This is part of an ongoing cycle of commits on all the BSDs to
merge the USB vendor and device defintions..
A merge from OpenBSD is still pending.
Submitted by: barry bouwsma (freebsd-misuser@NOSPAM.dyndns.dk)
Obtained from: NetBSD
MFC after: 1 week
multiple IRQs (which is nonsense for _CRS) when the link hasn't been
programmed. Before, this was a KASSERT. A ServerWorks system was
seen returning IRQs of 0, 2 in response to _CRS before link setup.
Thanks to sam@ for quick testing and turnaround on this.
Tested by: sam
datasheet says it is only valid for such chipsets and shouldn't be used
with others. This fixes some 82559 based cards which otherwise only
work at 10Mbit.
MFC after: 5 days
Tested by: krion
In contrast to OpenBSD we enable jumbo frame support
depending on MTU setting (like done for xmac).
Approved by: pjd (mentor)
Obtained from: OpenBSD if_sk.c r1.52 (YU_SMR_MFL_JUMBO flag)
Tested by: Heinz Knocke <knockefreebsd at o2 dot pl>
MFC after: 5 days
there is some hope for the 32-bit management utilities to run. I've used
the cli successfully, but 3dm2 doesn't work for other reasons. Of course,
a native binary of the 3dm2 and cli would be much better, but that doesn't
exist.
o don't encapsulate on tx; the chip expect a raw frame w/o the crypto header
o clear the WEP bit in the 802.11 header on rx so the 802.11 layer doesn't
try to strip the crypto header
o clobber the "drop unencoded frames" state bit when privacy is enabled so
rx'd frames we pass up to the 802.11 layer are not discarded as unencrypted
This stuff will need to be redone if anyone decides to add WPA support.
port during the device probe as this can cause hangs on some machines,
specifically Compaq R3000Z series amd64 laptops. The flag is bit 3, or
0x8.
PR: amd64/67745
Reported by: Neil Winterbauer newntrbr at ucla dot edu, many others
Tested by: ade, astrodog at gmail dot com, many others
MFC after: 1 week
pointers to an integer via uintptr_t.
Fix an apparent bug that caused a compile failure.
ieee80211_iterate_nodes() takes ic->ic_sta as its first argument on the
onoe module. It had just 'ic' here in the same context, which was a
mismatched argument.
of a sizeof, need to use %z to get the correct type on all our platforms.
Also, convert integers<->pointers via uintptr_t.
(I think Sam's instructions were for me to commit this. If I
misunderstood, then I apologize in advance.)
to better keep track of the total amoutn transferred during a
transfer. Seems similar to some code in the NetBSD version.
I notice they have incorporated matches from him so I don't know which
direction it went.
Submitted by: damien.bergamini@free.fr
Obtained from: patches to make the ueagle driver work
MFC after: 1 week
You could turn this off by debug.mpsafenet=0 for full network
stack or via debug.{cp|cx|ctau}.mpsafenet for cp(4), cx(4) and
ctau(4) accordingly.
MFC after: 10 days
