- for now, alignments bigger that page size is allowed only for buffers
allocated by bus_dmamem_alloc(), cover this fact by KASSERT.
- never bounce buffers allocated by bus_dmamem_alloc(), these always comply
with the required rules (alignment, boundary, address range).
MFC after: 1 week
Reviewed by: jah
PR: 235542
Avoid setting zero bytes beyond the length of the 'thisline' parameters
in i_process() and u_process(), and don't attempt to memset a negative
number of bytes.
MFC after: 1 week
Replace calls to sinf(x) and cosf(x) with a single call to sincosf().
Submitted by: Steve Kargl <sgk@troutmask.apl.washington.edu>
Reviewed by: bde
Approved by: grog
MFC after: 3 days
reading some events from the interrupt status registers. These events
are reported to devd via system "PMU" and subsystem "Battery", "AC"
and "USB" such as plugged/unplugged, absent, charged and charging.
Reviewed by: manu
Differential Revision: https://reviews.freebsd.org/D19116
Make every rockchip file depend on the multiple soc_rockchip options
While here make rk_i2c and rk_gpio depend on their device options.
Reported by: sbruno
The COVERAGE option breaks xtoolchain-gcc GENERIC kernel early boot
extremely badly and hasn't been fixed for the ~week since it was committed.
Please enable for GENERIC only when it doesn't do that.
Related fallout reported by: lwhsu, tuexen (pr 235611)
This can aid with debugging when a thread is running and has no backtrace.
State can be estimated based on the pcb, and refined from there, for
example, to get a rough idea of the stack pointer.
r241119 that's performed globally by device_attach(9).
- As for the EM-class of devices, em(4) supports multiple queues
and MSI-X respectively only with 82574 devices. However, since
the conversion to iflib(4), em(4) relies on the interrupt type
fallback mechanism, i. e. MSI-X -> MSI -> INTx, of iflib(4) to
figure out the interrupt type to use for the EM-class (as well
as the IGB-class) of MACs. Moreover, despite the datasheet for
82583V not mentioning any support of MSI-X, there actually are
82583V devices out there that report a varying number of MSI-X
messages as supported. The interrupt type fallback of iflib(4)
is causing two failure modes depending on the actual number of
MSI-X messages supported for such instances of 82583V:
1) With only one MSI-X message supported, none is left for the
RX/TX queues as that one message gets assigned to the admin
interrupt. Worse, later on - which will be addressed with a
separate fix - iflib(4) interprets that one messages as MSI
or INTx to be set up, but fails to actually do so as it has
previously called pci_alloc_msix(9). [1, 2]
2) With more message supported, their distribution is okay but
then em_if_msix_intr_assign() doesn't work for 82583V, with
the interface being left in a non-working state, too. [3]
Thus, let em_if_attach_pre() indicate to iflib(4) to try MSI-X
with 82574 only, and at most MSI for the remainder of EM-class
devices.
While at it, remove "try_second_bar" as it's polarity inverted
and not actually needed.
- Remove code from em_if_timer() that effectively is a NOP since
the conversion to iflib(4) ("trigger" is no longer read).
While at it, let the comment for em_if_timer() reflect reality
after said conversion.
- Implement an ifdi_watchdog_reset method which only updates the
em(4) "watchdog_events" counter but doesn't perform any reset,
so that the em(4) "watchdog_timeouts" SYSCTL (iflib(4) doesn't
provide a counterpart) reflects reality and these timeouts add
to IFCOUNTER_OERRORS again after the iflib(4) conversion.
- Remove the "mbuf_defrag_fail" and "tx_dma_fail" SYSCTLS; since
the iflib(4) conversion, associated counters are disconnected,
but iflib(4) provides "mbuf_defrag_failed" and "tx_map_failed"
respectively as equivalents.
- Move the description preceding lem_smartspeed() to the correct
spot before em_reset() and bring back appropriate comments for
{igb,em}_initialize_rss_mapping() and lem_smartspeed() lost in
the iflib(4) conversion.
- Adapt some other function descriptions and INIT_DEBUGOUT() use
to match reality after the iflib(4) conversion.
- Put the debugging message of em_enable_vectors_82574() (missed
in r343578) under bootverbose, too.
