Cameron Grant
724efc44ec
attach to non-ac97 neomagic chips and hope that ac97 ones do not have the
...
same pnpbios id
2000-01-13 06:11:32 +00:00
Cameron Grant
5b4c3f3ca0
be less verbose
2000-01-13 06:00:57 +00:00
Daniel Eischen
d404cb51ee
Add support for detection of the ESS 1878 chip.
2000-01-12 11:16:23 +00:00
Cameron Grant
e7fb32964c
exclude chips with subdevices specified on a list of non-ac97 chips
2000-01-11 10:37:16 +00:00
Cameron Grant
898cb2af53
make dsp_read() assert that it has a read channel, not a write channel
...
Submitted by: green
2000-01-10 07:05:15 +00:00
Cameron Grant
10b23f4c02
don't complain about bad intrs unless we get 1000 of them consecutively
...
whilst we are playing or recording. since we should irq ~20 times/sec when
active, this should never trigger. in theory. if it never does trigger,
the check will be removed.
2000-01-10 06:19:20 +00:00
Cameron Grant
9090c22ce7
general tidyup
2000-01-10 03:22:28 +00:00
Cameron Grant
4ee074718b
return the sample rate set instead of 0. oops. mpg123 should now work.
2000-01-10 01:59:12 +00:00
Cameron Grant
147d35e8b3
fix the premature termination of playback
2000-01-09 08:32:49 +00:00
Cameron Grant
d5fa8408e6
driver for neomagic 256av and 256zx
...
Obtained from: anonymous author, heavily derived
2000-01-09 08:14:11 +00:00
Cameron Grant
bf8ca271a3
modify sndstat output
2000-01-09 08:07:46 +00:00
Cameron Grant
833f702348
allow mixer-only devices - ie, devices with no play/rec channels
2000-01-06 04:11:36 +00:00
Cameron Grant
bbb5bf3d69
don't panic if channel init fails, report and fail gracefully
2000-01-05 20:44:41 +00:00
Cameron Grant
2abc85f0c0
argh, forgot the bus_dma_tag_creates.
...
also, panic if channel init fails instead of derefing null.
2000-01-05 04:01:34 +00:00
Cameron Grant
ebb0b1f9bb
set up the pci regs properly for busmastering. this makes the card work on
...
my smp box.
2000-01-05 02:03:55 +00:00
Cameron Grant
9d1671b8c2
allocate isa bounce buffers of the right size for ess/mss cards, fixes
...
panics reported
2000-01-05 00:39:20 +00:00
Seigo Tanimura
769309aaf2
Do not start/stop DMA transfer if it is already started/stopped.
2000-01-03 05:26:12 +00:00
Seigo Tanimura
f259d7eed5
- Handle an interrupt for csa primarily in the bridge driver,
...
then invoke the children. As the value of HISR can be read
only once, pass the HISR to the children via struct
csa_bridgeinfo, stored in the ivars of them.
- Clear the contents of serial FIFO upon stopping the DMA for
playing. This may eliminate buzz on playing. Experimental.
2000-01-03 02:51:16 +00:00
Cameron Grant
43607766d6
revert buffer size to 64k
2000-01-01 21:50:20 +00:00
Seigo Tanimura
f7e00c54d1
Correct the delay durations as in the sample sources provided by Crystal Semiconductor.
2000-01-01 09:07:03 +00:00
Peter Wemm
32ef0d3eb6
Attach the CS4610 PCI / CS4239 setup in isa compatability mode as CSC0100.
...
The PCI component is non-AC97 apparently.
PR: 15632
Submitted by: gibbs
1999-12-30 20:04:11 +00:00
Cameron Grant
69cbc772d9
make ess cards use a 64k buffer again, by implementing esschan_init()
1999-12-30 04:04:43 +00:00
Cameron Grant
2635fee807
make es1373 chips with ac97 2.1 work on troublesome motherboards
...
Submitted by: Russell Cattelan <cattelan@thebarn.com>
1999-12-29 05:44:17 +00:00
Peter Wemm
664a31e496
Change #ifdef KERNEL to #ifdef _KERNEL in the public headers. "KERNEL"
...
is an application space macro and the applications are supposed to be free
to use it as they please (but cannot). This is consistant with the other
BSD's who made this change quite some time ago. More commits to come.
1999-12-29 04:46:21 +00:00
Cameron Grant
a0b57fb738
- latest 2ndbuffer patch
...
- make chn_setdir work for rec on isa cards
- note: es1371 does not irq in smp
Submitted by: tanimura
1999-12-29 03:46:54 +00:00
Peter Wemm
7c361b70c5
Fix a mistake in the PNP EISA-encoding of the Avance ALS120 id.
...
