the syscalls that are not implemented in Linux kernel itself.
Cleanup DUMMY() macros.
Reviewed by: dchagin, trasz
Approved by: dchagin
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D9804
Renumber cluase 4 to 3, per what everybody else did when BSD granted
them permission to remove clause 3. My insistance on keeping the same
numbering for legal reasons is too pedantic, so give up on that point.
Submitted by: Jan Schaumann <jschauma@stevens.edu>
Pull Request: https://github.com/freebsd/freebsd/pull/96
Otherwise kernel traps on NULL dereference if fpu_kern(9) is used from the
thread0 context.
Reported by: cem
Reviewed by: cem, jhb
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
PG_PROMOTED, that indicates whether lingering 4KB page mappings might
need to be flushed on a PDE change that restricts or destroys a 2MB
page mapping. This flag allows the pmap to avoid range invalidations
that are both unnecessary and costly.
Reviewed by: kib, markj
MFC after: 6 weeks
Differential Revision: https://reviews.freebsd.org/D9665
show pte from the pmap of the process of the current DDB thread, instead
of necessarily the PCPU pmap.
Submitted by: Ryan Libby <rlibby@gmail.com>
Reviewed by: kib
MFC after: 1 week
Sponsored by: Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D9645
This also adds support for LINUX_ARCH_SET_GS.
Reviewed by: dchagin
MFC after: 2 weeks
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D9372
For the loop that dirties vm_pages in case superpage was written to,
check the complete condition before the loop.
Reviewed by: alc
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
Implement get_pcpu() for amd64/sparc64/mips/powerpc, and use it to
replace pcpu_find(curcpu) in MI code.
Reviewed by: andreast, kan, lidl
Tested by: lidl(mips, sparc64), andreast(powerpc)
Differential Revision: https://reviews.freebsd.org/D9587
MTRR handlers are set in {amd64/i686}_mem_drvinit, which is called at
SI_SUB_DRIVERS, and that's too late when EARLY_AP_STARTUP is set because APs
have already started at this point. {amd64/i686}_mrinit is also called too late
for the BSP, since that happens when the memory device is attached, also after
APs have already started.
Move the position to SI_SUB_CPU, and also initialize the state for the BSP, so
that the APs can correctly get to the same state as the BSP.
Sponsored by: Citrix Systems R&D
MFC after: 1 week
Reviewed by: jhb, kib
Differential Revision: https://reviews.freebsd.org/D9630
but it allows to use 64 bit linux strace(1) on 64 bit linux binaries.
Reviewed by: dchagin (earlier version)
MFC after: 2 weeks
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D9406
Refresh upstream driver before impending conversion to iflib.
Major new features:
- Support for Fortville-based 25G adapters
- Support for I2C reads/writes
(To prevent getting or sending corrupt data, you should set
dev.ixl.0.debug.disable_fw_link_management=1 when using I2C
[this will disable link!], then set it to 0 when done. The driver implements
the SIOCGI2C ioctl, so ifconfig -v works for reading I2C data,
but there are read_i2c and write_i2c sysctls under the .debug sysctl tree
[the latter being useful for upper page support in QSFP+]).
- Addition of an iWARP client interface (so the future iWARP driver for
X722 devices can communicate with the base driver).
- Compiling this option in is enabled by default, with "options IXL_IW" in
GENERIC.
Differential Revision: https://reviews.freebsd.org/D9227
Reviewed by: sbruno
MFC after: 2 weeks
Sponsored by: Intel Corporation
and wrong numbering for a few unimplemented syscalls.
For 32-bit Linuxulator, socketcall() syscall was historically
the entry point for the sockets API. Starting in Linux 4.3, direct
syscalls are provided for the sockets API. Enable it.
The initial version of patch was provided by trasz@ and extended by me.
Submitted by: trasz
MFC after: 2 week
Differential Revision: https://reviews.freebsd.org/D9381
The switch to get_pcpu() in MI code seems to cause hangs on MIPS.
Back out until we can get a better idea of what's happening there.
Reported by: kan, lidl
protection change.
On superpage promotion, x86 pmaps do not invalidate existing 4K
entries for the superpage range, because they are compatible with the
promoted 2/4M entry. But the invalidation on superpage removal or
protection change only did single INVLPG with the base address of the
superpage. This reliably flushed superpage TLB entry, and 4K entry
for the first page of the superpage, potentially leaving other 4K TLB
entries lingering. Do the invalidation of the whole superpage range
to correct the problem.
Note that the precise invalidation is done by x86 code for kernel_pmap
only, for user pmaps whole (per-AS) TLB is flushed. This made the bug
well hidden, because promotions of the kernel mappings require
specific load.
Reported and tested by: Jonathan Looney <jtl@netflix.com> (previous version)
Reviewed by: alc
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
SDM states that CLFLUSHOPT instructions can be ordered with other
writes by SFENCE, heavier MFENCE is not required.
