being requested is outside of the range of the direct map region. eg:
for pci windows. While here, increase the minimum size of the direct
map region to be 4GB instead of 1GB.
so can leave stale data in the buffer and confuse the driver.
- enable the ability to set the 'disable' hint for the driver to keep it
from attaching. i.e. 'hw.ips.0.disable=1' will prevent the driver from
attaching.
- Only detach if attach suceeded.
Submitted by: mjacob
Before, we would add/subtract the leap second when the system had been
up for an even multiple of days, rather than at the end of the day, as
a leap second is defined (at least wrt ntp). We do this by
calculating the notion of UTC earlier in the loop, and passing that to
get it adjusted. Any adjustments that ntp_update_second makes to this
time are then transferred to boot time. We can't pass it either the
boot time or the uptime because their sum is what determines when a
leap second is needed. This code adds an extra assignment and two
extra compare in the typical case, which is as cheap as I could made
it.
I have confirmed with this code the kernel time does the correct thing
for both positive and negative leap seconds. Since the ntp interface
doesn't allow for +2 or -2, those cases can't be tested (and the folks
in the know here say there will never be a +2s or -2s leap event, but
rather two +1s or -1s leap events).
There will very likely be no leap seconds for a while, given how the
earth is speeding up and slowing down, so there will be plenty of time
for this fix to propigate. UT1-UTC is currently at "about -0.4s" and
decrementing by .1s every 8 months or so. 6 * 8 is 48 months, or 4
years.
-stable has different code, but a similar bug that was introduced
about the time of the last leap second, which is why nobody has
noticed until now.
MFC After: 3 weeks
Reviewed by: phk
"Furthermore, leap seconds must die." -- Cato the Elder
incremented at the start of the leap second, not after the leap second
has been inserted. This is because at the start of the leap second,
we set the time back one second. This setting back one second is the
moment that the offset changes. The old code set it back after the
leap second, but that's one second too late. The negative leap second
case is handled correctly.
Reviewed by: phk
of pcpu locks. This makes uma_zone somewhat smaller (by (LOCKNAME_LEN *
sizeof(char) + sizeof(struct mtx) * maxcpu) bytes, to be exact).
No Objections from jeff.
short read operations at the end of a file to not have the "eof"
flag set as they should. The problem is that the requested read
count was compared against the rounded-up reply data length instead
of the actual reply data length. This bug appears to have been
introduced in revision 1.78 (June 1999). It causes first-time reads
of certain file sizes (e.g 4094 bytes) to fail with EIO on a RedHat
9.0 NFSv3 client.
MFC after: 1 week
build it on the i386 and alpha architectures, where this has been
set up (there is also a sparc64-bitops.h in sys/gnu/ext2fs, but it
appears to be broken and it is not linked up).
This should unbreak the sparc64 LINT build.
in the netisr case. This would result in a lock reversal. This
fixes the net.isr.enable=1 case. Better performance might be
obtained by chaining all packets received, dropping the lock, and
then calling if_input() on each one.
Reported by: hmp
of the contents of the CCSCBCTL register into our
local varaible. The other bits are used in later tests.
This avoids a potential deadlock in ahd_run_qoutfifo()
if we happen to catch the DMA engine in just the right
state.
built by LINT. Also override a number of knobs for enabling and
disabling various modules in the ALL_MODULES case to further increase
LINT's module coverage.
Submitted by: ru
o code reorg (relative to old netbsd-derived code) for future growth
o drivers now specify available channels and rates and 802.11 layer handles
almost all ifmedia actions
o multi-mode support for 11a/b/g devices
o 11g protocol additions (incomplete)
o new element id additions (for other than 11g)
o node/station table redone for proper locking and to eliminate driver
incestuousness
o split device flags and capabilities to reduce confusion and provide room
for expansion
o incomplete power management infrastructure (need to revisit)
o incomplete hooks for software retry
o more...
