freebsd-nq/sys/dev/ath/ath_hal/ar5312/ar5312reg.h
2010-03-03 17:32:32 +00:00

140 lines
5.9 KiB
C

/*
* Copyright (c) 2002-2008 Sam Leffler, Errno Consulting
* Copyright (c) 2002-2008 Atheros Communications, Inc.
*
* Permission to use, copy, modify, and/or distribute this software for any
* purpose with or without fee is hereby granted, provided that the above
* copyright notice and this permission notice appear in all copies.
*
* THE SOFTWARE IS PROVIDED "AS IS" AND THE AUTHOR DISCLAIMS ALL WARRANTIES
* WITH REGARD TO THIS SOFTWARE INCLUDING ALL IMPLIED WARRANTIES OF
* MERCHANTABILITY AND FITNESS. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR
* ANY SPECIAL, DIRECT, INDIRECT, OR CONSEQUENTIAL DAMAGES OR ANY DAMAGES
* WHATSOEVER RESULTING FROM LOSS OF USE, DATA OR PROFITS, WHETHER IN AN
* ACTION OF CONTRACT, NEGLIGENCE OR OTHER TORTIOUS ACTION, ARISING OUT OF
* OR IN CONNECTION WITH THE USE OR PERFORMANCE OF THIS SOFTWARE.
*
* $FreeBSD$
*/
#ifndef _DEV_ATH_AR5312REG_H_
#define _DEV_ATH_AR5312REG_H_
#include "ar5212/ar5212reg.h"
/*
* Definitions for the Atheros 5312 chipset.
*/
/* Register base addresses for modules which are not wmac modules */
/* 531X has a fixed memory map */
#define REG_WRITE(_reg,_val) *((volatile uint32_t *)(_reg)) = (_val);
#define REG_READ(_reg) *((volatile uint32_t *)(_reg))
/*
* PCI-MAC Configuration registers (AR2315+)
*/
#define AR5315_RSTIMER_BASE 0xb1000000 /* Address for reset/timer registers */
#define AR5315_GPIO_BASE 0xb1000000 /* Address for GPIO registers */
#define AR5315_WLAN0 0xb0000000
#define AR5315_RESET 0x0004 /* Offset of reset control register */
#define AR5315_SREV 0x0014 /* Offset of reset control register */
#define AR5315_ENDIAN_CTL 0x000c /* offset of the endian control register */
#define AR5315_CONFIG_WLAN 0x00000002 /* WLAN byteswap */
#define AR5315_REV_MAJ 0x00f0
#define AR5315_REV_MIN 0x000f
#define AR5315_GPIODIR 0x0098 /* GPIO direction register */
#define AR5315_GPIODO 0x0090 /* GPIO data output access reg */
#define AR5315_GPIODI 0x0088 /* GPIO data input access reg*/
#define AR5315_GPIOINT 0x00a0 /* GPIO interrupt control */
#define AR5315_GPIODIR_M(x) (1 << (x)) /* mask for i/o */
#define AR5315_GPIODIR_O(x) (1 << (x)) /* output */
#define AR5315_GPIODIR_I(x) 0 /* input */
#define AR5315_GPIOINT_S 0
#define AR5315_GPIOINT_M 0x3F
#define AR5315_GPIOINTLVL_S 6
#define AR5315_GPIOINTLVL_M (3 << AR5315_GPIOINTLVL_S)
#define AR5315_WREV (-0xefbfe0) /* Revision ID register offset */
#define AR5315_WREV_S 0 /* Shift for WMAC revision info */
#define AR5315_WREV_ID 0x000000FF /* Mask for WMAC revision info */
#define AR5315_WREV_ID_S 4 /* Shift for WMAC Rev ID */
#define AR5315_WREV_REVISION 0x0000000F /* Mask for WMAN Revsion version */
#define AR5315_RC_BB0_CRES 0x00000002 /* Cold reset to WMAC0 & WBB0 */