PR: 219428 [1], 235246 [2], 235147 [3]
Reviewed by: erj (previous version)
Differential Revision: https://reviews.freebsd.org/D19108
It is currently re-declared in sys/sysent.h which is a wrong place for
MD variable. Which causes redeclaration error with gcc when
sys/sysent.h and machine/md_var.h are included both.
Remove it from sys/sysent.h and instead include machine/md_var.h when
needed, under #ifdef for both i386 and amd64.
Reported and tested by: bde
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The MPC8540 is actually e500v1, which doesn't have double-precision floating
point support. The 8548 does, so use that as the CPU target.
MFC after: 2 weeks
r343896 made it such that a non-zero exit status was passed through, but was
still wrong if the script exits on a signal. POSIX does not say what the
WEXITSTATUS macro returns in this case and in practice 0 is a common value.
Instead, translate the wait status into 8 bits the same way as the shell
calculates $?.
Reviewed by: kib, Nash Kaminski
MFC after: 1 week
Instead of using pw to modify group membership, users often edit
/etc/group by hand, which is discouraged. Provide an example of
adding a user to the wheel group, which is a common use case.
I'm using a different user here as in the previous example as that
deleted the user (although the examples don't necessarily have to
be followed in order).
Reviewed by: rgrimes,0mp
Approved by: 0mp
MFC after: 3 days
Differential Revision: https://reviews.freebsd.org/D19123
sysctl variable net.inet.tcp.cc.cdg.smoothing_factor to 0, the smoothing
is disabled. Without this patch, a division by zero orrurs.
PR: 193762
Reviewed by: lstewart@, rrs@
MFC after: 3 days
Sponsored by: Netflix, Inc.
Differential Revision: https://reviews.freebsd.org/D19071
When configured with more tx queues than rx queues,
em_if_msix_intr_assign() was incorrectly routing the tx event
interrupts.
Reviewed by: erj, marius
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D19070
There are many cases which this code does not handle (e.g. ZFS mirrors)
but the code can handle the single-disk case -- so it's enough to take
care of the "disk image which gets booted into a VM with a larger than
expected disk" case for which this firstboot script was created.
MFC after: 1 week
Differential Revision: https://reviews.freebsd.org/D19095
trig_test.reduction test cases to fail, if the fixes from r343916 have
not yet been applied to the base compiler.
Reported by: lwhsu
PR: 234040
Upstream PR: https://bugs.llvm.org/show_bug.cgi?id=40206
MFC after: 1 week
[X86] Add FPSW as a Def on some FP instructions that were missing it.
Pull in r353141 from upstream llvm trunk (by Craig Topper):
[X86] Connect the default fpsr and dirflag clobbers in inline
assembly to the registers we have defined for them.
Summary:
We don't currently map these constraints to physical register numbers
so they don't make it to the MachineIR representation of inline
assembly.
This could have problems for proper dependency tracking in the
machine schedulers though I don't have a test case that shows that.
Reviewers: rnk
Reviewed By: rnk
Subscribers: eraman, llvm-commits
Tags: #llvm
Differential Revision: https://reviews.llvm.org/D57641
Pull in r353489 from upstream llvm trunk (by Craig Topper):
[X86] Add FPCW as a register and start using it as an implicit use on
floating point instructions.
Summary:
FPCW contains the rounding mode control which we manipulate to
implement fp to integer conversion by changing the roudning mode,
storing the value to the stack, and then changing the rounding mode
back. Because we didn't model FPCW and its dependency chain, other
instructions could be scheduled into the middle of the sequence.
This patch introduces the register and adds it as an implciit def of
FLDCW and implicit use of the FP binary arithmetic instructions and
store instructions. There are more instructions that need to be
updated, but this is a good start. I believe this fixes at least the
reduced test case from PR40529.
Reviewers: RKSimon, spatel, rnk, efriedma, andrew.w.kaylor
Subscribers: dim, llvm-commits
Tags: #llvm
Differential Revision: https://reviews.llvm.org/D57735
These should fix a problem in clang 7.0 where it would sometimes emit
long double floating point instructions in a slightly wrong order,
leading to failures in our libm tests. In particular, the cbrt_test
test case 'cbrtl_powl' and the trig_test test case 'reduction'.
Also bump __FreeBSD_cc_version, to be able to detect this in our test
suite.
