the UDP checksum computation and signals that it was OK,
clear this bit when passing the packet to SCTP. Since the
bits indicating a valid UDP checksum and a valid SCTP
checksum are the same, the SCTP stack would assume
that also an SCTP checksum check has been performed.
MFC after: 1 week
only for read locks on pcbs. The same race can happen with write
lock semantics as well.
The race scenario:
- Two threads (1 and 2) locate pcb with writer semantics (INPLOOKUP_WLOCKPCB)
and do in_pcbref() on it.
- 1 and 2 both drop the inp hash lock.
- Another thread (3) grabs the inp hash lock. Then it runs in_pcbfree(),
which wlocks the pcb. They must happen faster than 1 or 2 come INP_WLOCK()!
- 1 and 2 congest in INP_WLOCK().
- 3 does in_pcbremlists(), drops hash lock, and runs in_pcbrele_wlocked(),
which doesn't free the pcb due to two references on it.
Then it unlocks the pcb.
- 1 (or 2) gets wlock on the pcb, runs in_pcbrele_wlocked(), which doesn't
report inp as freed, due to 2 (or 1) still helding extra reference on it.
The thread tries to do smth with a disconnected pcb and crashes.
Submitted by: emeric.poupon@stormshield.eu
Reviewed by: gleb@
MFC after: 1 week
Sponsored by: Stormshield
Tested by: Cassiano Peixoto, Stormshield
Use hhook(9) framework to achieve ability of loading and unloading
if_enc(4) kernel module. INET and INET6 code on initialization registers
two helper hooks points in the kernel. if_enc(4) module uses these helper
hook points and registers its hooks. IPSEC code uses these hhook points
to call helper hooks implemented in if_enc(4).
When the M_NOWAIT allocation fails, we recurse the if_addr_lock trying
to clean up. Reorder the cleanup after dropping the if_addr_lock. The
obvious race is already possible between if_addmulti and IF_ADDR_WLOCK
above, so it must be ok.
Submitted by: Ryan Libby <rlibby@gmail.com>
Reviewed by: jhb
Found with: M_NOWAIT failure injection testing
Sponsored by: EMC / Isilon Storage Division
Differential Revision: https://reviews.freebsd.org/D4138
new return codes of -1 were mistakenly being considered "true". Callout_stop
now returns -1 to indicate the callout had either already completed or
was not running and 0 to indicate it could not be stopped. Also update
the manual page to make it more consistent no non-zero in the callout_stop
or callout_reset descriptions.
MFC after: 1 Month with associated callout change.
Rename arp_ifinit2() into arp_announce_ifaddr().
Eliminate zeroing ifa_rtrequest: it was used for calling arp_rtrequest()
which was responsible for handling route cloning requests. It became
obsolete since r186119 (L2/L3 split).
sysctl and will always be on. The former split between default and
fast forwarding is removed by this commit while preserving the ability
to use all network stack features.
Differential Revision: https://reviews.freebsd.org/D4042
Reviewed by: ae, melifaro, olivier, rwatson
MFC after: 1 month
Sponsored by: Rubicon Communications (Netgate)
suggested by RFC 6675.
Currently differnt places in the stack tries to guess this in suboptimal ways.
The main problem is that current calculations don't take sacked bytes into
account. Sacked bytes are the bytes receiver acked via SACK option. This is
suboptimal because it assumes that network has more outstanding (unacked) bytes
than the actual value and thus sends less data by setting congestion window
lower than what's possible which in turn may cause slower recovery from losses.
As an example, one of the current calculations looks something like this:
snd_nxt - snd_fack + sackhint.sack_bytes_rexmit
New proposal from RFC 6675 is:
snd_max - snd_una - sackhint.sacked_bytes + sackhint.sack_bytes_rexmit
which takes sacked bytes into account which is a new addition to the sackhint
struct. Only thing we are missing from RFC 6675 is isLost() i.e. segment being
considered lost and thus adjusting pipe based on that which makes this
calculation a bit on conservative side.
The approach is very simple. We already process each ack with sack info in
tcp_sack_doack() and extract sack blocks/holes out of it. We'd now also track
this new variable sacked_bytes which keeps track of total sacked bytes reported.
One downside to this approach is that we may get incorrect count of sacked_bytes
if the other end decides to drop sack info in the ack because of memory pressure
or some other reasons. But in this (not very likely) case also the pipe
calculation would be conservative which is okay as opposed to being aggressive
in sending packets into the network.
Next step is to use this more accurate pipe estimation to drive congestion
window adjustments.
In collaboration with: rrs
Reviewed by: jason_eggnet dot com, rrs
MFC after: 2 weeks
Sponsored by: Limelight Networks
Differential Revision: https://reviews.freebsd.org/D3971
window in number of segments on fly. It is set to 10 segments by default.
Remove net.inet.tcp.experimental.initcwnd10 which is now redundant. Also remove
the parent node net.inet.tcp.experimental as it's not needed anymore and also
because it was not well thought out.
Differential Revision: https://reviews.freebsd.org/D3858
In collaboration with: lstewart
Reviewed by: gnn (prev version), rwatson, allanjude, wblock (man page)
MFC after: 2 weeks
Relnotes: yes
Sponsored by: Limelight Networks
degradation (7%) for host host TCP connections over 10Gbps links,
even when there were no secuirty policies in place. There is no
change in performance on 1Gbps network links. Testing GENERIC vs.
