register, in addition to configuring it as input with the pinmux driver.
There was a control register bit commented as "no desc in datasheet". A
later revision of the manual reveals the bit to be an input/output control
for the timer pin. In addition to configuring capture or pulse mode, you
apparently have to separately configure the pin direction in the timer
control register.
Before this change, the timer block was apparently driving a signal onto a
pad configured by pinmux as input. Capture mode still accidentally worked
for me during testing because I was using a very strong signal source that
just out-muscled the weaker drive from the misconfigured pin.
descriptor state will not change anymore). This seems to eliminate the
race where we can miss a stalled queue under high load.
While here remove the unnecessary curly brackets.
Reported by: Konstantin Kormashev <konstantin@netgate.com>
MFC after: 3 days
Sponsored by: Rubicon Communications, LLC (Netgate)
- Pad small packets to 60 bytes and not 64 (exclude the CRC bytes);
- Pad the packet using m_append(9), if the packet has enough space for
padding, which is usually true, it will not be necessary append a newly
allocated mbuf to the chain.
Suggested by: yongari
MFC after: 3 days
Sponsored by: Rubicon Communications, LLC (Netgate)
disabled (Hi netmap!).
Only remove the CRC bytes from packets when the hardware tell us to do so.
Fixes the 'discard frame w/o leading ethernet header' issues.
Sponsored by: Rubicon Communications, LLC (Netgate)
As cs is stored in a uint32_t, use the last bit to store the
active high flag as it's unlikely that we will have that much CS.
Reviewed by: loos
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D8614
Replace them with a default handler that returns devmap_lastaddr.
Reviewed by: mmel
Sponsored by: ABT Systems Ltd
Differential Revision: https://reviews.freebsd.org/D8806
miibus_writereg.
Reduce the DELAY() between reads while waiting for MII access.
Spotted by: yongari
Sponsored by: Rubicon Communications, LLC (Netgate)
Writing the full queue size to it every time was makeing it overflow with a
lot of bogus values.
This fixes the interrupt storms on irq 40.
Sponsored by: Rubicon Communications, LLC (Netgate)
Adds VLAN and port management abilities for etherswitchcfg(8).
The code is conditionally enabled for now, because it is not necessary on
single ethernet use cases.
Obtained from: pfSense
MFC after: 2 weeks
Sponsored by: Rubicon Communications, LLC (Netgate)
Use "ti,am33xx" instead of "ti,am335x", which gives an exact match in every
DTS we support.
This fixes the boot on TI SoCs after r308533.
Suggested by: gonzo
Sponsored by: Rubicon Communications, LLC (Netgate)
the aintc driver for Allwinner A10.
This fixes the boot of the GENERIC ARM kernel on TI/AM335x SoCs.
Sponsored by: Rubicon Communications, LLC (Netgate)
When detaching device trees parent devices must be detached prior to
detaching its children. This is because parent devices can have
pointers to the child devices in their softcs which are not
invalidated by device_delete_child(). This can cause use after free
issues and panic().
Device drivers implementing trees, must ensure its detach function
detaches or deletes all its children before returning.
While at it remove now redundant device_detach() calls before
device_delete_child() and device_delete_children(), mostly in
the USB controller drivers.
Tested by: Jan Henrik Sylvester <me@janh.de>
Reviewed by: jhb
Differential Revision: https://reviews.freebsd.org/D8070
MFC after: 2 weeks
- Fix RX and TX teardown:
. TX teardown would not reclaim the abandoned descriptors;
. Interrupt storms in RX teardown;
. Fixed the acknowledge of the teardown completion interrupt.
- Remove temporary lists for the descriptors;
- Simplified the descriptor handling (less writes and reads from
descriptors where possible);
- Better debug;
- Add support for the RX threshold interrupts:
With interrupt moderation only, an RX overrun is likely to happen. The
RX threshold is set to trigger a non paced interrupt everytime your RX
free buffers are under the minimum threshold, helping to prevent the rx
overrun.
The NIC now survive when pushed over its limits (where previously it would
lock up in a few seconds).
uFW (600MHz SoC) can now forward up to 560Mb/s of UDP traffic (netmap
pkt-gen as source and sink). TCP forwarding rate is over 350Mb/s.
No difference (other than CPU use) was seen on Beaglebone black (1GHz SoC)
for his fast ethernet.
Tested on: uFW, BBB
Sponsored by: Rubicon Communications, LLC (Netgate)
for later Cortex-A CPUs that support the Multiprocessor Extensions. This
will be needed to support both in a single GENERIC kernel while still
being able to only build for a single SoC.
Reviewed by: mmel
Relnotes: yes
Sponsored by: ABT Systems Ltd
Differential Revision: https://reviews.freebsd.org/D8138
descriptors are reclaimed as soon as possible.
Without this the free buffers are reclaimed only on watchdog runs or after
trying to enqueue more packets.
Sponsored by: Rubicon Communications, LLC (Netgte)
- Convert "options EVDEV" to "device evdev" and "device uinput", add
modules for both new devices. They are isolated subsystems and do not
require any compile-time changes to general kernel subsytems
- For hybrid drivers that have evdev as an optional way to deliver input
events add option EVDEV_SUPPORT. Update all existing hybrid drivers
to use it instead of EVDEV
- Remove no-op DECLARE_MODULE in evdev, it's not required, MODULE_VERSION
is enough
- Add evdev module dependency to uinput
Submitted by: Vladimir Kondratiev <wulf@cicgroup.ru>
