This turns on support for kernel dump encryption and compression, and
netdump. arm and mips platforms are omitted for now, since they are more
constrained and don't benefit as much from these features.
Reviewed by: cem, manu, rgrimes
Tested by: manu (arm64)
Relnotes: yes
Differential Revision: https://reviews.freebsd.org/D15465
is executed on the right stack already. No copy from the entry stack
to the kstack must be performed for vm86 bios call code to function.
To access the pcb flags on kernel entry, unconditionally switch to
kernel address space if vm86 mode is detected.
This fixes very early vm86 bios calls, typically done when boot is
performed by boot2 without loader, and kernel falls back to BIOS calls
to get SMAP.
Reported by: bde
Sponsored by: The FreeBSD Foundation
PCB_VM86CALL pcb flag not set should be treated same as return to
userspace.
Most important, the address space must be switched. This fixes
usermode vm86 operations after the 4/4 split.
Sponsored by: The FreeBSD Foundation
exception code is copied to the trampoline.
The correct value is then copied to trampoline automatically, so
tramp_idleptd_reloced can be eliminated.
This will allow to use the same exception entry code to handle traps
from vm86 bios calls on early boot stage, as after the trampoline is
configured.
Sponsored by: The FreeBSD Foundation
Record common_tssd, the descriptor to be written in GDT to point to
the common TSS, before LTR is executed. The LTR instruction sets the
loaded descriptor type to 386 TSS busy, which traps on reloads.
Sponsored by: The FreeBSD Foundation
Since pop %ss/mov %ss instructions defer all interrupts and exceptions
for the next instruction, it is possible that the userspace watchpoint
trap executes on the first instruction of the kernel entry for
syscall/bpt.
In this case, DB# should be treated similarly to NMI: on amd64 we must
always load GSBASE even if the trap comes from kernel mode, and load
the kernel page table root into %cr3. Moreover, the trap must
use the dedicated stack, because we are still on the user stack when
trapped on syscall entry.
For i386, we must reload %cr3. The syscall instruction is not configured,
so there is no issue with executing on user stack when trapping.
Due to some CPU erratas it is not always possible to detect that the
userspace watchpoint triggered by inspecting %dr6. In trap(), compare the
trap %rip with the known unsafe entry points and if matched pretend that
the watchpoint did not fire at all.
Thank you to the MSRC Incident Response Team, and in particular Greg
Lenti and Nate Warfield, for coordinating the response to this issue
across multiple vendors.
Thanks to Computer Recycling at The Working Center of Kitchener for
making hardware available to allow us to test the patch on additional
CPU families.
Reviewed by: jhb
Discussed with: Matthew Dillon
Tested by: emaste
Sponsored by: The FreeBSD Foundation
Security: CVE-2018-8897
Security: FreeBSD-SA-18:06.debugreg
Required MD bits are only provided for x86.
Reviewed by: jhb (previous version, as part of the larger patch)
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Differential revision: https://reviews.freebsd.org/D13838
This driver was for an early and uncommon legacy PCI 10GbE for a single
ASIC, Intel 82597EX. Intel quickly shifted to the long lived ixgbe family.
Submitted by: kbowling
Reviewed by: brooks imp jeffrey.e.pieper@intel.com
Relnotes: yes
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D15234
Dumpers may wish to print messages from an initialization hook; this
change ensures that such messages aren't mixed with output from the
generic dump code.
MFC after: 1 week
Use proper method to access userspace. For now, only the slow copyout
path is implemented.
Reported and tested by: tijl (previous version)
Sponsored by: The FreeBSD Foundation
Remove auxarg_size as it was only used once right after a confusing
assignment in each of the variants of exec_copyout_strings().
Reviewed by: emaste
MFC after: 1 month
Differential Revision: https://reviews.freebsd.org/D15123
This will allow to hook a ddb script to "kdb.enter.trap" event.
Previously there was no specific name for this event, so it could only
be handled by either "kdb.enter.unknown" or "kdb.enter.default" hooks.
Both are very unspecific.
