with this configuration, but Ruslan tells me that I was probably mistaken,
and on retest the .5 pages are being installed just fine.
Therefore reverse the MAN[58] change in favor of the more modern syntax.
Submitted by: ru
but it is possible:
1. Read data from good component for synchronization.
2. Write data to the same area.
3. Write synchronization data, which are now stale.
Found by: tegge
the base-system. Adding the port for ia64 on disc1 is especially bogus,
because the port doesn't even build on ia64. It also doesn't support
libthread_db.
mutexes instead.
This closes the last (known) race issues in ATA which should fix
the various hangs etc seen on heavy loaded systems.
Change from using timeout functions to using callout functions in
the timeout code. This together with above closes the race that could
happen if timeout and device interrupt occured simultaniously.
Also fix the possible recursion in ata_reinit() on very dodgy
devices that could take us down in the probe.
the signal mask and pending signals of the calling thread. These
are stored in userland in libpthread.
There is a small race condition in this patch which could cause
problems if a signal arrives after setting the (kernel) signal
mask and before exec'ing. The thread's set of pending signals
also are not yet installed in the exec'd process. Both of these
will be corrected with the addition of a special syscall.
Reported & Tested by: Joost Bekkers <joost at jodocus dot org>
Reviewed by: julian, davidxu
the trapframe via kdb_frame, but kdb_frame was not initialized until
after the call to kdb_cpu_trap(). Ergo: kdb_cpu_trap() was moved too
far up.
Pointy hat: marcel
1. Install man files and links for the lwres library.
2. Fix the path in various files to say /etc/namedb/ instead of just /etc.
3. Correctly install the conf file man pages for named and rndc.
the mbuf due to use of m_pulldown. Discarding the result because of this
does not make sense as no subsequent code depends on the entire msg being
linearized (only the individual pieces). It's likely something else is wrong
here but for now this appears to get things back to a working state.
Submitted by: Roselyn Lee
chrooted the pid symlink code should not fire. Also, remove the quotes
around the chroot variable in the rndc-confgen invocation so that if
not chrooted the command will still succeed.
Pointed out by: Sean McNeil <sean@mcneil.com>
I have from Broadcom does not give much information on these devices,
so the Broadcom Linux driver was used for clues to what these chips
support. It turns out they are similar to the 5705 with the 5751
being the PCI-Express version and needing special work-arounds and
settings.
