PAGE_SIZE or less, the bounce page counting logic was flawed and wouldn't
reserve any pages. Adjust to be correct. Review of other architectures is
forthcoming.
Submitted by: Joseph Golio
aligned (or at least not cross a page boundary). However, it turns out
that on at least one machine one table header does cross a page boundary.
This caused problems with the MADT early probe as it uses the crash dump
map to load ACPI tables by loading the RSDT/XSDT into pages 1 ... N and
loading the header of each ACPI table header into page 0 looking for the
MADT. However, if a table header crossed a page boundary, then page 1
would get trashed resulting in a panic. Fix this by reserving the first
2 pages for ACPI table headers (headers are less than a page in size,
so 2 pages will be sufficient) and use pages 2 .. N for the RSDT and XSDT.
Note: amd64 should probably be simplified to just use pmap_mapbios()
for all these tables which will use the direct map and not need the
crash dump hack.
MFC after: 5 days
Tested on: i386
Reported by: Pete French petefrench of ticketswitch.com
compiled under PMAP_DIAGNOSTIC are now KASSERT()s. (Note: The kernel
option DIAGNOSTIC still disables inlining of certain pmap functions.)
Eliminate dead code from pmap_enter(). This code implemented an assertion.
On i386, an equivalent check is already implemented. However, on amd64,
a small change is required to implement an equivalent check.
Eliminate \n from a nearby panic string.
Use KASSERT() to reimplement pmap_copy()'s two assertions.
conjuction with 'thread' argument passing which is always curthread.
Remove the unuseful extra-argument and pass explicitly curthread to lower
layer functions, when necessary.
KPI results broken by this change, which should affect several ports, so
version bumping and manpage update will be further committed.
Tested by: kris, pho, Diego Sardina <siarodx at gmail dot com>
of fpget*() and fpset*()).
The i386 fpget*() were efficient but a bit obfuscated (using macros
and a case statement to demultiplex them through a single inline).
The demultiplexing mainly gave smaller source code.
The i386 fpset*() were obfuscated in the same way and were very
inefficient due to the case statement not having enough cases or
complexity so all cases used the FP environment.
This also fixes a harmless bug in rev.1.12. fpsetmask() extracted the
old value from the bit-field twice, but the doubled shift was harmless
since the shift count is 0.
All fp*() interfaces are now inline functions on i386. They used to
be macros that call (a different set of) inline functions. This is a
small ABI change which shouldn't cause problems since cases where
inlining fails (mainly -O0) only give (working) static functions.
others can be replaced cleanly by the amd64 versions. There is no
current amd64 version to merge, but there is an old one which is
similar.
Fix the following bugs in fpresetsticky():
- garbage args clobbered non-sticky bits in the status register
- the return value was usually garbage since it was masked with the
arg instead of with the field selector.
Optimize fpresetsticky() to avoid using the environment as in
feclearexcept() (use only fnclex() if possible) and also to avoid
using fnclex() for null changes. The second of these optimizations
might not be so good since its branch might cost more than it saves.
Remove this argument and pass curthread directly to underlying
VOP_LOCK1() VFS method. This modify makes the code cleaner and in
particular remove an annoying dependence helping next lockmgr() cleanup.
KPI results, obviously, changed.
Manpage and FreeBSD_version will be updated through further commits.
As a side note, would be valuable to say that next commits will address
a similar cleanup about VFS methods, in particular vop_lock1 and
vop_unlock.
Tested by: Diego Sardina <siarodx at gmail dot com>,
Andrea Di Pasquale <whyx dot it at gmail dot com>
pv_list_count from struct md_page. Ever since Peter rewrote the pv
entry allocator for amd64 and i386 pv_list_count has been correctly
maintained but otherwise unused.
instead of writing apologetic comments. As it turns out, I need every
kernel page table page to have a legitimate pindex to support superpage
promotion on kernel memory.
Correct a nearby style error: Pointers should be compared to NULL.
implemented with macros. This patch improves code readability. Reasoning
behind vidd_* is a sort of "video discipline".
