change 0 means success and non-zero means failure.
This also helps to eliminate VMEXIT_POWEROFF and VMEXIT_RESET as return values
from VM-exit handlers.
CR: D480
Reviewed by: grehan, jhb
- Allow a hostbridge to be created with AMD as a vendor.
This passes the OpenBSD check to allow the use of MSI
on a PCI bus.
- Enable the i/o interrupt section of the mptable, and
populate it with unity ISA mappings. This allows the
'legacy' IRQ mappings of the PCI serial port to be
set up. Delete unused print routine that was obscuring code.
- Use the '-W' option to enable virtio single-vector MSI
rather than an environment variable. Update the virtio
net/block drivers to query this flag when setting up
interrupts.: bhyverun.c
- Fix the arithmetic used to derive the century byte in
RTC CMOS, as well as encoding it in BCD.
Reviewed by: neel
MFC after: 3 days
'invpcid' instruction to the guest. Currently bhyve will try to enable this
capability unconditionally if it is available.
Consolidate code in bhyve to set the capabilities so it is no longer
duplicated in BSP and AP bringup.
Add a sysctl 'vm.pmap.invpcid_works' to display whether the 'invpcid'
instruction is available.
Reviewed by: grehan
MFC after: 3 days
these.
The mux-vcpus option may return at some point, given it's utility
in finding bhyve (and FreeBSD) bugs.
Approved by: re@ (blanket)
Discussed with: neel@
command line option "-m <memsize in MB>" to specify the memory size.
Prior to this change the user needed to explicitly specify the amount of
memory allocated below 4G (-m <lowmem>) and the amount above 4G (-M <highmem>).
The "-M" option is no longer supported by 'bhyveload' and 'bhyve'.
The start of the PCI hole is fixed at 3GB and cannot be directly changed
using command line options. However it is still possible to change this in
special circumstances via the 'vm_set_lowmem_limit()' API provided by
libvmmapi.
Submitted by: Dinakar Medavaram (initial version)
Reviewed by: grehan
Obtained from: NetApp
This seems prudent to do in its own right but it also opens up the possibility
of not having to mmap the entire guest address space in the 'bhyve' process
context.
Discussed with: grehan
Obtained from: NetApp
bhyve is intended to be a generic hypervisor, and not FreeBSD-specific.
(renaming internal routines will come later)
Reviewed by: neel
Obtained from: NetApp
