one specific problem: the driver didn't check for ACK/NAK after writing a
slave address byte to the bus, and some slaves signal that they are busy
(such as when completing an internal write to flash memory) by sending a
NAK in response to being addressed.
While working on that problem I discovered that the driver's handling of
error conditions in general didn't match the state transition diagram in
the reference manual, and making that right resulted in a lot of code
reorganization.
Along the way various other changes also happened...
- Remove a mutex that wasn't protecting anything.
- Remove some mystery DELAY()s, document the few that remain.
- Use pause_sbt(9) to yield the processor for the bulk of the time it
takes to transfer each byte rather than busy-polling the whole time.
- Disable the controller when no transfers are in progress; since we
don't operate in slave mode, there's no reason to run the hardware.
- Remove a bunch of unecessary code from probe().
perform a stop operation on the bus if there was an error, otherwise the
bus will remain hung forever. Consistantly use 'if (error != 0)' style in
the function.
Due to an off by one the code would read an entry past the table, as
opposed to the last entry which contains the nosys handler.
Reported by: Pawel Biernacki <pawel.biernacki gmail.com>
- Move the required kernel compiler flags from Makefile.arm64 to kern.mk.
- Build arm64 modules as PIC; non-PIC relocations in .o for shared object
output cannot be handled.
- Do not try to install aarch64 symlink.
- A hack for arm64 to avoid ld -r stage. See the comment for the explanation.
Some functionality is lost, like ctf handling, but hopefully will be
restored after newer linker is available.
Reviewed by: andrew, emaste
Tested by: andrew (on real hardware)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3796
It is decided to go with the shared object file format for modules on
arm64, due to the Aarch64 instruction set details. Combination of the
signed 28-bit offset in the branch instructions encoding together with
the supported memory model of compilers makes the relocatable object
support impossible or at least too hard.
Reviewed by: andrew, emaste
Tested by: andrew (on real hardware)
Sponsored by: The FreeBSD Foundation
Differential Revision: https://reviews.freebsd.org/D3796
The current Xen console driver is crashing very quickly when using it on
an ARM guest. This is because the console lock is recursive and it may
lead to recursion on the tty lock and/or corrupt the ring pointer.
Furthermore, the console lock is not always taken where it should be and has
to be released too early because of the way the console has been designed.
Over the years, code has been modified to support various new features but
the driver has not been reworked.
This new driver has been rewritten with the idea of only having a small set
of specific function to write either via the shared ring or the hypercall
interface.
Note that HVM support has been left aside for now because it requires
additional features which are not yet supported. A follow-up patch will be
sent with HVM guest support.
List of items that may be good to have but not mandatory:
- Avoid to flush for each character written when using the tty
- Support multiple consoles
Submitted by: Julien Grall <julien.grall@citrix.com>
Reviewed by: royger
Differential Revision: https://reviews.freebsd.org/D3698
Sponsored by: Citrix Systems R&D
bytes of boot2. Since we're in 16-bit mode, we can't copy all 128kB at
once; instead we loop four times and copy 32 kB each time.
This change was made necessary by an upcoming increase in the size of the
boot2 binary; should it increase further, the COPY_BLKS value can be
adjusted without anyone needing to remember 8086 assembly language again.
Requested by: allanjude
Tested by: allanjude
MFC after: 1 week
struct thread and kernel stack for the thread. Otherwise, a load
similar to a fork bomb would exhaust KVA and possibly kmem, mostly due
to the struct proc being type-stable.
The nprocs counter is changed from being protected by allproc_lock sx
to be an atomic variable. Note that ddb/db_ps.c:db_ps() use of nprocs
was unsafe before, and is still unsafe, but it seems that the only
possible undesired consequence is the harmless warning printed when
allproc linked list length does not match nprocs.
Diagnosed by: Svatopluk Kraus <onwahe@gmail.com>
Tested by: pho
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
The new mapping will restore binary compatibility with stable_10
but file generated since r283120 are broken.
Reviewed by: jhb
Sponsored by: Stormshield
CloudABI has approximately 50 system calls that do not depend on the
pointer size of the system. As the ABI is pretty compact, it takes
little effort to each truss(8) the formatting rules for these system
calls. Start off by formatting pointer size independent system calls.
Changes:
- Make it possible to include the CloudABI system call definitions in
FreeBSD userspace builds. Add ${root}/sys to the truss(8) Makefile so
we can pull in <compat/cloudabi/cloudabi_syscalldefs.h>.
- Refactoring: patch up amd64-cloudabi64.c to use the CLOUDABI_*
constants instead of rolling our own table.
- Add table entries for all of the system calls.
- Add new generic formatting types (UInt, IntArray) that we'll be using
to format unsigned integers and arrays of integers.
- Add CloudABI specific formatting types.
Approved by: jhb
Differential Revision: https://reviews.freebsd.org/D3836
Use direct dispatch into the destination hardware ring instead of using
a staging queue.
Submitted by: <s3erios@gmail.com>
Differential Revision: https://reviews.freebsd.org/D3757
r161611 added some of the code from sys_vfork() directly into the Linux
module wrappers since they use RFSTOPPED. In r232240, the RFFPWAIT handling
was moved to syscallret(), thus this code in the Linux module is no longer
needed as it will be called later.
This also allows the Linux wrappers to benefit from the fix in r275616 for
threads not getting suspended if their vforked child is stopped while they
wait on them.
