same prefix. Since a single route entry is installed for the prefix
(without RADIX_MPATH), incoming packets on the interfaces that are not
associated with the prefix route may trigger an error message about
unable to allocation LLE entry, and fails L2. This patch makes sure a
valid route is present in the system, and allow the aforementioned
condition to exist and treats as valid.
Reviewed by: bz
MFC after: 5 days
build the ip_fw_pfil.c hooks and ipfw even in case of no-ip under the
assumption that the private L2 hook (which hopefully eventually will be a
pfil hook as well) can still be useful.
Allow building the module without inet as well.
Glanced at by: jhb
MFC after: 3 days
options defined in the kernel config. This more closely matches the
behavior of other modules which inherit configuration settings from the
kernel configuration during a kernel + modules build.
Reviewed by: luigi
Approved by: re (kib)
MFC after: 1 week
route with the same prefix is searched for as a replacement. The
current code did not bypass routes that have non-operational
interfaces. This patch fixes that bug and will find a replacement
route with an active interface.
PR: kern/159603
Submitted by: pluknet, ambrisko at ambrisko dot com
Reviewed by: discussed on net@
Approved by: re (bz)
MFC after: 3 days
and the maximum TCP send and receive buffer limits from 256kB
to 2MB.
For sb_max_adj we need to add the cast as already used in the sysctl
handler to not overflow the type doing the maths.
Note that this is just the defaults. They will allow more memory
to be consumed per socket/connection if needed but not change the
default "idle" memory consumption. All values are still tunable
by sysctls.
Suggested by: gnn
Discussed on: arch (Mar and Aug 2011)
MFC after: 3 weeks
Approved by: re (kib)
Distinguish IPv4 and IPv6 addresses and optional port numbers in
user space to set the option for the correct protocol family.
Add support in the kernel for carrying the new IPv6 destination
address and port.
Add support to TCP and UDP for IPv6 and fix UDP IPv4 to not change
the address in the IP header.
Add support for IPv6 forwarding to a non-local destination.
Add a regession test uitilizing VIMAGE to check all 20 possible
combinations I could think of.
Obtained from: David Dolson at Sandvine Incorporated
(original version for ipfw fwd IPv6 support)
Sponsored by: Sandvine Incorporated
PR: bin/117214
MFC after: 4 weeks
Approved by: re (kib)
more fragments flag off so that offset == 0 checks work properly.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
X-MFC with: r225032
Approved by: re (kib)
then terminate the loop as we will not find any further headers and
for short fragments this could otherwise lead to a pullup error
discarding the fragment.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
packet is a/the first fragment or not. For IPv6 we have added the
"more fragments" flag as well to be able to determine on whether
there will be more as we do not have the fragment header avaialble
for logging, while for IPv4 this information can be derived directly
from the IPv4 header. This allowed fragmented packets to bypass
normal rules as proper masking was not done when checking offset.
Split variables to not need masking for IPv6 to avoid further errors.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
translation technology involved (and that section is suggested to
be removed by Errata 2843), single packet fragments do not harm.
There is another errata under discussion to clarify and allow this.
Meanwhile add a sysctl to allow disabling this behaviour again.
We will treat single packet fragment (a fragment header added
when not needed) as if there was no fragment header.
PR: kern/145733
Submitted by: Matthew Luckie (mjl luckie.org.nz) (original version)
Tested by: Matthew Luckie (mjl luckie.org.nz)
MFC after: 2 weeks
Approved by: re (kib)
While there:
* Fix a locking issue in setsockopt() of SCTP_CMT_ON_OFF.
* Fix a bug in setsockopt() of SCTP_DEFAULT_PRINFO, where the pr_value
was ignored.
Approved by: re@
MFC after: 2 months.
* Decouple the path supervision using a separate HB timer per path.
* Add support for potentially failed state.
* Bring back RTO.min to 1 second.
* Accept packets on IP-addresses already announced via an ASCONF
* While there: do some cleanups.
Approved by: re@
MFC after: 2 months.
- TCP keep* timers
- TCP UTO (adjust from what was there already)
- netmap
- route caching
- user cookie (temporary to allow for the real fix)
Slightly re-shuffle struct ifnet moving fields out of the middle
of spares and to better align.
Discussed with: rwatson (slightly earlier version)
same as the host address. This already works fine for INET6 and ND6.
While here, remove two function pointers from struct lltable which are
only initialized but never used.
MFC after: 3 days
I think the benefit of making the code cleaner and easier to understand
outweighs the humour of leaving this intact (or possibly changing it to
#ifdef not_yet_and_probably_never).
MFC after: 2 weeks
when len is inserted back into the synthetic IP packet and cause a
multiple of 2^16 bytes of TCP "packet loss".
This improves Linux->FreeBSD netperf bandwidth by a factor of 300 in
testing on Amazon EC2.
Reviewed by: jfv
MFC after: 2 weeks
- While here, remove a paragraph about userspace operation that
has been outdated for some time. [2]
PR: 158623
Submitted by: Ben Kudak (kaduk % mit!edu) [1]
Reviewed by: glebius [2]
MFC after: 1 week
This makes pf find the wrong state and cause errors reported with state mismatches.
Clear the cached state link on the pf(4) tag to avoid the state mismatches.
Approved by: bz
reset rcvif to NULL. Since rcvif is not NULL, ipfw(4) supposes that ARP
replies were received on specified interface.
Reset rcvif to NULL for ARP replies to fix this issue.
PR: kern/131817
Reviewed by: glebius
MFC after: 1 month
possible to organize subroutines with rules.
The "call" action saves the current rule number in the internal
stack and rules processing continues from the first rule with
specified number (similar to skipto action). If later a rule with
"return" action is encountered, the processing returns to the first
rule with number of "call" rule saved in the stack plus one or higher.
Submitted by: Vadim Goncharov
Discussed by: ipfw@, luigi@
alias address needs to be specified.
Add inbound handler to the alias_ftp module. It helps handle active
FTP transfer mode for the case with external clients and FTP server behind
NAT. Fix passive FTP transfer case for server behind NAT using redirect with
external IP address different from NAT ip address.
PR: kern/157957
Submitted by: Alexander V. Chernikov
IPsec being compiled in and used. Improve reporting by adding the length
fields to the panic message, so that we would have some immediate debugging
hints.
Discussed with: jhb