GENERIC-NOIPSEC vs. GENERIC with this change shows that the new
code removes any overhead introduced by having IPSEC always in the
kernel.
Differential Revision: D3993
MFC after: 1 month
Sponsored by: Rubicon Communications (Netgate)
down state.
Regression appeared in r287789, where the "prefix has no corresponding
installed route" case was forgotten. Additionally, lltable_delete_addr()
was called with incorrect byte order (default is network for lltable code).
While here, improve comments on given cases and byte order.
PR: 203573
Submitted by: phk
retransmission timeout (rto) when blackhole detection is enabled. Make
sure it only happens when the second attempt to send the same segment also fails
with rto.
Also make sure that each mtu probing stage (usually 1448 -> 1188 -> 524) follows
the same pattern and gets 2 chances (rto) before further clamping down.
Note: RFC4821 doesn't specify implementation details on how this situation
should be handled.
Differential Revision: https://reviews.freebsd.org/D3434
Reviewed by: sbruno, gnn (previous version)
MFC after: 2 weeks
Sponsored by: Limelight Networks
packets and/or state transitions from each TCP socket. That would help with
narrowing down certain problems we see in the field that are hard to reproduce
without understanding the history of how we got into a certain state. This
change provides just that.
It saves copies of the last N packets in a list in the tcpcb. When the tcpcb is
destroyed, the list is freed. I thought this was likely to be more
performance-friendly than saving copies of the tcpcb. Plus, with the packets,
you should be able to reverse-engineer what happened to the tcpcb.
To enable the feature, you will need to compile a kernel with the TCPPCAP
option. Even then, the feature defaults to being deactivated. You can activate
it by setting a positive value for the number of captured packets. You can do
that on either a global basis or on a per-socket basis (via a setsockopt call).
There is no way to get the packets out of the kernel other than using kmem or
getting a coredump. I thought that would help some of the legal/privacy concerns
regarding such a feature. However, it should be possible to add a future effort
to export them in PCAP format.
I tested this at low scale, and found that there were no mbuf leaks and the peak
mbuf usage appeared to be unchanged with and without the feature.
The main performance concern I can envision is the number of mbufs that would be
used on systems with a large number of sockets. If you save five packets per
direction per socket and have 3,000 sockets, that will consume at least 30,000
mbufs just to keep these packets. I tried to reduce the concerns associated with
this by limiting the number of clusters (not mbufs) that could be used for this
feature. Again, in my testing, that appears to work correctly.
Differential Revision: D3100
Submitted by: Jonathan Looney <jlooney at juniper dot net>
Reviewed by: gnn, hiren
unconditionally, we end up with an mbuf chain of two mbufs, which
later in in_arpreply() is rewritten from ARP request to ARP reply
and is sent out. Looks like igb(4) (at least mine, and at least
at my network) fails on such mbuf chain, so ARP reply doesn't go
out wire. Thus, make the m_pullup() call conditional, as it is
everywhere. Of course, the bug in igb(?) should be investigated,
but better first fix the head. And unconditional m_pullup() was
suboptimal, anyway.
Currently we perform crypto requests for IPSEC synchronous for most of
crypto providers (software, aesni) and only VIA padlock calls crypto
callback asynchronous. In synchronous mode it is possible, that security
policy will be removed during the processing crypto request. And crypto
callback will release the last reference to SP. Then upon return into
ipsec[46]_process_packet() IPSECREQUEST_UNLOCK() will be called to already
freed request. To prevent this we will take extra reference to SP.
PR: 201876
Sponsored by: Yandex LLC
is smaller than the current one for this connection. This is behavior
specified by RFC 1191, and this is how original BSD stack behaved, but this
was unintentionally regressed in r182851.
Reported & tested by: Richard Russo <russor whatsapp.com>
Differential Revision: D3567
Sponsored by: Nginx, Inc.
Initially function was introduced in r53541 (KAME initial commit) to
"provide hints from upper layer protocols that indicate a connection
is making "forward progress"" (quote from RFC 2461 7.3.1 Reachability
Confirmation).
However, it was converted to do nothing (e.g. just return) in r122922
(tcp_hostcache implementation) back in 2003. Some defines were moved
to tcp_var.h in r169541. Then, it was broken (for non-corner cases)
by r186119 (L2<>L3 split) in 2008 (NULL ifp in nd6_lookup). So,
right now this code is broken and has no "real" base users.
Differential Revision: https://reviews.freebsd.org/D3699
instead of old "ignore-and-return 0" in r287789. This broke arp -da /
ndp -cn behavior (they exit on rtsock command failure). Fix this by
translating LLE_IFADDR to RTM_PINNED flag, passing it to userland and
making arp/ndp ignore these entries in batched delete.
MFC after: 2 weeks
function. The change is mostly mechanical with the following exception:
Last piece of nd6_resolve_slow() was refactored: ND6_LLINFO_PERMANENT
condition was removed as always-true, explicit ND6_LLINFO_NOSTATE ->
ND6_LLINFO_INCOMPLETE state transition was removed as duplicate.
Reviewed by: ae
Sponsored by: Yandex LLC
* prepare gateway before insertion
* use RTM_CHANGE instead of explicit find/change route
* Remove fib argument from ifa_switch_loopback_route added in r264887:
if old ifp fib differes from new one, that the caller
is doing something wrong
* Make ifa_*_loopback_route call single ifa_maintain_loopback_route().