Reviewed by: jhb, kib
MFC after: 2 weeks
Differential Revision: https://reviews.freebsd.org/D3828
specific as we may use the pmu registers for other uses. No configs seem
to currently build this.
This will allow for more use of this device.
Discussed with: bz
Sponsored by: ABT Systems Ltd
unconditionally, we end up with an mbuf chain of two mbufs, which
later in in_arpreply() is rewritten from ARP request to ARP reply
and is sent out. Looks like igb(4) (at least mine, and at least
at my network) fails on such mbuf chain, so ARP reply doesn't go
out wire. Thus, make the m_pullup() call conditional, as it is
everywhere. Of course, the bug in igb(?) should be investigated,
but better first fix the head. And unconditional m_pullup() was
suboptimal, anyway.
mbuf. Unlike in the pre-r248371 code, assert that M_PKTHDR is set
only on a first mbuf.
Reported & tested by: Andriy Voskoboinyk <s3erios gmail.com>
Sponsored by: Nginx, Inc.
pre-VFPv3 processors, since they do require software support code to
handle denormals. For VFPv3 and later, enable flush-to-zero if
hardware does not claim full denormals arithmetic support by VMVFR1_FZ
field in mvfr1 register.
The end result is that we do use correct fpu environment on Cortexes
with VFPv3, while ARM11 (e.g. rpi) is in non-compliant flush-to-zero
mode. At least CPUs without complete hardware implementation of
IEEE 754 do not cause unhandled floating point exception on underflow,
as it was before r288492.
Noted by: ian
Tested by: gjb
Sponsored by: The FreeBSD Foundation
MFC after: 1 week
- Always set td_dbg_sc_* when P_TRACED is set on system call entry
even if the debugger is not tracing system call entries. This
ensures the fields are valid when reporting other stops that
occur at system call boundaries such as for PT_FOLLOW_FORKS or
when only tracing system call exits.
- Set TDB_SCX when reporting the stop for a new child process in
fork_return(). This causes the event to be reported as a system
call exit.
- Report a system call exit event in fork_return() for new threads in
a traced process.
- Copy td_dbg_sc_* to new threads instead of zeroing. This ensures
that td_dbg_sc_code in particular will report the system call that
created the new thread or process when it reports a system call
exit event in fork_return().
- Add new ptrace tests to verify that new child processes and threads
report system call exit events with a valid pl_syscall_code via
PT_LWPINFO.
Reviewed by: kib
Differential Revision: https://reviews.freebsd.org/D3822
This fix is spiritually similar to r287442 and was discovered thanks to
the KASSERT added in that revision.
NT_PROCSTAT_VMMAP output length, when packing kinfo structs, is tied to
the length of filenames corresponding to vnodes in the process' vm map
via vn_fullpath. As vnodes may move during coredump, this is racy.
We do not remove the race, only prevent it from causing coredump
corruption.
- Add a sysctl, kern.coredump_pack_vmmapinfo, to allow users to disable
kinfo packing for PROCSTAT_VMMAP notes. This avoids VMMAP corruption
and truncation, even if names change, at the cost of up to PATH_MAX
bytes per mapped object. The new sysctl is documented in core.5.
- Fix note_procstat_vmmap to self-limit in the second pass. This
addresses corruption, at the cost of sometimes producing a truncated
result.
- Fix PROCSTAT_VMMAP consumers libutil (and libprocstat, via copy-paste)
to grok the new zero padding.
Reported by: pho (https://people.freebsd.org/~pho/stress/log/datamove4-2.txt)
Relnotes: yes
Sponsored by: EMC / Isilon Storage Division
Differential Revision: https://reviews.freebsd.org/D3824
Pull the latest headers for Xen which allow us to add support for ARM and
use new features in FreeBSD.
This is a verbatim copy of the xen/include/public so every headers which
don't exits anymore in the Xen repositories have been dropped.
Note the interface version hasn't been bumped, it will be done in a
follow-up. Although, it requires fix in the code to get it compiled:
- sys/xen/xen_intr.h: evtchn_port_t is already defined in the headers so
drop it.
- {amd64,i386}/include/intr_machdep.h: NR_EVENT_CHANNELS now depends on
xen/interface/event_channel.h, so include it.
- {amd64,i386}/{amd64,i386}/support.S: It's not neccessary to include
machine/intr_machdep.h. This is also fixing build compilation with the
new headers.
- dev/xen/blkfront/blkfront.c: The typedef for blkif_request_segmenthas
been dropped. So directly use struct blkif_request_segment
Finally, modify xen/interface/xen-compat.h to throw a preprocessing error if
__XEN_INTERFACE_VERSION__ is not set. This is allow us to catch any file
where xen/xen-os.h is not correctly included.
Submitted by: Julien Grall <julien.grall@citrix.com>
Reviewed by: royger
Differential Revision: https://reviews.freebsd.org/D3805
Sponsored by: Citrix Systems R&D
the kernel or kmem object can't be paged out. Since they can't be paged
out, they are never enqueued in a paging queue. Nonetheless, passing
PQ_INACTIVE to vm_page_unwire() in kmem_unback() creates the appearance
that these pages are being enqueued in the inactive queue. As of r288122,
we can avoid giving this false impression by passing PQ_NONE.
Submitted by: kmacy
Differential Revision: https://reviews.freebsd.org/D1674
