freebsd-nq/sys/dev/bwn/if_bwn_debug.h
Adrian Chadd 5025b8d583 [bwn] add opt_wlan.h and opt_bwn.h so we can enable bwn debugging as appropriate.
Tested:

* BCM4322, STA mode (11a)

Sponsored by:	Palm Springs
2016-05-16 22:56:45 +00:00

80 lines
3.1 KiB
C

/*-
* Copyright (c) 2009-2010 Weongyo Jeong <weongyo@freebsd.org>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer,
* without modification.
* 2. Redistributions in binary form must reproduce at minimum a disclaimer
* similar to the "NO WARRANTY" disclaimer below ("Disclaimer") and any
* redistribution must be conditioned upon including a substantially
* similar Disclaimer requirement for further binary redistribution.
*
* NO WARRANTY
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
* ``AS IS'' AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
* LIMITED TO, THE IMPLIED WARRANTIES OF NONINFRINGEMENT, MERCHANTIBILITY
* AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL
* THE COPYRIGHT HOLDERS OR CONTRIBUTORS BE LIABLE FOR SPECIAL, EXEMPLARY,
* OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF
* SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
* INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER
* IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE)
* ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF
* THE POSSIBILITY OF SUCH DAMAGES.
*
* $FreeBSD$
*/
#ifndef __IF_BWN_DEBUG_H__
#define __IF_BWN_DEBUG_H__
enum {
BWN_DEBUG_XMIT = 0x00000001, /* basic xmit operation */
BWN_DEBUG_RECV = 0x00000002, /* basic recv operation */
BWN_DEBUG_STATE = 0x00000004, /* 802.11 state transitions */
BWN_DEBUG_TXPOW = 0x00000008, /* tx power processing */
BWN_DEBUG_RESET = 0x00000010, /* reset processing */
BWN_DEBUG_OPS = 0x00000020, /* bwn_ops processing */
BWN_DEBUG_BEACON = 0x00000040, /* beacon handling */
BWN_DEBUG_WATCHDOG = 0x00000080, /* watchdog timeout */
BWN_DEBUG_INTR = 0x00000100, /* ISR */
BWN_DEBUG_CALIBRATE = 0x00000200, /* periodic calibration */
BWN_DEBUG_NODE = 0x00000400, /* node management */
BWN_DEBUG_LED = 0x00000800, /* led management */
BWN_DEBUG_CMD = 0x00001000, /* cmd submission */
BWN_DEBUG_LO = 0x00002000, /* LO */
BWN_DEBUG_FW = 0x00004000, /* firmware */
BWN_DEBUG_WME = 0x00008000, /* WME */
BWN_DEBUG_RF = 0x00010000, /* RF */
BWN_DEBUG_XMIT_POWER = 0x00020000,
BWN_DEBUG_PHY = 0x00040000,
BWN_DEBUG_EEPROM = 0x00080000,
BWN_DEBUG_FATAL = 0x80000000, /* fatal errors */
BWN_DEBUG_ANY = 0xffffffff
};
#ifdef BWN_DEBUG
#define DPRINTF(sc, m, fmt, ...) do { \
if (sc->sc_debug & (m)) \
printf(fmt, __VA_ARGS__); \
} while (0)
#else /* BWN_DEBUG */
#define DPRINTF(sc, m, fmt, ...) do { (void) sc; } while (0)
#endif /* BWN_DEBUG */
#define BWN_ERRPRINTF(sc, ...) do { \
printf(__VA_ARGS__); \
} while (0)
#define BWN_DBGPRINTF(sc, ...) do { \
printf(__VA_ARGS__); \
} while (0)
#define BWN_WARNPRINTF(sc, ...) do { \
printf(__VA_ARGS__); \
} while (0)
#endif /* __IF_BWN_DEBUG_H__ */