Adrian Chadd ea75088478 Add STBC TX support for AR5416 HAL chips. ...

Specifically, however:

* AR9280 and later support 1-stream STBC RX;
* AR9280 and AR9287 support 1-stream STBC TX.

The STBC support isn't announced (yet) via net80211 and it isn't at all
chosen by the rate control code, so there's no real consumer of this
yet.

Obtained from:	Qualcomm Atheros

2012-07-27 11:54:05 +00:00

..

ar2133.c

Add the 11n chipset RF frontends to the linker set, even though they're not

2011-12-15 00:59:11 +00:00

ar5416_ani.c

Change the MIB cycle count API to return HAL_BOOL, rather than uint32_t,

2012-05-01 14:48:51 +00:00

ar5416_attach.c

Add some AR5416/AR5418 WAR's for power-on and suspend/resume:

2012-05-25 17:53:57 +00:00

ar5416_beacon.c

The AR5212 setup path (also used by the AR5416 code) configures a

2011-09-28 03:03:23 +00:00

ar5416_btcoex.c

Bring over the initial 802.11n bluetooth coexistence support code.

2012-06-26 22:16:53 +00:00

ar5416_btcoex.h

Remove duplicate entries.

2012-06-27 03:00:29 +00:00

ar5416_cal_adcdc.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_cal_adcgain.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_cal_iq.c

Fix the calibration logic to correctly clamp the calculated coefficient.

2010-08-14 15:28:15 +00:00

ar5416_cal.c

Bump this up to where it used to be.

2011-11-09 23:28:47 +00:00

ar5416_cal.h

Introduce methods for the initial calibration and the new PA calibration

2011-03-11 11:35:36 +00:00

ar5416_eeprom.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_gpio.c

Bring over the initial 802.11n bluetooth coexistence support code.

2012-06-26 22:16:53 +00:00

ar5416_interrupts.c

Squirrel away the SYNC interrupt in case we're doing interrupt debugging.

2012-04-10 07:11:33 +00:00

ar5416_keycache.c

Replace Id keyword with the FreeBSD keyword.

2010-01-29 10:07:17 +00:00

ar5416_misc.c

Migrate the MAC/BB hang structures out from ar5416_misc.h into the HAL.

2012-07-01 03:15:18 +00:00

ar5416_phy.c

Modify the AR5416 11na rate table to use 24mb OFDM 11a for control traffic,

2011-02-21 05:10:34 +00:00

ar5416_power.c

Both linux ath9k and the reference driver initialises the PLL here

2012-04-14 04:40:11 +00:00

ar5416_radar.c

Break out the radar code into a separate source file.

2012-02-20 03:07:07 +00:00

ar5416_recv.c

Fix a subtle corner case surrounding the handling of OFDM restart along

2012-06-27 05:23:33 +00:00

ar5416_reset.c

After thinking about this a bit more, let's not keep statistics per-channel

2012-04-28 22:03:19 +00:00

ar5416_xmit.c

Add STBC TX support for AR5416 HAL chips.

2012-07-27 11:54:05 +00:00

ar5416.h

Bring this API in line with what the reference driver and Linux ath9k

2012-07-27 11:23:24 +00:00

ar5416.ini

Fix the addac serial load register write for AR5416.

2011-09-06 10:49:05 +00:00

ar5416desc.h

Add some 11n bits from the if_ath_tx 11n branch:

2011-10-25 23:09:07 +00:00

ar5416phy.h

Add the BT register definitions for AR9285/AR9287 BT coexistence.

2012-04-26 02:03:16 +00:00

ar5416reg.h

* According to the reference code, AR_WA_D3_L1_DISBABLE is bit 14.

2012-05-25 16:45:56 +00:00