freebsd-nq/sys/sparc64/pci/apb.c
Marius Strobl 26280d88d7 - Introduce an ofw_bus kobj-interface for retrieving the OFW node and a
subset ("compatible", "device_type", "model" and "name") of the standard
  properties in drivers for devices on Open Firmware supported busses. The
  standard properties "reg", "interrupts" und "address" are not covered by
  this interface because they are only of interest in the respective bridge
  code. There's a remaining standard property "status" which is unclear how
  to support properly but which also isn't used in FreeBSD at present.
  This ofw_bus kobj-interface allows to replace the various (ebus_get_node(),
  ofw_pci_get_node(), etc.) and partially inconsistent (central_get_type()
  vs. sbus_get_device_type(), etc.) existing IVAR ones with a common one.
  This in turn allows to simplify and remove code-duplication in drivers for
  devices that can hang off of more than one OFW supported bus.
- Convert the sparc64 Central, EBus, FHC, PCI and SBus bus drivers and the
  drivers for their children to use the ofw_bus kobj-interface. The IVAR-
  interfaces of the Central, EBus and FHC are entirely replaced by this. The
  PCI bus driver used its own kobj-interface and now also uses the ofw_bus
  one. The IVARs special to the SBus, e.g. for retrieving the burst size,
  remain.
  Beware: this causes an ABI-breakage for modules of drivers which used the
  IVAR-interfaces, i.e. esp(4), hme(4), isp(4) and uart(4), which need to be
  recompiled.
  The style-inconsistencies introduced in some of the bus drivers will be
  fixed by tmm@ in a generic clean-up of the respective drivers later (he
  requested to add the changes in the "new" style).
- Convert the powerpc MacIO bus driver and the drivers for its children to
  use the ofw_bus kobj-interface. This invloves removing the IVARs related
  to the "reg" property which were unused and a leftover from the NetBSD
  origini of the code. There's no ABI-breakage caused by this because none
  of these driver are currently built as modules.
  There are other powerpc bus drivers which can be converted to the ofw_bus
  kobj-interface, e.g. the PCI bus driver, which should be done together
  with converting powerpc to use the OFW PCI code from sparc64.
- Make the SBus and FHC front-end of zs(4) and the sparc64 eeprom(4) take
  advantage of the ofw_bus kobj-interface and simplify them a bit.

Reviewed by:	grehan, tmm
Approved by:	re (scottl)
Discussed with:	tmm
Tested with:	Sun AX1105, AXe, Ultra 2, Ultra 60; PPC cross-build on i386
2004-08-12 17:41:33 +00:00