Reported by: lwhsu
PR: 234040
Upstream PR: https://bugs.llvm.org/show_bug.cgi?id=40206
MFC after: 1 week
When loading bigger variables form UEFI it is necessary to know their
size beforehand, so that an appropriate amount of memory can be
allocated. The easiest way to do this is to try to read the variable
with buffer size equal 0, expecting EFI_BUFFER_TOO_SMALL error to be
returned. Allow such possible approach in efi_getenv routine.
Extracted from a bigger patch as suggested by imp.
Submitted by: Kornel Duleba <mindal@semihalf.com>
Obtained from: Semihalf
Sponsored by: Stormshield
- CID 1394815, CID 1305673: Dereference before null check - memory was
allocated and the allocation checked for NULL with a call to errx()
if it failed. Code below that was guaranteed that the pointer was
non-NULL, but there was another check for NULL at the exit of the
function (after the memory had already been referenced). Eliminate
the useless NULL check.
- CID 1007454, CID 1007453: Resource leak - The result of a strdup()
was stored in a global variable and not freed before program exit.
- CID 1007452: Resource leak - Storage intended to be allocated and
returned to the caller was never freed. This was the result of a
regression in the function signature introduced in r208648 (2010)
(thanks for that find, @cem!). Fixed by altering the function
signature and passing the allocated memory to the caller as
intended. This also fixes PR158794.
- CID 1008620: Logically dead code in newsyslog.c - This was a direct
result of CID 1007452. Since the memory allocated as described there
was not returned to the caller, a subsequent check for the memory
having been allocated was dead code. Returning the memory
re-animates the code that is the subject of this CID.
- CID 1006131: Unused value - in parsing a configuration file, a
pointer to the end of the last field was saved, but not used after
that. Rewrite to use the pointer value. This could have been fixed
by avoiding the assignment altogether, but this solutions more
closely follows the pattern used in the preceding code.
PR: 158794
Reported by: Coverity, Ken-ichi EZURA <k.ezura@gmail.com> (PR158794)
Reviewed by: cem, markj
MFC after: 1 week
Sponsored by: Dell EMC Isilon
Tested using the virtual_bt_speaker(8) tool from the virtual_oss(8)
project at github.com.
PR: 210089
MFC after: 1 week
Sponsored by: Mellanox Technologies
The vp vnode is unlocked during the execution of the VOP method and
can be reclaimed, zeroing vp->v_data. Caching allows to use the
correct mount point.
Reported and tested by: pho
PR: 235549
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
This is also OpenBSD rev. 1.117, as pointed out by
Ryan Moeller <ryan@ixsystems.com>.
Submitted by: Nash Kaminski <nashkaminski@gmail.com>
MFC after: 1 week
When renameat(2) is used with:
- absolute path for to;
- tofd not set to AT_FDCWD;
- the target exists
kern_renameat() requires CAP_UNLINK capability on tofd, but
corresponding namei ni_filecap is not initialized at all because the
lookup is absolute. As result, the check was done against empty filecap
and syscall fails erronously.
Fix it by creating a return flags namei member and reporting if the
lookup was absolute, then do not touch to.ni_filecaps at all.
PR: 222258
Reviewed by: jilles, ngie
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
X-MFC-note: KBI breakage
Differential revision: https://reviews.freebsd.org/D19096
Code after exec_fail_dealloc label expects that the image vnode is
locked if present. When copyout() of the strings or auxv vectors fails,
goto to the error handling did not relocked the vnode as required.
The copyout() can be made failing e.g. by creating an ELF image with
PT_GNU_STACK segment disabling the write.
Reported by: Jonathan Stuart <n0t.jcs@gmail.com> (found by fuzzing)
Sponsored by: The FreeBSD Foundation
MFC after: 3 days
Back in 1993, the fgetln (then fgetline) interface was changed to not
return a C string. The change was accomplished by ifdefing out the code
that did the termination. Changing the interface would violate our API
stability rules so remove the old implementation.
Sponsored by: DARPA, AFRL
Refactor the function calls and tests so that, on UFS, the proper fields
are filled out.
PR: 233849
Reported by: Andre Albsmeier
Reviewed by: mav, delphij
MFC after: 1 month
Sponsored by: iXsystems Inc
Differential Revision: https://reviews.freebsd.org/D18785