Having a specific event is useful because the fatal trap condition is
very similar to panic but it has an additional property that the current
stack frame is the frame where the trap occurred. So, both a register
dump and a stack bottom dump have additional information that can help
analyze the problem.
I have added the event only on architectures that have trap_fatal()
function defined. I haven't looked at other architectures. Their
maintainers can add support for the event later.
Sample script:
kdb.enter.trap=bt; show reg; x/aS $rsp,20; x/agx $rsp,20
Reviewed by: kib, jhb, markj
MFC after: 11 days
Sponsored by: Panzura
Differential Revision: https://reviews.freebsd.org/D15093
Half of implementations always failed (returned (-1)) and they were
previously used in only one place.
Reviewed by: kib, andrew
Obtained from: CheriBSD
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D15102
'bool' is preferred to 'boolean_t'. We only get the boolean_t
definition by header pollution (though the same is true for
bool). Since we use both, switch entirely to bool.
Note: We still have TRUE/FALSE instead of true/false in heavy use in
the rest of the file. These are with ints of various flavors, so
that's appropriate, even though we should eventually migrate to bool
and true/false (though the tables they are in are nicely packed with
short and wouldn't be so nicely packed with bool, another reason
to leave it alone for now).
The change makes the user and kernel address spaces on i386
independent, giving each almost the full 4G of usable virtual addresses
except for one PDE at top used for trampoline and per-CPU trampoline
stacks, and system structures that must be always mapped, namely IDT,
GDT, common TSS and LDT, and process-private TSS and LDT if allocated.
By using 1:1 mapping for the kernel text and data, it appeared
possible to eliminate assembler part of the locore.S which bootstraps
initial page table and KPTmap. The code is rewritten in C and moved
into the pmap_cold(). The comment in vmparam.h explains the KVA
layout.
There is no PCID mechanism available in protected mode, so each
kernel/user switch forth and back completely flushes the TLB, except
for the trampoline PTD region. The TLB invalidations for userspace
becomes trivial, because IPI handlers switch page tables. On the other
hand, context switches no longer need to reload %cr3.
copyout(9) was rewritten to use vm_fault_quick_hold(). An issue for
new copyout(9) is compatibility with wiring user buffers around sysctl
handlers. This explains two kind of locks for copyout ptes and
accounting of the vslock() calls. The vm_fault_quick_hold() AKA slow
path, is only tried after the 'fast path' failed, which temporary
changes mapping to the userspace and copies the data to/from small
per-cpu buffer in the trampoline. If a page fault occurs during the
copy, it is short-circuit by exception.s to not even reach C code.
The change was motivated by the need to implement the Meltdown
mitigation, but instead of KPTI the full split is done. The i386
architecture already shows the sizing problems, in particular, it is
impossible to link clang and lld with debugging. I expect that the
issues due to the virtual address space limits would only exaggerate
and the split gives more liveness to the platform.
Tested by: pho
Discussed with: bde
Sponsored by: The FreeBSD Foundation
MFC after: 1 month
Differential revision: https://reviews.freebsd.org/D14633
The miscellaneous x86 sysent->sv_setregs() implementations tried to
migrate PSL_T from the previous program to the new executed one, but
they evaluated regs->tf_eflags after the whole regs structure was
bzeroed. Make this functional by saving PSL_T value before zeroing.
Note that if the debugger is not attached, executing the first
instruction in the new program with PSL_T set results in SIGTRAP, and
since all intercepted signals are reset to default dispostion on
exec(2), this means that non-debugged process gets killed immediately
if PSL_T is inherited. In particular, since suid images drop
P_TRACED, attempt to set PSL_T for execution of such program would
kill the process.
Another issue with userspace PSL_T handling is that it is reset by
trap(). It is reasonable to clear PSL_T when entering SIGTRAP
handler, to allow the signal to be handled without recursion or
delivery of blocked fault. But it is not reasonable to return back to
the normal flow with PSL_T cleared. This is too late to change, I
think.
Discussed with: bde, Ali Mashtizadeh
Sponsored by: The FreeBSD Foundation
MFC after: 3 weeks
Differential revision: https://reviews.freebsd.org/D14995
Previously linuxulator had three identical copies of
linux_exec_imgact_try. Deduplicate before adding another arch to
linuxulator.
