OpenBSD's if_ral.c.
I didn't make the LINKSYS4 -> CISCOLINKSYS name change, nor did I
include the RALINK RT2573 that's supported by the rum(4) driver. I
didn't merge any code changes either.
"0" cannot be a correct value since when the function is entered at least
one shared holder must be present and since we want the last one "1" is
the correct value.
Note that lock_profiling for sx locks is far from being perfect.
Expect further fixes for that.
Approved by: jeff (mentor)
patch:
- Do the correct test for ldt allocation
- Drop dt_lock just before to call kmem_free (since it acquires blocking
locks inside)
- Solve a deadlock with smp_rendezvous() where other CPU will wait
undefinitively for dt_lock acquisition.
- Add dt_lock in the WITNESS list of spinlocks
While applying these modifies, change the requirement for user_ldt_free()
making that returning without dt_lock held.
Tested by: marcus, tegge
Reviewed by: tegge
Approved by: jeff (mentor)
race seen on smp laptops when suspending where the rx task can be
entered after the interface is detach'd.
NB: use of taskqueue_drain while holding the softc mutex is problematic
Submitted by: ambrisko
MFC after: 1 month
It is disabled by default. You need to put
LOADER_FIREWIRE_SUPPORT=yes in /etc/make.conf
and rebuild loader to enable it.
(cd /sys/boot/i386 && make clean && make && make install)
You can find a short introduction of dcons at
http://wiki.freebsd.org/DebugWithDcons
as to the type of the command argument: int -> u_long.
These types have different widths in the 64-bit world.
Add a note to UPDATING because the change breaks KBI
on 64-bit platforms.
Discussed on: -net, -current
Reviewed by: bms, ru
hold a wq lock for the iterator. Panda uses a
silly recursive lock they hold through the timer.
- Add poor mans wireshark compile option..
- Allocate and start using SCTP_M_XXX for all SCTP_MALLOC() calls.
- sysctl now will get back the refcnt for viewing by onlookers.
Reviewed by: gnn
used to return PAGE_SIZE without respect to restrictions of a DMA tag.
This affected all of the busdma load functions that use
_bus_dmamap_loader_buffer() as their back-end.
Reviewed by: scottl
arm and powerpc have 64KB as the maximum argument size, so one
cannot run "make delete-old" on arm or powerpc anymore. Stop
special-casing powerpc and give it 256KB of arguments like all
other platforms, but keep arm on 64KB for now. There may be a
purpose to it that doesn't exist for powerpc.
produced incorrect behaviour with the KDB_UNATTENDED option) and call
panic in both the KDB and non-KDB cases. This change is consistent
with rwatson's current kdb/ddb work.
by the subsequent mix_setdevs() and friends.
- Minor style(9) declaration arrangement nit.
Requested by: joeld
Submitted by: pluknet <pluknet@gmail.com>
Note on dcons:
To enable dcons in kernel, put the following lines in /boot/loader.conf.
You may also want to enable dcons in /etc/ttys.
boot_multicons="YES"
#Force dcons to be the high-level console if a firewire bus presents.
#hw.firewire.dcons_crom.force_console=1
FireWire/dcons support in loader will come shortly.
(i386/amd64 only)
- bounded cookie-life to 1 second minimum in socket option set.
- Delayed_ack_time becomes delayed_ack per new socket api document.
- Improve port number selection, we now use low/high bounds and
no chance of a endless loop. Only one call to random per bind
as well.
- fixes so set_peer_primary pre-screens addresses to be
valid to this host.
- maxseg did not allow setting on an assoc basis. We needed
to thus track and use an association value instead of a inp value.
- Fixed ep get of HB status to report back properly.
- use settings flag to tell if assoc level hb is on off not
the timer.. since the timer may still run if unconf address
are present.
- check for crazy ENABLE/DISABLE conditions.
- set and get of pmtud (fixed path mtu) not always taking into account ovh.
- Getting PMTU info on stcb only needs to return PMTUD_ENABLED if
any net is doing PMTU discovery.
- Panic or warning fixed to not do so when a valid ip frag is
taking place.
- sndrcvinfo appearing in both inp and stcb was full size, instead
of the non-pad version. This saves about 92 bytes from each struct
by carefully converting to use the smaller version.
- one-2-one model get(maxseg) would always get ep value, never the
tcb's value.
- The delayed ack time could be under a tick, this fixes so
it bounds it to at least 1 tick for platforms whos tick
is more than a ms.
- Fragment interleave level set to wrong default value.
- Fragment interleave could not set level 0.
- Defered stream reset was broken due to a guard check and ntohl issue.
- Found two lock order reversals and fixed.
- Tighten up address checking, if the user gives an address the sa_len
had better be set properly.
- Get asoc by assoc-id would return a locked tcb when it was asked
not to if the tcb was in the restart hash.
- sysctl to dig down and get more association details
Reviewed by: gnn
in tcp_input():
o tighten the checks on allowed TCP flags to be RFC793 and
tcp-secure conform
o log check failures to syslog at LOG_DEBUG level
o rearrange the code flow to be easier to follow
o add KASSERTs to validate assumptions of the code flow
Add sysctl net.inet.tcp.syncache.rst_on_sock_fail defaulting to enable
that controls the behavior on socket creation failure for a otherwise
successful 3-way handshake. The socket creation can fail due to global
memory shortage, listen queue limits and file descriptor limits. The
sysctl allows to chose between two options to deal with this. One is
to send a reset to the other endpoint to notify it about the failure
(default). The other one is to ignore and treat the failure as a
transient error and have the other endpoint retransmit for another try.
Reviewed by: rwatson (in general)
based on individual fields beeing set. This doesn't work for setattr replay,
because va_type is set there, so we add AT_TYPE flag to va_mask, which won't
be accepted by zfs_setattr().
Reported by: kris
- Double the number of descriptors that a single call to send can use
- Quadruple the number of descriptors that can be reclaimed per pass
- only run reclaim twice per second
- increase coalesce timer from 3.5us to 5us
fix printf warning on 64-bit platforms