be a permanent rule, because this device may eventually be deemed
"effectively compulsory", and built by default directly into the
kernel. For the moment, however, this is useful for debugging and
development.
Reviewed by: dfr
This is work-in-progress, and the entropy-gathering routines are not
yet present. As such, this should be viewed as a pretty reasonable
PRNG with _ABSOLUTELY_NO_ security!!
Entropy gathering will be the subject of ongoing work.
This is written as a module, and as such is unloadable, but there is
no refcounting done. I would like to use something like device_busy(9)
to achieve this (eventually).
Lots of useful ideas from: bde, phk, Jeroen van Gelderen
Reviewed by: dfr
severely stripped down compared with its predecessor, and is measurably
a _lot_ faster.
Many thanks to Jeroen van Gelderen for lots of good ideas.
There is still a problem with this; it is written as a mudule, and as
such is theoretically unloadable. However, there is no refcounting done
as I would prefer to do that a'la device_busy(9), rather than some
"home-rolled" scheme. The point is pretty moot, as /dev/null is
effectively compulsory.
Reviewed by: dfr
the message to indicate that it could also be a disconnected cable, and
return okay from wx_hw_intialize *anyway*. This allows us to contineu to
set the station address and when we do get link up, we're ready to roll.
the PnP probe is merely a stub as we make assumptions about some of this
hardware before we have probed it.
Since these devices (with the exception of the speaker) are 'standard',
suppress output in the !bootverbose case to clean up the probe messages
somewhat.
1) while allocating a uidinfo struct malloc is called with M_WAITOK,
it's possible that while asleep another process by the same user
could have woken up earlier and inserted an entry into the uid
hash table. Having redundant entries causes inconsistancies that
we can't handle.
fix: do a non-waiting malloc, and if that fails then do a blocking
malloc, after waking up check that no one else has inserted an entry
for us already.
2) Because many checks for sbsize were done as "test then set" in a non
atomic manner it was possible to exceed the limits put up via races.
fix: instead of querying the count then setting, we just attempt to
set the count and leave it up to the function to return success or
failure.
3) The uidinfo code was inlining and repeating, lookups and insertions
and deletions needed to be in their own functions for clarity.
Reviewed by: green
When re-adding an event, do not reset the event state. If the event was
pending, it will remain pending. This allows the user to change the udata
field after the event was registered, while not losing any events which
have already occurred.
Reported by: jmg
