If a driver's Linux mmap callback passed vm_page_prot through unchanged,
then linux_dev_mmap_single() would try to apply whatever VM_MEMATTR_xxx
value 0 is to the mapping. On x86, VM_MEMATTR_DEFAULT is the PAT value
for write-back (WB) which is 6, while 0 maps to the PAT value for
uncacheable (UC). Thus, any mmap request that did not explicitly set
page_prot was tried to map memory as UC triggering the warning in
sg_pager_getpages().
Tested by: np
Reported by: Krishnamraju Eraparaju @ Chelsio
MFC after: 3 days
Sponsored by: Chelsio Communications
to actually wait until the TX FIFOs of UARTs have be drained before
returning. This is done by bringing the equivalent of the TS_BUSY flag
found in the previous implementation back in an ABI-preserving way.
Reported and tested by: Patrick Powell
Most likely, drivers for USB-serial-adapters likewise incorporating
TX FIFOs as well as other terminal devices that buffer output in some
form should also provide implementations of tsw_busy.
MFC after: 3 days
The return value doesn't need to be checked, because nvlist_get_guid's
callers check the returned values of the guids.
Coverity CID: 1341869
MFC after: 1 week
X-MFC-With: 292066
Sponsored by: Spectra Logic Corp
- Pull the vmspace logic out into helper functions and reduce duplication.
Operations on the vmspace are all isolated to vm_map.c, but it now exports
a new 'vmspace_switch_aio' for use by AIO kernel processes.
- When an AIO kernel process wants to exit, break out of the main loop and
perform cleanup after the loop end. This reduces a lot of indentation and
allows cleanup to more closely mirror setup actions before the loop starts.
- Convert a DIAGNOSTIC to KASSERT().
- Replace mycp with more typical 'p'.
Reviewed by: kib
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D4990
This code dates back to the initial AIO support and the commit log does
not explain why it is needed. However, I cannot find anything in the
AIO code or the various file methods (fo_read/fo_write) that would change
behavior due to using a private session instead of proc0's session.
Reviewed by: kib
Sponsored by: Chelsio Communications
Differential Revision: https://reviews.freebsd.org/D4988
Using zvols as backing devices for ZFS pools is fraught with panics and
deadlocks. For example, attempting to online a missing device in the
presence of a zvol can cause a panic when vdev_geom tastes the zvol. Better
to completely disable vdev_geom from ever opening a zvol. The solution
relies on setting a thread-local variable during vdev_geom_open, and
returning EOPNOTSUPP during zvol_open if that thread-local variable is set.
Remove the check for MUTEX_HELD(&zfsdev_state_lock) in zvol_open. Its intent
was to prevent a recursive mutex acquisition panic. However, the new check
for the thread-local variable also fixes that problem.
Also, fix a panic in vdev_geom_taste_orphan. For an unknown reason, this
function was set to panic. But it can occur that a device disappears during
tasting, and it causes no problems to ignore this departure.
Reviewed by: delphij
MFC after: 1 week
Relnotes: yes
Sponsored by: Spectra Logic Corp
Differential Revision: https://reviews.freebsd.org/D4986
- Add optimizing LRO wrapper which pre-sorts all incoming packets
according to the hash type and flowid. This prevents exhaustion of
the LRO entries due to too many connections at the same time.
Testing using a larger number of higher bandwidth TCP connections
showed that the incoming ACK packet aggregation rate increased from
~1.3:1 to almost 3:1. Another test showed that for a number of TCP
connections greater than 16 per hardware receive ring, where 8 TCP
connections was the LRO active entry limit, there was a significant
improvement in throughput due to being able to fully aggregate more
than 8 TCP stream. For very few very high bandwidth TCP streams, the
optimizing LRO wrapper will add CPU usage instead of reducing CPU
usage. This is expected. Network drivers which want to use the
optimizing LRO wrapper needs to call "tcp_lro_queue_mbuf()" instead
of "tcp_lro_rx()" and "tcp_lro_flush_all()" instead of
"tcp_lro_flush()". Further the LRO control structure must be
initialized using "tcp_lro_init_args()" passing a non-zero number
into the "lro_mbufs" argument.
- Make LRO statistics 64-bit. Previously 32-bit integers were used for
statistics which can be prone to wrap-around. Fix this while at it
and update all SYSCTL's which expose LRO statistics.
- Ensure all data is freed when destroying a LRO control structures,
especially leftover LRO entries.
- Reduce number of memory allocations needed when setting up a LRO
control structure by precomputing the total amount of memory needed.
- Add own memory allocation counter for LRO.
- Bump the FreeBSD version to force recompilation of all KLDs due to
change of the LRO control structure size.
Sponsored by: Mellanox Technologies
Reviewed by: gallatin, sbruno, rrs, gnn, transport
Tested by: Netflix
Differential Revision: https://reviews.freebsd.org/D4914
after changing the HW LRO sysctl when previously in up state.
Reviewed by: gnn
Sponsored by: Mellanox Technologies
MFC after: 5 days
Differential Revision: https://reviews.freebsd.org/D4941
registers. This brings amd64 on par with i386, providing consistent
initial FPU state.