Reviewed by: alc
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
The error is:
vmm_dev.c: In function 'alloc_memseg':
vmm_dev.c:261:11: error: null argument where non-null required (argument 1) [-Werror=nonnull]
Apparently, the gcc is unable to figure out that if a ternary operator
produced a non-NULL value once, then the operator with exactly the same
operands would produce the same value again.
MFC after: 1 week
We would previously invalidate such entries individually, resulting in more
IPIs than necessary.
Reviewed by: alc, kib
MFC after: 3 weeks
Differential Revision: https://reviews.freebsd.org/D9094
- em(4) igb(4) and lem(4)
- deprecate the igb device from kernel configurations
- create a symbolic link in /boot/kernel from if_em.ko to if_igb.ko
Devices tested:
- 82574L
- I218-LM
- 82546GB
- 82579LM
- I350
- I217
Please report problems to freebsd-net@freebsd.org
Partial review from jhb and suggestions on how to *not* brick folks who
originally would have lost their igbX device.
Submitted by: mmacy@nextbsd.org
MFC after: 2 weeks
Relnotes: yes
Sponsored by: Limelight Networks and Dell EMC Isilon
Differential Revision: https://reviews.freebsd.org/D8299
hammer_time(). This makes assembler exception handlers not fault
itself when setting PCB flags, and allow normal kernel trap handler to
get control. The pointer is reset after FPU parameters are obtained.
Set thread0.td_critnest to 1 for duration of hammer_time() as well.
In particular, page faults at that early stage panic immediately
instead of trying to call not yet operational VM to resolve it.
As result, faults during second half of the hammer_time() execution
have a chance to be reported instead of silent machine reboot or hang.
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Changes include modifications in kernel crash dump routines, dumpon(8) and
savecore(8). A new tool called decryptcore(8) was added.
A new DIOCSKERNELDUMP I/O control was added to send a kernel crash dump
configuration in the diocskerneldump_arg structure to the kernel.
The old DIOCSKERNELDUMP I/O control was renamed to DIOCSKERNELDUMP_FREEBSD11 for
backward ABI compatibility.
dumpon(8) generates an one-time random symmetric key and encrypts it using
an RSA public key in capability mode. Currently only AES-256-CBC is supported
but EKCD was designed to implement support for other algorithms in the future.
The public key is chosen using the -k flag. The dumpon rc(8) script can do this
automatically during startup using the dumppubkey rc.conf(5) variable. Once the
keys are calculated dumpon sends them to the kernel via DIOCSKERNELDUMP I/O
control.
When the kernel receives the DIOCSKERNELDUMP I/O control it generates a random
IV and sets up the key schedule for the specified algorithm. Each time the
kernel tries to write a crash dump to the dump device, the IV is replaced by
a SHA-256 hash of the previous value. This is intended to make a possible
differential cryptanalysis harder since it is possible to write multiple crash
dumps without reboot by repeating the following commands:
# sysctl debug.kdb.enter=1
db> call doadump(0)
db> continue
# savecore
A kernel dump key consists of an algorithm identifier, an IV and an encrypted
symmetric key. The kernel dump key size is included in a kernel dump header.
The size is an unsigned 32-bit integer and it is aligned to a block size.
The header structure has 512 bytes to match the block size so it was required to
make a panic string 4 bytes shorter to add a new field to the header structure.
If the kernel dump key size in the header is nonzero it is assumed that the
kernel dump key is placed after the first header on the dump device and the core
dump is encrypted.
Separate functions were implemented to write the kernel dump header and the
kernel dump key as they need to be unencrypted. The dump_write function encrypts
data if the kernel was compiled with the EKCD option. Encrypted kernel textdumps
are not supported due to the way they are constructed which makes it impossible
to use the CBC mode for encryption. It should be also noted that textdumps don't
contain sensitive data by design as a user decides what information should be
dumped.
savecore(8) writes the kernel dump key to a key.# file if its size in the header
is nonzero. # is the number of the current core dump.
decryptcore(8) decrypts the core dump using a private RSA key and the kernel
dump key. This is performed by a child process in capability mode.
If the decryption was not successful the parent process removes a partially
decrypted core dump.
Description on how to encrypt crash dumps was added to the decryptcore(8),
dumpon(8), rc.conf(5) and savecore(8) manual pages.
EKCD was tested on amd64 using bhyve and i386, mipsel and sparc64 using QEMU.
The feature still has to be tested on arm and arm64 as it wasn't possible to run
FreeBSD due to the problems with QEMU emulation and lack of hardware.
Designed by: def, pjd
Reviewed by: cem, oshogbo, pjd
Partial review: delphij, emaste, jhb, kib
Approved by: pjd (mentor)
Differential Revision: https://reviews.freebsd.org/D4712
module loading is successful, but attempts to use it will not be
successful. This is similar to what we do (did?) with ACPI on non-ACPI
systems. We succeed if we can't find the necessary information to hook
into EFI, but still fail if we're unable to allocate resources if we
do find EFI.
Not Objected to by: kib@
MFC Afer: 3 days