#define AR5315_RC_BB1_CRES 0x00000200 /* Cold reset to WMAC1 & WBB1n */
#define AR5315_RC_WMAC0_RES 0x00000001 /* Warm reset to WMAC 0 */
#define AR5315_RC_WBB0_RES 0x00000002 /* Warm reset to WBB0 */
#define AR5315_RC_WMAC1_RES 0x00020000 /* Warm reset to WMAC1 */
#define AR5315_RC_WBB1_RES 0x00040000 /* Warm reset to WBB */
/*
* PCI-MAC Configuration registers (AR5312)
*/
#define AR5312_RSTIMER_BASE 0xbc003000 /* Address for reset/timer registers */
#define AR5312_GPIO_BASE 0xbc002000 /* Address for GPIO registers */
#define AR5312_WLAN0 0xb8000000
#define AR5312_WLAN1 0xb8500000
#define AR5312_RESET 0x0020 /* Offset of reset control register */
#define AR5312_PCICFG 0x00B0 /* MAC/PCI configuration reg (LEDs) */
#define AR5312_PCICFG_LEDMODE 0x0000001c /* LED Mode mask */
#define AR5312_PCICFG_LEDMODE_S 2 /* LED Mode shift */
#define AR5312_PCICFG_LEDMOD0 0 /* Blnk prop to Tx and filtered Rx */
#define AR5312_PCICFG_LEDMOD1 1 /* Blnk prop to all Tx and Rx */
#define AR5312_PCICFG_LEDMOD2 2 /* DEBG flash */
#define AR5312_PCICFG_LEDMOD3 3 /* BLNK Randomly */
#define AR5312_PCICFG_LEDSEL 0x000000e0 /* LED Throughput select */
#define AR5312_PCICFG_LEDSEL_S 5
#define AR5312_PCICFG_LEDSEL0 0 /* See blink rate table on p. 143 */
#define AR5312_PCICFG_LEDSEL1 1 /* of AR5212 data sheet */
#define AR5312_PCICFG_LEDSEL2 2
#define AR5312_PCICFG_LEDSEL3 3
#define AR5312_PCICFG_LEDSEL4 4
#define AR5312_PCICFG_LEDSEL5 5
#define AR5312_PCICFG_LEDSEL6 6
#define AR5312_PCICFG_LEDSEL7 7
#define AR5312_PCICFG_LEDSBR 0x00000100 /* Slow blink rate if no
activity. 0 = blink @ lowest
rate */
#undef AR_GPIOCR
#undef AR_GPIODO /* Undefine the 5212 defs */
#undef AR_GPIODI
#define AR5312_GPIOCR 0x0008 /* GPIO Control register */
#define AR5312_GPIODO 0x0000 /* GPIO data output access reg */
#define AR5312_GPIODI 0x0004 /* GPIO data input access reg*/
/* NB: AR5312 uses AR5212 defines for GPIOCR definitions */
#define AR5312_WREV 0x0090 /* Revision ID register offset */
#define AR5312_WREV_S 8 /* Shift for WMAC revision info */
#define AR5312_WREV_ID 0x000000FF /* Mask for WMAC revision info */
#define AR5312_WREV_ID_S 4 /* Shift for WMAC Rev ID */
#define AR5312_WREV_REVISION 0x0000000F /* Mask for WMAN Revsion version */
#define AR5312_RC_BB0_CRES 0x00000004 /* Cold reset to WMAC0 & WBB0 */
#define AR5312_RC_BB1_CRES 0x00000200 /* Cold reset to WMAC1 & WBB1n */
#define AR5312_RC_WMAC0_RES 0x00002000 /* Warm reset to WMAC 0 */
#define AR5312_RC_WBB0_RES 0x00004000 /* Warm reset to WBB0 */
#define AR5312_RC_WMAC1_RES 0x00020000 /* Warm reset to WMAC1 */
#define AR5312_RC_WBB1_RES 0x00040000 /* Warm reset to WBB */
#define AR_RAD2112_SREV_MAJOR 0x40 /* 2112 Major Rev */
enum AR5312PowerMode {
AR5312_POWER_MODE_FORCE_SLEEP = 0,
AR5312_POWER_MODE_FORCE_WAKE = 1,
AR5312_POWER_MODE_NORMAL = 2,
};
#endif /* _DEV_AR5312REG_H_ */