To preserve the existing behavior of etc/rc.d/netif, add code to wait
up to if_up_delay seconds (30 seconds by default) for a default route to
be configured if there are any dhcp interfaces. This should be extended
to test that the interface is actually up.
X-MFC after:
more wlans_<ifn> and create_args_<ifn>
Add documentation for these variants and generally update the wireless
device example.
There is are very short lived shim from vaps_<ifn> which produces
a warning and vap_create_<ifn> which does not. Misuse the MFC
notification service to remind me to remove them.
MFC after: 3 weeks
wpa_supplicant expects that it has exclusive access to the net80211 state so
when its starts poking in the WEP/WPA settings and the card is already
scanning it can cause net80211 to try and associate incorrectly with a
protected AP.
This is an inconvenience for firmware based cards such as iwi where it can be
sent an auth instruction with incomplete security info and cause a firmware
error.
Remove the 'ifconfig up' from network.subr since wpa_supplicant will
immediately down the interface again.
Reported by: Guy Helmer (and others)
Reviewed by: sam, brooks, avatar
MFC after: 3 days
All xxx_<ifname> flags are set to empty strings automatically earlier so
eval echo \${${prefix}${_if}${suffix}-${_default}}
not substitute the default but return just the empty string.
Fix it using
eval echo \${${prefix}${_if}${suffix}:-${_default}}
(i.e. treat empty strings as unset)
The bug manifistates itself with the following warning from checkyesno():
/etc/rc.d/dhclient: WARNING: $background_dhclient is not set properly -
see rc.conf(5)
Note: This also deprecates "NO" as a way to specify an empty list of
interfaces for gif_interfaces.
PR: conf/104884
Submitted by: nork
Harassed by: brd
Discussed with: brooks, dougb
interface is an IPv6 interface.
Use this method to decide if we should attempt to configure an interface
with an IPv6 address in pccard_ether. The mechanism pccard_ether uses
to do this is unsuited to the task because it assumes the list of
interfaces it is passed is the full list of IPv6 interfaces and makes
decissions based on that. This is at least a step in the right
direction and is probably about as much as we can MFC safely.
PR: conf/103428
MFC after: 3 days
touch interfaces that don't actually exist in the stop case. In the
process move some IPv4 specific code from ifconfig_down to ipv4_down.
This should solve problems with ifconfig: error messages on boot when
interfaces are renamed.
working on.
1) Make it possible to configure interfaces with certain characters in
their names that aren't valid in shell variables. Currently supported
characters are ".-/+". They are converted into '_' characters.
2) Replace nearly all eval statements in network.subr with a new
function get_if_var which substitues an interface name (after the
translations above) for "IF" in a variable name.
3) Fix list_net_interfaces() in the nodhcp case.
4) Allow the administrator to specify if dhclient should be started
when /etc/rc.d/netif configures the interface or only by devd.
This can be set on both a per interface and system wide basis.
PR: conf/88974 [1,2], conf/92433 [1,2]
more IPv4 address from a ranged list in CIRD notation:
ipv4_addrs_ed0="192.168.0.1/24 192.168.1.1-5/28"
In the process move alias processing into new ipv4_up/down functions to
more toward a less IPv4 centric world.
Submitted by: Philipp Wuensche <cryx dash freebsd at h3q dot com>
- If an interface's ifconfig_<ifn> is set, but empty, don't set it to
ifconfig_DEFAULT. This way interfaces can be disabled even in the
presence of ifconfig_DEFAULT.
- When listing interfaces and network_interfaces=auto, place lo0 first
if it's around.
now run on any interface.
- Add a new ifconfig_<ifn> keyword, NOAUTO which prevents configuration
of an interface at boot or via /etc/pccard_ether. This allows
/etc/rc.d/netif to be used to start and stop an interface on a purely
manual basis. The decision to affect pccard_ether may be revisited at
a later date.
Requested by: imp, gallatin (removable_interfaces)
Discussed with: sam, Randy Bush (NOAUTO)
ifconfig_DEFAULT variable. Unlike pccard_ifconfig, ifconfig_DEFAULT
applies to all interfaces that do not specify an ifconfig_<ifn>
variable rather than just those listed in removable_interfaces.