List of macros is supposed to be complete--all methods of video_switch
ought to have their respective macros from now on.
Functionally, this code should be no-op. My intention is to leave current
behaviour of touched code as is.
No objections: rwatson
Silence on: freebsd-current@
Approved by: cognet
for that argument. This will allow DDB to detect the broad category of
reason why the debugger has been entered, which it can use for the
purposes of deciding which DDB script to run.
Assign approximate why values to all current consumers of the
kdb_enter() interface.
old code special cased them too early which caused a few differences for
these sort of links relative to other PCI links:
- They were always re-routed via the BIOS call instead of assuming that
they were already routed if the BIOS had programmed the IRQ into a
matching device during POST.
- If the BIOS did route that link to a different IRQ that was marked as
invalid, we trusted the $PIR table rather than the BIOS IRQ.
This change moves the special casing for "unique IRQ" links to only take
that into account when picking an IRQ for an unrouted link so that these
links will now not be routed if the BIOS appears to have routed it already
(some BIOSen have problems with that) and so that if the BIOS uses a
different IRQ than the $PIR, we trust the BIOS routing instead (this is
what we do for all other links as well).
Reported by: Bruce Walter walter of fortean com
MFC after: 1 week
cards:
o RocketRAID 172x series
o RocketRAID 174x series
o RocketRAID 2210
o RocketRAID 222x series
o RocketRAID 2240
o RocketRAID 230x series
o RocketRAID 231x series
o RocketRAID 232x series
o RocketRAID 2340
o RocketRAID 2522
Many thanks to Highpoint for their continued support of FreeBSD.
Submitted by: Highpoint
register (MacBooks only).
This allows MacBooks to boot in SMP mode without any trick and solves
the timer problems with HZ=1000.
MFC after: 1 week
Reviewed by: njl (mentor), jhb
Approved by: njl (mentor), jhb
with insufficient protection mode.
For the i386 and amd64, create the tunable, machdep.prot_fault_translation,
with the following behaviour:
0 = autodetect the signal to be delivered on KERN_PROTECTION_FAILURE
from vm_fault based on the ELF OSABI note:
no note or __FreeBSD_version < 700004 - SIGBUS/BUS_PAGE_FAULT
note, and __FreeBSD_version >= 700004 - SIGSEGV/SEGV_ACCERR
1 = always SIGBUS/BUS_PAGE_FAULT
2 = always SIGSEGV/SEGV_ACCERR
This would do mostly automatic correction of ABI breakage, with the exception
of the untaged binaries for 7-CURRENT/RELENG_7 before the note is fixed. For
them, sysctl would allow to run the binary with manual settings.
Discussed with: portmgr (kris)
PR: kern/118304
MFC after: 3 days
- Introduce per-architecture stack_machdep.c to hold stack_save(9).
- Introduce per-architecture machine/stack.h to capture any common
definitions required between db_trace.c and stack_machdep.c.
- Add new kernel option "options STACK"; we will build in stack(9) if it is
defined, or also if "options DDB" is defined to provide compatibility
with existing users of stack(9).
Add new stack_save_td(9) function, which allows the capture of a stacktrace
of another thread rather than the current thread, which the existing
stack_save(9) was limited to. It requires that the thread be neither
swapped out nor running, which is the responsibility of the consumer to
enforce.
Update stack(9) man page.
Build tested: amd64, arm, i386, ia64, powerpc, sparc64, sun4v
Runtime tested: amd64 (rwatson), arm (cognet), i386 (rwatson)
allocation fails and pv entries are reclaimed, there may be an unused pv
entry in a pv chunk that survived the reclamation. However, previously,
after reclamation, get_pv_entry() did not look for an unused pv entry in
a surviving pv chunk; it simply retried the page allocation. Now, it
does look for an unused pv entry before retrying the page allocation.
Note: This only applies to RELENG_7. Earlier branches use a different
pv entry allocator.
