eliminate all existing definitions of VM_KMEM_SIZE. With
auto-sizing enabled, VM_KMEM_SIZE effectively became an alternate spelling
for VM_KMEM_SIZE_MIN on most architectures. Use VM_KMEM_SIZE_MIN for
clarity.
Change kmeminit() so that the effect of defining VM_KMEM_SIZE is similar to
that of setting the tunable vm.kmem_size. Whereas the macros
VM_KMEM_SIZE_{MAX,MIN,SCALE} have had the same effect as the tunables
vm.kmem_size_{max,min,scale}, the effects of VM_KMEM_SIZE and vm.kmem_size
have been distinct. In particular, whereas VM_KMEM_SIZE was overridden by
VM_KMEM_SIZE_{MAX,MIN,SCALE} and vm.kmem_size_{max,min,scale}, vm.kmem_size
was not. Remedy this inconsistency. Now, VM_KMEM_SIZE can be used to set
the size of the kmem arena at compile-time without that value being
overridden by auto-sizing.
Update the nearby comments to reflect the kmem submap being replaced by the
kmem arena. Stop duplicating the auto-sizing formula in every machine-
dependent vmparam.h and place it in kmeminit() where auto-sizing takes
place.
Reviewed by: kib (an earlier version)
Sponsored by: EMC / Isilon Storage Division
fdtbus in most cases. This brings ARM and MIPS more in line with existing
Open Firmware platforms like sparc64 and powerpc, as well as preventing
double-enumeration of the OF tree on embedded PowerPC (first through nexus,
then through fdtbus).
This change is also designed to simplify resource management on FDT platforms
by letting there exist a platform-defined root bus resource_activate() call
instead of replying on fdtbus to do the right thing through fdt_bs_tag.
The OFW_BUS_MAP_INTR() and OFW_BUS_CONFIG_INTR() kobj methods are also
available to implement for similar purposes.
Discussed on: -arm, -mips
Tested by: zbb, brooks, imp, and others
MFC after: 6 weeks
