freebsd-nq/sys/mips/conf/PICOSTATION_M2HP
Hiren Panchasara 631f16444a Add device PicoStation M2HP support.
This is a nice small outdoor/indoor AP from Ubiquity Networks.

The device has:
AR7241 CPU SoC
AR9287 Wifi
8MB flash
32MB RAM

wifi has been tested to work along with leds.

Submitted by:   loos
Approved by:    sbruno (mentor, implicit)
Tested by:      hiren
2013-08-30 20:46:01 +00:00

69 lines
1.6 KiB
Plaintext

#
# Specific board setup for the Picostation M2 HP board.
#
# This board has the following hardware:
#
# + AR7241 CPU SoC
# + AR9287 Wifi
# + Integrated switch (XXX speed?)
# + 8MB flash
# + 32MB RAM
# + uboot environment
# $FreeBSD$
include "AR724X_BASE"
ident "PICOSTATION_M2HP"
hints "PICOSTATION_M2HP.hints"
options AR71XX_REALMEM=32*1024*1024
options AR71XX_ENV_UBOOT
# Limit inlines
makeoptions INLINE_LIMIT=768
# We bite the performance overhead for now; the kernel won't
# fit if the mutexes are inlined.
options MUTEX_NOINLINE
options RWLOCK_NOINLINE
options SX_NOINLINE
# There's no need to enable swapping on this platform.
options NO_SWAPPING
# For DOS - enable if required
# options MSDOSFS
# uncompress - to boot read-only lzma natively from flash
device geom_uncompress
options GEOM_UNCOMPRESS
options ROOTDEVNAME=\"ufs:/dev/map/rootfs.uncompress\"
# Not enough space for these..
nooptions INVARIANTS
nooptions INVARIANT_SUPPORT
nooptions WITNESS
nooptions WITNESS_SKIPSPIN
nooptions DEBUG_REDZONE
nooptions DEBUG_MEMGUARD
# Used for the static uboot partition map
device geom_map
# Options needed for the EEPROM based calibration/PCI configuration data.
options AR71XX_ATH_EEPROM # Fetch EEPROM/PCI config from flash
options ATH_EEPROM_FIRMWARE # Use EEPROM from flash
device firmware # Used by the above
# Options required for miiproxy and mdiobus
options ARGE_MDIO # Export an MDIO bus separate from arge
device miiproxy # MDIO bus <-> MII PHY rendezvous
device etherswitch
device arswitch
# Enable GPIO
device gpio
device gpioled