Sponsored by: Turing Robotic Industries Inc
Differential Revision: https://reviews.freebsd.org/D14856
opt_compat.h is mentioned in nearly 180 files. In-progress network
driver compabibility improvements may add over 100 more so this is
closer to "just about everywhere" than "only some files" per the
guidance in sys/conf/options.
Keep COMPAT_LINUX32 in opt_compat.h as it is confined to a subset of
sys/compat/linux/*.c. A fake _COMPAT_LINUX option ensure opt_compat.h
is created on all architectures.
Move COMPAT_LINUXKPI to opt_dontuse.h as it is only used to control the
set of compiled files.
Reviewed by: kib, cem, jhb, jtl
Sponsored by: DARPA, AFRL
Differential Revision: https://reviews.freebsd.org/D14941
So that it doesn't rely on physmap[1] containing an address below
1MiB. Instead scan the full physmap and search for a suitable address
to place the trampoline code (below 1MiB) and the initial memory pages
(below 4GiB).
Sponsored by: Citrix Systems R&D
Reviewed by: kib
Differential Revision: https://reviews.freebsd.org/D14878
x86/cpu_machdep.c now needs to include elan_mmcr.h when CPU_ELAN is set.
While here, also remove the now unneeded inclusion of isareg.h in i386
and amd64 vm_machdep.c.
Reported by: lwhsu
MFC after: 14 days
X-MFC with: r331878
Because I didn't see any reason not too.
I've been making some changes to the code and couldn't help but notice
that the i386 and am64 code was nearly identical.
MFC after: 17 days
If cpu_reset() is called on an AP and if it somehow fails to wake the
BSP, then it's better to attempt the reset on the AP than just sit there
spinning on an unusable and undebuggable system.
MFC after: 16 days
The processor is "parked" in a spin-loop already and that's sufficient
for the reset. There is nothing that stop_cpus() would add here, only
extra complexity and fragility.
The original processor does not need to enable interrupts now, in fact,
it must not do that.
MFC after: 2 weeks
platforms. Original commit message as follows:
Only use CPUs in the domain the device is attached to for default
assignment. Device drivers are able to override the default assignment
if they bind directly. There are severe performance penalties for
handling interrupts on remote CPUs and this should only be done in
very controlled circumstances.
Reviewed by: jhb, kib
Tested by: pho
Sponsored by: Netflix, Dell/EMC Isilon
Differential Revision: https://reviews.freebsd.org/D14838
These have been supplanted by the MI signal information codes in
<sys/signal.h> since 7.0. The FPE_*_TRAP ones were deprecated even
earlier in 1999.
PR: 226579 (exp-run)
Reviewed by: kib
Differential Revision: https://reviews.freebsd.org/D14637
assignment. Device drivers are able to override the default assignment
if they bind directly. There are severe performance penalties for
handling interrupts on remote CPUs and this should only be done in
very controlled circumstances.
Reviewed by: jhb, kib
Tested by: pho (earlier version)
Sponsored by: Netflix, Dell/EMC Isilon
Differential Revision: https://reviews.freebsd.org/D14838
Bring #includes closer to style(9) and reduce differences between the
(three) MD versions of linux_machdep.c and linux_sysvec.c.
Sponsored by: Turing Robotic Industries Inc.
i386 was changed to only require critical section around the thread
FPU state manipulations, and vm86_bioscall callers already enter
critical section for other reasons.
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
ibcs2_getdents() copies a dirent structure to userland. The ibcs2
dirent structure contains a 2 byte pad element. This element is never
initialized, but copied to userland none-the-less.
Note that ibcs2 has not built on HEAD since r302095.
Submitted by: Domagoj Stolfa <ds815@cam.ac.uk>
Reported by: Ilja Van Sprundel <ivansprundel@ioactive.com>
MFC after: 3 days
Security: Kernel memory disclosure (803)
assym is only to be included by other .s files, and should never
actually be assembled by itself.
Reviewed by: imp, bdrewery (earlier)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D14180