Note that we do not clear any extended state, at least because kernel
does not understand extended state structure and consequences of zero
overwrite after fninit()/fpusave().
Submitted by: joss.upton@yahoo.com
PR: 206370
MFC after: 2 weeks
Ensure that checksum flags and L3/L4 fields are ignored
if lower level errors are reported in the event.
Remove checks for CRC0_ERR (bad iSCSI header CRC) and
CRC1_ERR (bad iSCSI payload or FCoE/FCoIP CRC) as they
are not used by any existing code.
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4975
The dynamic config on Medford is stored using two partitions in flash, and at
any time one is the 'current' partition, used to provide the active config,
and the other 'backup' partition is used for writes. This means that there
are two potential partitions that can be used to service reads, and which is
required can depend on, for example, whether the read is to get the current
contents or to verify a write.
When the partition write lock is held, the default behaviour is to read from
the backup partition, which was wrong for most reads in the common code which
require the current partition. This change allows the current partition to be
read whilst the write lock is held.
There is one read in Manftest which needs the backup partition.
ef10_nvram_partn_read_mode() is created to avoid changing
ef10_nvram_partn_read() which shares a prototype with the equivalent Falcon
and Siena methods.
MC_CMD_NVRAM_READ_IN_V2 adds an extra field, but firmware which doesn't support
it just ignores it.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4974
By confining the page table management to a handful of functions it'll be
easier to modify the page table scheme without affecting other functions.
This will be necessary when 64-bit support is added, and page tables become
much larger.
This API has no in-tree consumers at the moment but is useful to at least
one out-of-tree consumer, and naturally complements existing vnode refcount
functions (vholdl(9), vdropl(9)).
Obtained from: kib (sys/ portion)
Sponsored by: EMC / Isilon Storage Division
Differential Revision: https://reviews.freebsd.org/D4947
Differential Revision: https://reviews.freebsd.org/D4953
on FDT/OFW platforms.
After the refactoring of the powerpc code so that OF_decode_addr() is usable
on all FDT/OFW platforms, this switches uart(4) to using it.
Differential Revision: https://reviews.freebsd.org/D4675
Add VFS_AIO to generic config to allow using of high-performance
asynchronous disk AIO operation.
Reviewed by: imp
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential revision: https://reviews.freebsd.org/D4979
In recent EFI the DTS entries changed for PCIe controller.
This commit fixes internal PCIe, external is yet TBD.
Submitted by: Dominik Ermel <der@semihalf.com>
Obtained from: Semihalf
Sponsored by: The FreeBSD Foundation
Differential revision: https://reviews.freebsd.org/D4976
tlv_partition_header has field *preset* to support RFID-selectable
segments of dynamic configuration
Submitted by: Mateusz Wrzesinski <mwrzesinski at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
This allows an MTU change to be requested on unpriviliged functions
without also setting all the other parameters supported by MC_CMD_SET_MAC.
The enhanced SET_MAC command was introduced in v4_7 firmware.
Submitted by: Mark Spender <mspender at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4958
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4961
we want to use it.
The rate table was being initialised in low->high, but the link quality
table was being initialised high->low. So, when we did a lookup, we
would get the indexes wrong.
This started by a patch from dragonflybsd which reversed how the ni->in_ridx[]
array is being used; I'd rather it all be consistent. So, this is consistent.
Inspired by: what I did to iwn(4) a while ago
Inspired by: DragonflyBSD; <imre@vdsz.com>
underflow when we have small blocks of memory at the start and end of the
32-bit address range.
While here, only insert mappings pointing at a non-zero amount of memory.
Sponsored by: ABT Systems Ltd
Previously the polarity was for TTL levels, which are the reverse of RS-232.
Also add handling of the UART_PPS_INVERT_PULSE option bit in the sysctl
value, the same as was recently added to uart(4), so that people using TTL
level connections can request a logical inverting of the signal.
Use the named constants from the new dev/uart/uart_ppstypes.h for the pps
capture modes and option bits.
not call VOP_CLOSE() manually. Instead, delegate the close to
fo_close() performed as part of the fdrop() on the file failed to
open. For this, finish constructing file on error, in particular, set
f_vnode and f_ops.
Forcibly resetting f_ops to badfileops disabled additional cleanups
performed by fo_close() for some file types, in this case it was noted
that cdevpriv data was corrupted. Since fo_close() call must be
enabled for some file types, it makes more sense to enable it for all
files opened through vn_open_cred().
In collaboration with: pho
Sponsored by: The FreeBSD Foundation
MFC after: 2 weeks
Submitted by: Andy Moreton <amoreton at solarflare.com>
Sponsored by: Solarflare Communications, Inc.
MFC after: 2 days
Differential Revision: https://reviews.freebsd.org/D4957
Add locking around access to bv_cnt which is currently being done unlocked
PR: 206224
Reviewed by: imp
Approved by: jhb
MFC after: 1 week
Sponsored by: Panasas, Inc.
Differential Revision: https://reviews.freebsd.org/D4931