276 lines
7.8 KiB
C

/*-
* Copyright (c) 1994,1995 Stefan Esser, Wolfgang StanglMeier
* Copyright (c) 2000 Michael Smith <msmith@freebsd.org>
* Copyright (c) 2000 BSDi
* Copyright (c) 2001, 2003 Thomas Moestl <tmm@FreeBSD.org>
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
* modification, are permitted provided that the following conditions
* are met:
* 1. Redistributions of source code must retain the above copyright
* notice, this list of conditions and the following disclaimer.
* 2. Redistributions in binary form must reproduce the above copyright
* notice, this list of conditions and the following disclaimer in the
* documentation and/or other materials provided with the distribution.
* 3. The name of the author may not be used to endorse or promote products
* derived from this software without specific prior written permission.
*
* THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND
* ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE
* IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE
* ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE
* FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL
* DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS
* OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION)
* HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
* LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
* OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
* SUCH DAMAGE.
*
* from: FreeBSD: src/sys/dev/pci/pci_pci.c,v 1.3 2000/12/13
*
* $FreeBSD$
*/
/*
* Support for the Sun APB (Advanced PCI Bridge) PCI-PCI bridge.
* This bridge does not fully comply to the PCI bridge specification, and is
* therefore not supported by the generic driver.
* We can use some of the pcib methods anyway.
*/
#include "opt_ofw_pci.h"
#include <sys/param.h>
#include <sys/systm.h>
#include <sys/kernel.h>
#include <sys/module.h>
#include <sys/bus.h>
#include <dev/ofw/ofw_bus.h>
#include <dev/ofw/openfirm.h>
#include <machine/bus.h>
#include <machine/ofw_bus.h>
#include <machine/resource.h>
#include <dev/pci/pcireg.h>
#include <dev/pci/pcivar.h>
#include <dev/pci/pcib_private.h>
#include "pcib_if.h"
#include <sparc64/pci/ofw_pci.h>
#include <sparc64/pci/ofw_pcib_subr.h>
/*
* Bridge-specific data.
*/
struct apb_softc {
struct ofw_pcib_gen_softc sc_bsc;
u_int8_t sc_iomap;
u_int8_t sc_memmap;
};
static device_probe_t apb_probe;
static device_attach_t apb_attach;
static bus_alloc_resource_t apb_alloc_resource;
static device_method_t apb_methods[] = {
/* Device interface */
DEVMETHOD(device_probe, apb_probe),
DEVMETHOD(device_attach, apb_attach),
DEVMETHOD(device_shutdown, bus_generic_shutdown),
DEVMETHOD(device_suspend, bus_generic_suspend),
DEVMETHOD(device_resume, bus_generic_resume),
/* Bus interface */
DEVMETHOD(bus_print_child, bus_generic_print_child),
DEVMETHOD(bus_read_ivar, pcib_read_ivar),
DEVMETHOD(bus_write_ivar, pcib_write_ivar),
DEVMETHOD(bus_alloc_resource, apb_alloc_resource),
DEVMETHOD(bus_release_resource, bus_generic_release_resource),
DEVMETHOD(bus_activate_resource, bus_generic_activate_resource),
DEVMETHOD(bus_deactivate_resource, bus_generic_deactivate_resource),
DEVMETHOD(bus_setup_intr, bus_generic_setup_intr),
DEVMETHOD(bus_teardown_intr, bus_generic_teardown_intr),
/* pcib interface */
DEVMETHOD(pcib_maxslots, pcib_maxslots),
DEVMETHOD(pcib_read_config, pcib_read_config),
DEVMETHOD(pcib_write_config, pcib_write_config),
DEVMETHOD(pcib_route_interrupt, ofw_pcib_gen_route_interrupt),
/* ofw_bus interface */
DEVMETHOD(ofw_bus_get_node, ofw_pcib_gen_get_node),
/* ofw_pci interface */
DEVMETHOD(ofw_pci_adjust_busrange, ofw_pcib_gen_adjust_busrange),
{ 0, 0 }
};
static driver_t apb_driver = {
"pcib",
apb_methods,
sizeof(struct apb_softc),
};
DRIVER_MODULE(apb, pci, apb_driver, pcib_devclass, 0, 0);
/* APB specific registers */
#define APBR_IOMAP 0xde
#define APBR_MEMMAP 0xdf
/* Definitions for the mapping registers */
#define APB_IO_SCALE 0x200000
#define APB_MEM_SCALE 0x20000000
/*
* Generic device interface
*/
static int
apb_probe(device_t dev)
{
if (pci_get_vendor(dev) == 0x108e && /* Sun */
pci_get_device(dev) == 0x5000) { /* APB */
device_set_desc(dev, "APB PCI-PCI bridge");
return (0);
}
return (ENXIO);
}
static void
apb_map_print(u_int8_t map, u_long scale)
{
int i, first;
for (first = 1, i = 0; i < 8; i++) {
if ((map & (1 << i)) != 0) {
printf("%s0x%lx-0x%lx", first ? "" : ", ",
i * scale, (i + 1) * scale - 1);
first = 0;
}
}
}
static int
apb_map_checkrange(u_int8_t map, u_long scale, u_long start, u_long end)
{
int i, ei;
i = start / scale;
ei = end / scale;
if (i > 7 || ei > 7)
return (0);
for (; i <= ei; i++)
if ((map & (1 << i)) == 0)
return (0);
return (1);
}
static int
apb_attach(device_t dev)
{
struct apb_softc *sc;
sc = device_get_softc(dev);
/*
* Get current bridge configuration.
*/
sc->sc_iomap = pci_read_config(dev, APBR_IOMAP, 1);
sc->sc_memmap = pci_read_config(dev, APBR_MEMMAP, 1);
ofw_pcib_gen_setup(dev);
if (bootverbose) {
device_printf(dev, " secondary bus %d\n",
sc->sc_bsc.ops_pcib_sc.secbus);
device_printf(dev, " subordinate bus %d\n",
sc->sc_bsc.ops_pcib_sc.subbus);
device_printf(dev, " I/O decode ");
apb_map_print(sc->sc_iomap, APB_IO_SCALE);
printf("\n");
device_printf(dev, " memory decode ");
apb_map_print(sc->sc_memmap, APB_MEM_SCALE);
printf("\n");
}
device_add_child(dev, "pci", sc->sc_bsc.ops_pcib_sc.secbus);
return (bus_generic_attach(dev));
}
/*
* We have to trap resource allocation requests and ensure that the bridge
* is set up to, or capable of handling them.
*/
static struct resource *
apb_alloc_resource(device_t dev, device_t child, int type, int *rid,
u_long start, u_long end, u_long count, u_int flags)
{
struct apb_softc *sc;
sc = device_get_softc(dev);
/*
* If this is a "default" allocation against this rid, we can't work
* out where it's coming from (we should actually never see these) so
* we just have to punt.
*/
if ((start == 0) && (end == ~0)) {
device_printf(dev, "can't decode default resource id %d for "
"%s%d, bypassing\n", *rid, device_get_name(child),
device_get_unit(child));
} else {
/*
* Fail the allocation for this range if it's not supported.
* XXX we should probably just fix up the bridge decode and
* soldier on.
*/
switch (type) {
case SYS_RES_IOPORT:
if (!apb_map_checkrange(sc->sc_iomap, APB_IO_SCALE,
start, end)) {
device_printf(dev, "device %s%d requested "
"unsupported I/O range 0x%lx-0x%lx\n",
device_get_name(child),
device_get_unit(child), start, end);
return (NULL);
}
if (bootverbose)
device_printf(sc->sc_bsc.ops_pcib_sc.dev,
"device %s%d requested decoded I/O range "
"0x%lx-0x%lx\n", device_get_name(child),
device_get_unit(child), start, end);
break;
case SYS_RES_MEMORY:
if (!apb_map_checkrange(sc->sc_memmap, APB_MEM_SCALE,
start, end)) {
device_printf(dev, "device %s%d requested "
"unsupported memory range 0x%lx-0x%lx\n",
device_get_name(child),
device_get_unit(child), start, end);
return (NULL);
}
if (bootverbose)
device_printf(sc->sc_bsc.ops_pcib_sc.dev,
"device %s%d requested decoded memory "
"range 0x%lx-0x%lx\n",
device_get_name(child),
device_get_unit(child), start, end);
break;
default:
break;
}
}
/*
* Bridge is OK decoding this resource, so pass it up.
*/
return (bus_generic_alloc_resource(dev, child, type, rid, start, end,
count, flags));
}