cea2b8b915
library:
o) Increase inline unit / large function growth limits for MIPS to accommodate
the needs of the Simple Executive, which uses a shocking amount of inlining.
o) Remove TARGET_OCTEON and use CPU_CNMIPS to do things required by cnMIPS and
the Octeon SoC.
o) Add OCTEON_VENDOR_LANNER to use Lanner's allocation of vendor-specific
board numbers, specifically to support the MR320.
o) Add OCTEON_BOARD_CAPK_0100ND to hard-wire configuration for the CAPK-0100nd,
which improperly uses an evaluation board's board number and breaks board
detection at runtime. This board is sold by Portwell as the CAM-0100.
o) Add support for the RTC available on some Octeon boards.
o) Add support for the Octeon PCI bus. Note that rman_[sg]et_virtual for IO
ports can not work unless building for n64.
o) Clean up the CompactFlash driver to use Simple Executive macros and
structures where possible (it would be advisable to use the Simple Executive
API to set the PIO mode, too, but that is not done presently.) Also use
structures from FreeBSD's ATA layer rather than structures copied from
Linux.
o) Print available Octeon SoC features on boot.
o) Add support for the Octeon timecounter.
o) Use the Simple Executive's routines rather than local copies for doing reads
and writes to 64-bit addresses and use its macros for various device
addresses rather than using local copies.
o) Rename octeon_board_real to octeon_is_simulation to reduce differences with
Cavium-provided code originally written for Linux. Also make it use the
same simplified test that the Simple Executive and Linux both use rather
than our complex one.
o) Add support for the Octeon CIU, which is the main interrupt unit, as a bus
to use normal interrupt allocation and setup routines.
o) Use the Simple Executive's bootmem facility to allocate physical memory for
the kernel, rather than assuming we know which addresses we can steal.
NB: This may reduce the amount of RAM the kernel reports you as having if
you are leaving large temporary allocations made by U-Boot allocated
when starting FreeBSD.
o) Add a port of the Cavium-provided Ethernet driver for Linux. This changes
Ethernet interface naming from rgmxN to octeN. The new driver has vast
improvements over the old one, both in performance and functionality, but
does still have some features which have not been ported entirely and there
may be unimplemented code that can be hit in everyday use. I will make
every effort to correct those as they are reported.
o) Support loading the kernel on non-contiguous cores.
o) Add very conservative support for harvesting randomness from the Octeon
random number device.
o) Turn SMP on by default.
o) Clean up the style of the Octeon kernel configurations a little and make
them compile with -march=octeon.
o) Add support for the Lanner MR320 and the CAPK-0100nd to the Simple
Executive.
o) Modify the Simple Executive to build on FreeBSD and to build without
executive-config.h or cvmx-config.h. In the future we may want to
revert part of these changes and supply executive-config.h and
cvmx-config.h and access to the options contained in those files via
kernel configuration files.
o) Modify the Simple Executive USB routines to support getting and setting
of the USB PID.
85 lines
3.1 KiB
C
85 lines
3.1 KiB
C
/*************************************************************************
|
|
Copyright (c) 2003-2007 Cavium Networks (support@cavium.com). All rights
|
|
reserved.
|
|
|
|
|
|
Redistribution and use in source and binary forms, with or without
|
|
modification, are permitted provided that the following conditions are
|
|
met:
|
|
|
|
* Redistributions of source code must retain the above copyright
|
|
notice, this list of conditions and the following disclaimer.
|
|
|
|
* Redistributions in binary form must reproduce the above
|
|
copyright notice, this list of conditions and the following
|
|
disclaimer in the documentation and/or other materials provided
|
|
with the distribution.
|
|
|
|
* Neither the name of Cavium Networks nor the names of
|
|
its contributors may be used to endorse or promote products
|
|
derived from this software without specific prior written
|
|
permission.
|
|
|
|
This Software, including technical data, may be subject to U.S. export control laws, including the U.S. Export Administration Act and its associated regulations, and may be subject to export or import regulations in other countries.
|
|
|
|
TO THE MAXIMUM EXTENT PERMITTED BY LAW, THE SOFTWARE IS PROVIDED "AS IS"
|
|
AND WITH ALL FAULTS AND CAVIUM NETWORKS MAKES NO PROMISES, REPRESENTATIONS OR WARRANTIES, EITHER EXPRESS, IMPLIED, STATUTORY, OR OTHERWISE, WITH RESPECT TO THE SOFTWARE, INCLUDING ITS CONDITION, ITS CONFORMITY TO ANY REPRESENTATION OR DESCRIPTION, OR THE EXISTENCE OF ANY LATENT OR PATENT DEFECTS, AND CAVIUM SPECIFICALLY DISCLAIMS ALL IMPLIED (IF ANY) WARRANTIES OF TITLE, MERCHANTABILITY, NONINFRINGEMENT, FITNESS FOR A PARTICULAR PURPOSE, LACK OF VIRUSES, ACCURACY OR COMPLETENESS, QUIET ENJOYMENT, QUIET POSSESSION OR CORRESPONDENCE TO DESCRIPTION. THE ENTIRE RISK ARISING OUT OF USE OR PERFORMANCE OF THE SOFTWARE LIES WITH YOU.
|
|
|
|
*************************************************************************/
|
|
/* $FreeBSD$ */
|
|
|
|
#define DEBUGPRINT(format, ...) printf(format, ##__VA_ARGS__)
|
|
|
|
/**
|
|
* Given a packet data address, return a pointer to the
|
|
* beginning of the packet buffer.
|
|
*
|
|
* @param packet_ptr Packet data hardware address
|
|
* @return Packet buffer pointer
|
|
*/
|
|
static inline char *cvm_oct_get_buffer_ptr(cvmx_buf_ptr_t packet_ptr)
|
|
{
|
|
return cvmx_phys_to_ptr(((packet_ptr.s.addr >> 7) - packet_ptr.s.back) << 7);
|
|
}
|
|
|
|
|
|
/**
|
|
* Given an IPD/PKO port number, return the logical interface it is
|
|
* on.
|
|
*
|
|
* @param ipd_port Port to check
|
|
*
|
|
* @return Logical interface
|
|
*/
|
|
static inline int INTERFACE(int ipd_port)
|
|
{
|
|
if (ipd_port < 32) /* Interface 0 or 1 for RGMII,GMII,SPI, etc */
|
|
return ipd_port>>4;
|
|
else if (ipd_port < 36) /* Interface 2 for NPI */
|
|
return 2;
|
|
else if (ipd_port < 40) /* Interface 3 for loopback */
|
|
return 3;
|
|
else if (ipd_port == 40) /* Non existant interface for POW0 */
|
|
return 4;
|
|
else
|
|
panic("Illegal ipd_port %d passed to INTERFACE\n", ipd_port);
|
|
}
|
|
|
|
|
|
/**
|
|
* Given an IPD/PKO port number, return the port's index on a
|
|
* logical interface.
|
|
*
|
|
* @param ipd_port Port to check
|
|
*
|
|
* @return Index into interface port list
|
|
*/
|
|
static inline int INDEX(int ipd_port)
|
|
{
|
|
if (ipd_port < 32)
|
|
return ipd_port & 15;
|
|
else
|
|
return ipd_port & 3;
|
|
}
|
|
|