MFC after: 6 weeks
since the branch caches on at least Athlon XP through Athlon 64 CPU's
don't understand such instructions and guarantee a cache miss taking
at least 10 cycles. Use the documented workaround "ret $0" instead
("nop; ret" also works, but "ret $0" is probably faster on old CPUs).
Normal code (even asm code) doesn't branch to "ret", since there is
usually some cleanup to do, but the __mcount, .mcount and .mexitcount
entry points were optimized too well to have the minimum number of
instructions (3 instructions each if profiling is not enabled) and
they did this. I didn't see a significant number of cache misses for
.mexitcount, but for the shared "ret" for __mcount and .mcount I
observed cache misses costing 26 cycles each. For a send(2) syscall
that makes about 70 function calls, the cost of these cache misses
alone increased the syscall time from about 4000 cycles to about 7000
cycles. 4000 is for a profiling (GUPROF) kernel with profiling disabled;
after this fix, configuring profiling only costs about 600 cycles in the
4000, which is consistent with almost perfect branch prediction in the
mcounting calls.
unused except to obfuscate disassemblies. -mprofiler-epilogue is
currently with gcc-4 (it does too little), but -finstrument-functions
is broken in a different way (it does too much).
amd64 version: meger whitespace fixes from i386 version.
- On amd64, just assume type #1 is always used. PCI 2.0 mandated
deprecated type #2 and required type #1 for all future bridges which
was well before amd64 existed.
- For i386, ignore whatever value was in 0xcf8 before testing for type #1
and instead rely on the other tests to determine if type #1 works. Some
newer machines leave garbage in 0xcf8 during boot and as a result the
kernel doesn't find PCI at all (which greatly confuses ACPI which expects
PCI to exist when PCI busses are in the namespace).
MFC after: 3 days
Discussed with: scottl
Currently, Giant is not too much contented so that it is ok to treact it
like any other mutexes.
Please don't forget to update your own custom config kernel files.
Approved by: cognet, marcel (maintainers of arches where option is
not enabled at the moment)
routine. It is not needed as the existing tests for segment coalescing
already handle bounced addresses and it prevents legal segment coalescing
in certain edge cases.
MFC after: 1 week
Reviewed by: scottl
include the ithread scheduling step. Without this, a preemption might
occur in between the interrupt getting masked and the ithread getting
scheduled. Since the interrupt handler runs in the context of curthread,
the scheudler might see it as having a such a low priority on a busy system
that it doesn't get to run for a _long_ time, leaving the interrupt stranded
in a disabled state. The only way that the preemption can happen is by
a fast/filter handler triggering a schduling event earlier in the handler,
so this problem can only happen for cases where an interrupt is being
shared by both a fast/filter handler and an ithread handler. Unfortunately,
it seems to be common for this sharing to happen with network and USB
devices, for example. This fixes many of the mysterious TCP session
timeouts and NIC watchdogs that were being reported. Many thanks to Sam
Lefler for getting to the bottom of this problem.
Reviewed by: jhb, jeff, silby
First, a file is mmap(2)ed and then mlock(2)ed. Later, it is truncated.
Under "normal" circumstances, i.e., when the file is not mlock(2)ed, the
pages beyond the EOF are unmapped and freed. However, when the file is
mlock(2)ed, the pages beyond the EOF are unmapped but not freed because
they have a non-zero wire count. This can be a mistake. Specifically,
it is a mistake if the sole reason why the pages are wired is because of
wired, managed mappings. Previously, unmapping the pages destroys these
wired, managed mappings, but does not reduce the pages' wire count.
Consequently, when the file is unmapped, the pages are not unwired
because the wired mapping has been destroyed. Moreover, when the vm
object is finally destroyed, the pages are leaked because they are still
wired. The fix is to reduce the pages' wired count by the number of
wired, managed mappings destroyed. To do this, I introduce a new pmap
function pmap_page_wired_mappings() that returns the number of managed
mappings to the given physical page that are wired, and I use this
function in vm_object_page_remove().
Reviewed by: tegge
MFC after: 6 weeks
