- Makefile nit
- Add more CVS/SVN keywords to make it easier to track changes from NetBSD
in case they add further improvements
Approved by: delphij (mentor)
Obtained from: The NetBSD Project
discussed earlier that the extra safeness is not required in these
cases and we can avoid the overhead by using the more general
memory copy functions.
Approved by: delphij (mentor)
Obtained from: The NetBSD Project
will be removed. Permit the journal to proceed so that we don't leave
a rollback in a cg for a very long time as this can cause terrible perf
problems in low memory situations.
Tested by: pho
functions are implemented with CMPXCHG8B instruction where it is available,
i. e., all Pentium-class and later processors. Note this instruction is
also used for atomic_store_rel_64() because a simple XCHG-like instruction
for 64-bit memory access does not exist, unfortunately. If the processor
lacks the instruction, i. e., 80486-class CPUs, two 32-bit load/store are
performed with interrupt temporarily disabled, assuming it does not support
SMP. Although this assumption may be little naive, it is true in reality.
This implementation is inspired by Linux.
improves command timeout handling.
Many thanks to Areca for continuing to support FreeBSD.
Submitted by: Ching-Lung Huang <ching2048 areca com tw>
MFC after: 2 months
flags, so remove that part from WITHOUT_CXX again.
This is only partially regenerated, as the entries for FDT and GPIO seem to
have switched their default state, too.
WITHOUT_CLANG.
Don't build clang bootstrap/build-tools depending on this flag. We also
keep gperf, devd and libstdc++ around to prevent foot-shooting and to
make this a two-way street.
for racct.
Note that after this commit, ipcs(1) needs to be rebuilt. Otherwise, it will
fail with "ipcs: sysctlbyname: kern.ipc.msqids: Cannot allocate memory".
Sponsored by: The FreeBSD Foundation
Reviewed by: kib (earlier version)
This fixes a long standing bug in mxge(4) where "ifconfig mxge0 $IP"
did not bring the interface into a RUNNING state, like it does on
most (all?) other FreeBSD NIC drivers.
Thanks to gnn for mentioning the bug, and yongari for pointing out that
ether_ioctl() invokes ifp->if_init() in SIOCSIFADDR.
MFC after: 7 days
was incorrect - 'list scan' does not actually do a scan, but instead lists
the results of the background 'scan' cache.
Submitted by: Fabian Keil (freebsd-listen of fabiankeil de) (via email)
Discussed with: bschmidt
MFC after: 3 days
Of course, strerror_r() may still fail with ERANGE.
Although the POSIX specification said this could fail with EINVAL and
doing this likely indicates invalid use of errno, most other
implementations permitted it, various POSIX testsuites require it to
work (matching the older sys_errlist array) and apparently some
applications depend on it.
PR: standards/151316
MFC after: 1 week
- Add the change made in em to the actual unrefreshed number
of descriptors is used as a basis in rxeof on the way out
to determine if more refresh is needed. NOTE: there is a
difference in the ring setup in igb, this is not accidental,
it is necessitated by hardware behavior, when you reset the
newer adapters it will not let you write RDH, it ALWAYS sets
it to 0. Thus the way em does it is not possible.
- Change the sysctl handling of flow control, it will now make
the change dynamically when the variable setting changes rather
than requiring a reset.
- Change the eee sysctl naming, validation found the old unintuitive :)
- Last but not least, some important performance tweaks in the TX
path, I found that UDP behavior could be drastically hindered or
improved with just small changes in the start loop. What I have
here is what testing has shown to be the best overall. Its interesting
to note that changing the clean threshold to start at a full half of
the ring, made a BIG difference in performance. I hope that this
will prove to be advantageous for most workloads.
MFC in a week.
up and declaring a filesystem out of space. Especially necessary when
running on a small filesystem. With this improvement, it should be
possible to use soft updates on a small root filesystem.