- Correct the list of interfaces when network_interfaces and
removable_interfaces are both set by including removable_interfaces
in the list of canidates.
- When listing dhcp interfaces, include those with other ifconfig
options so nat works.
Approved by: re (network interface startup blanket)
way interfaces are configured. Some key points:
- At startup, all interfaces are configured through /etc/rc.d/netif.
- ifconfig_<if> variables my now mix real ifconfig commands the with
DHCP and WPA directives. For example, this allows media
configuration prior to running dhclient.
- /etc/rc.d/dhclient is not run at startup except by netif to start
dhclient on specific interfaces.
- /etc/pccard_ether calls "/etc/rc.d/netif start <if>" to do most of
it's work.
- /etc/pccard_ether no longer takes additional arguments to pass to
ifconfig. Instead, ifconfig_<if> variables are now honored in favor
of pccard_ifconfig when available.
- /etc/pccard_ether will only run on interfaces specified in
removable_interfaces, even if pccard_ifconfig is set.
ifnet_rename() to support situations where rc.conf's $network_interfaces
variable is set to an explicit list of network interfaces (instead of
the default "auto").
Using "list_network_interfaces all" resulted in using
$network_interfaces for both interface _renaming_ and interface
_configuration_ which obviously cannot work either before (if the
new name is in $network_interfaces) or after (if the old name is in
$network_interfaces) renaming the interface.
from list_net_interfaces() when network_interfaces=auto.
Rationale: Since the auto case is special, the lesser evil
had to be chosen among not adding cloned interfaces to
_tmplist or removing duplicates from _tmplist after adding
cloned interfaces. Since list_net_interfaces() must not use
/usr/bin tools, the former "evil" appeared clearer and much
more efficient. (See the PR audit trail for discussion.)
PR: conf/63700
Reviewed by: brooks
MFC after: 5 days
There are now many configurations which have a NIC on board, and
pccard slots. If a dhclient is running on the internal nic, the
Improve the handling dhcp handling of pccard_ether.
Improve the dhcp handling of pccard_ether.
There are now many configurations which have a NIC on board and
Improve the dhcp handling of pccard_ether.
There are now many configurations which have a NIC on board and
cardbus slots too. If a dhclient was already running on the internal
NIC, the user was forced to kill a running dhclient manually.
If now a pccard is included at startup time, /etc/rc.d/dhclient
start does include it into the startup list for dhcp devices.
That means you can now do dhcp on the internal and the pccard devices
at the same time. If the card is plugged in later, a running dhclient
(working for the internal interface only) is killed, and restarted,
but the interface name of the new pccard is added to the internal
name. After removal, /etc/rc.d/dhclient is started again. This
script does nothing if there are no devices in /etc/rc.conf
This is only a workaround for a well known problem. After we have
a dhcp client which handles device adding and removal, it will go
away.
interfaces, interface aliases, user supplied ifconfig scripts, and
ipx interfaces. The ipx routine fails unconditionaly at the moment.
Someone who has a need for it can fill it in with the appropriate incantations.
o /etc/network.subr contains common subroutines used for seting
up network interfaces
o rc.d/hostname sets the hostname if not already set
o rc.d/nisdomain sets the nis domain *after* rpcbind but
before the yp* daemons. This fixes issues with temporary
hangs when looking up informaion in nis before it's ready.
o rc.d/netif brings network interfaces (minus dhcp) up.
o rc.d/network1 has been disabled and will be retired before
RELENG_5. It will be replaced by rc.d/netif
Approved by: markm (mentor)
devd later in the boot process. This should fix all the problems
people have had with those commits. Diskless should be working again,
and those that mount /usr with nfs should be able to do that again too.
* Space -> tabs conversion.
* Removed blanks before semicolon in "if ... ; then".
* Proper indentation of misindented lines.
* Put a full stop after some comments.
* Removed whitespace at end of line.
Approved by: silence from gordon