* WPA-None requires ap_scan=2:
The major difference between ap_scan=1 (default) and 2 is, that no
IEEE80211_IOC_SCAN* ioctls/functions are called, though, there is a
dependency on those. For example the call to wpa_driver_bsd_scan()
sets the interface UP, this never happens, therefore the interface
must be marked up in wpa_driver_bsd_associate(). IEEE80211_IOC_SSID
also is not called, which means that the SSID has not been set prior
to the IEEE80211_MLME_ASSOC call.
* WPA-None has no support for sequence number updates, it doesn't make
sense to check for replay violations..
* I had some crashes right after the switch to RUN state, issue is
that sc->sc_lastrs was not yet defined.
Approved by: rpaulo (mentor)
MFC after: 3 weeks
for it's unix domain socket. Before this change wpa_cli would take
the first file in the directory that was not "." or "..".
Submitted by: Brandon Gooch <jamesbrandongooch@gmail.com>
MFC after: 3 days
could be handled w/o fragmentation but clobbers user-specified values
such as those required when the interface is bridged.
Submitted by: jim@netgate.com
Reviewed by: Jouni Malinen
MFC after: 3 days
In particular, vendor sources that aren't ready for gnu99 should
still be compiled with gnu89. (Before r189824, these would have
generated warnings if you tried to compile them in gnu99 mode,
but the warnings went unheeded due to -Wno-error.)
directory [1]
- add the FILES section to the wpa_supplicant.conf.5 file, so that people
will be able to detect the example configuration file easier. [2]
PR: docs/121821 [2]
Approved by: brooks [1]
MFC after: 3 days
wpa_supplicant expects that it has exclusive access to the net80211 state so
when its starts poking in the WEP/WPA settings and the card is already
scanning it can cause net80211 to try and associate incorrectly with a
protected AP.
This is an inconvenience for firmware based cards such as iwi where it can be
sent an auth instruction with incomplete security info and cause a firmware
error.
Remove the 'ifconfig up' from network.subr since wpa_supplicant will
immediately down the interface again.
Reported by: Guy Helmer (and others)
Reviewed by: sam, brooks, avatar
MFC after: 3 days
WPA_SUPPLICANT_CFLAGS, etc. (consult the Makefile's for details)
o enable ipv6 support in hostapd (for communication w/ a radius backend)
PR: bin/116164
Submitted by: "Scot Hetzel" <swhetzel@gmail.com>
Approved by: re (gnn)
MFC after: 2 weeks
FreeBSD 6.2, but it didn't make it into RELENG_6_2.
Update the manual page to say "FreeBSD 6.3".
PR: docs/114429
Submitted by: Henrik Brix Andersen <henrik@brixandersen.dk>
MFC after: 3 days
Approved by: re (bmah)
o unix domain socket to wpa_cli is configured w/ CONFIG_CTRL_IFACE_UNIX
o terminate on last interface option is configured w/ CONFIG_TERMINATE_ONLASTIF
o ndis/Packet32.c fixups to force roaming mode to manual
o document new mixed_cell config knob
Submitted by: thompsa (Packet32.c)
Reviewed by: thompsa, sephe
Approved by: re (hrs)