Submitted by: Bryan Liesner <bleez@netaxs.com>
1999-12-26 10:51:47 +00:00
Doug Rabson
7e864cbf08
Don't pass u_int32_t pointers to BUS_READ_IVAR since it tends to make
...
alphas panic.
1999-12-24 16:22:45 +00:00
Peter Wemm
2996751a32
Collapse a bunch of unused MD_CS42nn tags into a single one. This saves
...
going to a lot of trouble to identify it and set the tag and then not use
it. Convert the pnp id matching to the preferred table based system.
@@@0001 (CMI8330 ldn 0) is a mss, not a SB.
1999-12-21 14:09:19 +00:00
Peter Wemm
93111ff410
Tidy up a few loose ends, including adding the pnp tags in comments.
...
Remove @@@0001 - it's an MSS, not a SB, at least according to the
original pre-sbc code and according to a pnpinfo report that Cameron has.
1999-12-21 14:04:14 +00:00
Peter Wemm
e9feccdcb4
Remove #if NISA > 0 - this is best done by the configuration process.
...
It had a heap of unreferenced stuff if there was no isa configured in the
system.
1999-12-21 13:55:46 +00:00
Cameron Grant
9035ec00a0
minor cleanup
...
Parts Submitted by: Ville-Pertti Keinonen <will@ztango.com>
1999-12-21 08:43:28 +00:00
Cameron Grant
637e117737
don't use the sbpro mic vol register during init on ess cards; it causes
...
feedback and we use the native one elsewhere.
1999-12-21 06:18:03 +00:00
Cameron Grant
a451ce1dad
minor cosmetics
1999-12-20 14:57:46 +00:00
Cameron Grant
71f78e06c6
make marcel's onboard ess1888 work
...
Submitted by: marcel
1999-12-20 14:55:56 +00:00
Cameron Grant
1ad869dbc6
allow (broken) apps to use mixer ioctls on dsp devices. eg: vmware
...
Submitted by: "Vladimir N. Silyaev" <vsilyaev@mindspring.com>
1999-12-20 00:56:51 +00:00
Cameron Grant
529863cb71
stop playing if we underrun; if there is more data to come, the next write
...
will restart
1999-12-19 22:32:55 +00:00
Cameron Grant
34c18c4fc5
note to self: vibra16c is not vibra16x
1999-12-19 22:28:31 +00:00
Cameron Grant
ff00068cce
fix for ess cards to use auto-init dma mode, so they work
1999-12-19 22:25:26 +00:00
Cameron Grant
09eb10434a
remove unused mixer stuff
1999-12-19 18:18:55 +00:00
Cameron Grant
d37a380ddb
general tidyup
1999-12-19 17:51:32 +00:00
Cameron Grant
7207eca657
move make_dev operations for audio channels to pcm_addchan(). in theory,
...
with modifications to MAKEDEV this will allow use of multiple output streams
on cards supporting it, eg trident 4dwave.
1999-12-19 15:27:24 +00:00
Cameron Grant
5c9abff13d
fix a bug in sndstat output, tidy up a few bits
1999-12-19 15:07:56 +00:00
Cameron Grant
df74837fd9
generalise the code a bit, and add an irq handler so that the child devices
...
can share the irq
1999-12-19 14:44:08 +00:00
Cameron Grant
71dde75288
remove the restriction limiting the vibra16x to 8 bit
...
Noticed By: Clive Lin <clive@CirX.ORG>
1999-12-19 14:21:38 +00:00
Cameron Grant
e53ad03a80
make vibra16x cards announce what they are in /dev/sndstat
1999-12-18 22:47:23 +00:00
Cameron Grant
f4a31ab806
fix the buffer repetition on ^c problem
1999-12-18 22:24:50 +00:00
Cameron Grant
354398891a
make the vibra16x work for playback at least, record is untested
1999-12-18 22:21:47 +00:00
Seigo Tanimura
cf4f3dda81
Correct the logical ID of Avance Asound 110.
...
Submitted by: Bryan Liesner <bleez@netaxs.com>
1999-12-18 12:17:02 +00:00
Cameron Grant
5f070b6772
more dma underrun fixes, using a per-channel 2nd buffer
...
Submitted by: tanimura
1999-12-13 03:29:09 +00:00
Cameron Grant
d4a72b067c
make sb dependant on sbc
...
add support for non-pnp cards to sbc
move card identification to sbc
channel-swapping code is in sb now instead of dsp
vibra16x support is still broken, but will be fixed soon
note: sbc is now compulsory for sb cards
for pnp cards use:
device sbc0
for non-pnp cards eg:
device sbc0 at isa? port 0x240 irq 5 drq 3 flags 0x15
(hints as oldpcm)
both in addition to:
device pcm0
Reviewed by: tanimura,dfr
Said he liked it: peter
1999-12-12 02:30:19 +00:00