Kudos to: Peter Holm
Testing by: Peter Holm
MFC: 2 weeks
{readline,history}.h are in /usr/include/edit so as to not conflict with
the GNU libreadline versions. To use the libedit readline(3) one should
add "-I/usr/include/edit" to their Makefile
(spelled "-I${DESTDIR}/${INCLUDEDIR}/edit" within the FreeBSD source tree).
* Enable its use in the BSD licensed utilities that support readline(3).
* To make it easier to sync libedit development with NetBSD, histedit.h
is moved into libedit's directory as history shows shown we keep merging
it into that location.
Obtained from: NetBSD
Sponsored by: Juniper Networks
show that there are perfectly working PM timers with occasional "hiccups",
probably because of an SMI. Now we ignore the maximum if it happens once in
the test loop and the width is small enough. Also, relax normal width a bit
to count in a boundary case.
Unlike other controllers which have more advanced jumbo support,
these controllers have one send ring, one standard receive producer
ring and one receive return ring. In order to receive jumbo frames
on the controllers, driver now will increase Rx buffer size to 9k.
Two Rx modes are supported on these controllers and I chose
standard Rx BDs over extended Rx BDs. The extended Rx BD mode
allows up to 4 segmentations for each Rx BDs such that kernel does
not have to allocate large buffer of contiguous memory for
receiving. The extended Rx BD mode is already used on controllers
that have separate jumbo receive ring. However, using extended Rx
BDs on BCM5714/BCM5715/BCM5780 reduces the number of Rx BDs to 256
entries which in turn may reduce the performance. Also UMA backed
page allocator for jumbo frame returns contiguous memory so using
extended Rx BD has no advantage on FreeBSD unless highly customized
local allocator implemented in driver is used.
To use jumbo buffers in standard receive ring, Rx buffer allocation
handler was changed to allocate MJUM9BYTES sized mbuf.
PR: kern/155192
Tested by: Vijay Singh <vijju.singh <> gmail dot com>
Submitted by: mjacob (initial version)
back-up is missing or dead. The current state of this field is reported
in 'mfiutil cache <volume>' and can be adjusted via
'mfiutil cache <volume> bad-bbu-write-cache <enable|disable>'. This
setting should generally be disabled to avoid data loss.
MFC after: 1 week
value.
The timeout is expressed in the form T(N) = (2^N * nanoseconds) and can
be easilly extracted from the watchdog interface as a WD_TO_* macro.
That new functionality is supposed to fix re-entering the kernel from DDB
re-enabling the watchdog again (previously disabled) and also offer the
possibility to break for deadlocked DDB commands.
Please note that retro-compatibility is retained.
Sponsored by: Sandvine Incorporated
Approved by: des
MFC after: 10 days
Make fdt default on arm and powerpc.
This now includes cross compiled targets, where before we tried to
make it host-based.
Also, move the lists of default yes and no options to a variable.
In general, only build tools should get this treatment in bsd.own.mk.
Also, the use of TARGET* in the bsd.*mk files is discouraged, but
necessary here due to the ordering of things in buildworld. We make
the native case work by testing MACHINE_ARCH after TARGET_ARCH.
levels. TX would hang, RX wouldn't. A bit of digging showed the interface
send queue was full, but IFF_DRV_OACTIVE was clear and the hardware TX
queue was empty.
It turns out that there wasn't a check to drain the interface send
queue once hardware TX had completed, so if the interface send queue
had filled up in the meantime, subsequent packets would be dropped
by the higher layers and if_start (and thus arge_start()) would never
be called.
The fix is simple - call arge_start_locked() in the software interrupt
handler after the hardware TX queue has been handled or a TX underrun
occured. This way the interface send queue gets drained.
at run-time on i386. cpu_ticks() is set to use RDTSC early enough on i386
where it is available. Otherwise, cpu_ticks() is driven by the current
timecounter hardware as binuptime(9) does. This also avoids unnecessary
namespace pollution from <machine/cputypes.h>.
